Recalls that may apply to the 1995 Ford Probe
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| None found. |
| 1999134 | 1999-07-26. Emissions. Certain vehicles may not comply with the requirements of CMVSS 1105 - Evaporative Emissions. Fuel vapour may leak from between the fuel cap and the fuel filler pipe. Correction: Filler cap will be replaced with one that incorporates an o-ring that will positively seal the suspect fuel filler pipes. |
|---|---|
| 1995099 | 1995-06-13. Electrical. THE FUEL PUMP WIRING ASSEMBLY MAY CORRODE DUE TO ROAD SALT, POSSIBLY RESULTING IN AN ELECTRICAL BRIDGE DEVELOPING BETWEEN THE FUEL PUMP ELECTRICAL CIRCUIT AND THE FUEL GAUGE SENDER TERMINALS. THIS COULD CAUSE THE FUEL SENDER GROUND CIRCUIT TO OVERHEAT THE WIRING AND MELT ITS INSULATION CAUSING SMOKE AND POSSIBLE DAMAGE TO OTHER WIRING. CORRECTION: A FUSED JUMPER HARNESS WILL BE INSTALLED IN THE FUEL PUMP/SENDER ELECTRICAL CIRCUIT. |
| 1995032 | 1995-02-21. Seats And Restraints. THE PASSENGER SIDE SUPPLEMENTAL RESTRAINT SYSTEM (AIR BAG) MAY HAVE A CRACKED INFLATOR BODY. IF THE VEHICLE IS INVOLVED IN A DEPLOYMENT LEVEL CRASH, THE PASSENGER SIDE AIR BAG MAY NOT INFLATE PROPERLY WHICH COULD RESULT IN REDUCED OCCUPANT PROTECTION. IN ADDITION, THE IGNITER PLUG COULD SEPARATE FROM THE INFLATOR, WHICH COULD RESULT IN THE RELEASE OF HOT GASES AND COULD IGNITE FLAMMABLE MATERIAL OR POTENTIALLY CAUSE PERSONAL INJURY. CORRECTION: VEHICLES WILL BE INSPECTED AND A NEW PASSENGER SIDE AIR BAG MODULE WILL BE INSTALLED IF NECESSARY. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.