Recalls that may apply to the 2000 Ford Mustang
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about SUSPENSION are shown.
| 01V121000 | 2001-04-11. SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT. VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE BALL JOINT ASSEMBLY IN THE REAR KNUCKLE, WHERE THE LOWER CONTROL ARM ATTACHES, IS DISPLACED LONGITUDINALLY FROM ITS INSTALLED POSITION, IT CAN CAUSE HIGHER STRESS LEVELS IN THE KNUCKLE CASTING. IF THIS OCCURS, THE CASTING COULD FRACTURE, ALLOWING THE CORNER OF THE VEHICLE TO DROP, AND THE LOWER CONTROL ARM COULD CONTACT THE INSIDE OF THE REAR WHEEL. Built 1998-11-02 to 2000-08-28. |
|---|
| 2001079 | 2001-04-05. Suspension. On certain Mustang SVT vehicles, when operated in severe driving cycles such as frequent drag race type standing start acceleration, the ball joint in the rear suspension knuckle where the lower control arm attaches may be displaced longitudinally out of its installed position. If this occurs, the stress levels in the knuckle casting will increase and the casting may fracture. The corner of the vehicle will then drop and the lower control arm may contact the inside of the wheel, possibly affecting directional control. Correction: Dealers will install a revised rear suspension knuckle assembly with positive retention of the ball joint. |
|---|
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.