Recalls that may apply to the 1999 Ford Mustang
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 01V121000 | 2001-04-11. SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT. VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE BALL JOINT ASSEMBLY IN THE REAR KNUCKLE, WHERE THE LOWER CONTROL ARM ATTACHES, IS DISPLACED LONGITUDINALLY FROM ITS INSTALLED POSITION, IT CAN CAUSE HIGHER STRESS LEVELS IN THE KNUCKLE CASTING. IF THIS OCCURS, THE CASTING COULD FRACTURE, ALLOWING THE CORNER OF THE VEHICLE TO DROP, AND THE LOWER CONTROL ARM COULD CONTACT THE INSIDE OF THE REAR WHEEL. Built 1998-11-02 to 2000-08-28. |
|---|---|
| 00V349000 | 2000-10-30. PARKING BRAKE:CONVENTIONAL. VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH MANUAL TRANSMISSIONS. IF A VEHICLE IS PARKED WITH THE PARKING BRAKE NOT FULLY APPLIED AND NOT IN FIRST GEAR, AS DIRECTED IN THE OWNER GUIDE, AND THE SELF ADJUSTMENT PAWL SUBSEQUENTLY SKIPS ONE OR TWO TEETH, THE VEHICLE COULD MOVE ON SOME GRADES. Built 1993-10-04 to 2000-10-10. |
| 99V250000 | 1999-09-20. SEAT BELTS:FRONT:ANCHORAGE. VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE SEAT BELT RETRACTOR MAY HAVE A PIN SHAFT IN THE SWITCHABLE ELR/ALR MECHANISM THAT IS INCORRECTLY FORMED. IN SOME CIRCUMSTANCES, THE SWITCHING MECHANISM COULD BECOME NONFUNCTIONAL, PREVENTING THE SEAT BELT WEBBING FROM BEING EXTRACTED FROM THE RETRACTOR. IT IS ALSO POSSIBLE THAT MALFUNCTION OF THE MECHANISM COULD PREVENT THE BELT FROM BEING SWITCHED INTO THE ALR MODE. THE ELR MECHANISM IS NOT AFFECTED BY THIS CONDITION. Built 1999-07-26 to 1999-08-13. |
| 99V062001 | 1999-03-30. VEHICLE SPEED CONTROL. VEHICLE DESCRIPTION: CERTAIN 1997-1999 RHD EXPLORER EQUIPPED WITH 4.0L OHV/SOHC ENGINES AND CRUISE CONTROL BUILT FROM MAY 29, 1996 THROUGH MARCH 4, 1999; 1998-1999 EXPLORER/MOUNTAINEERS EQUIPPED WITH 4.0L OHV/SOHC OR 5.0L ENGINES OR 1998-1999 RANGERS EQUIPPED WITH 2.5L, 3.0L FFV/EFI OR 4.0L ENGINES AND CRUISE CONTROL BUILT FROM JANUARY 5, 1998 THROUGH MARCH 4, 1999; 1998-1999 MUSTANGS EQUIPPED WITH 3.8L, 4.6L 2-VALVE OR 4-VALVE ENGINES AND CRUISE CONTROL BUILT FROM MARCH 2, 1998 THROUGH MARCH 4, 1999; 1999 F250/F350/F450/F550 (OVER 8,500 LBS.) TRUCKS EQUIPPED WITH 5.4L OR 6.8L ENGINES AND CRUISE CONTROL BUILT FROM MARCH 2, 1998 THROUGH MARCH 4, 1999; AND 1999 F-53 STRIPPED CHASSIS EQUIPPED WITH 5.4L OR 6.8L ENGINES AND CRUISE CONTROL BUILT FROM MARCH 2, 1998 THROUGH MARCH 4, 1999. A CRUISE CONTROL CABLE CAN INTERFERE WITH THE SPEED CONTROL SERVO PULLEY AND NOT ALLOW THE THROTTLE TO RETURN TO IDLE WHEN DISENGAGING THE CRUISE CONTROL. Built 1998-03-02 to 1999-03-04. |
| 2001079 | 2001-04-05. Suspension. On certain Mustang SVT vehicles, when operated in severe driving cycles such as frequent drag race type standing start acceleration, the ball joint in the rear suspension knuckle where the lower control arm attaches may be displaced longitudinally out of its installed position. If this occurs, the stress levels in the knuckle casting will increase and the casting may fracture. The corner of the vehicle will then drop and the lower control arm may contact the inside of the wheel, possibly affecting directional control. Correction: Dealers will install a revised rear suspension knuckle assembly with positive retention of the ball joint. |
|---|---|
| 2000282 | 2000-11-28. Brakes. On certain vehicles equipped with manual transmissions, if parked with the parking brake not fully applied and not in first gear, as directed in the Owner Guide, and the self adjustment pawl subsequently skips one or two teeth, the vehicle could move on some grades. This could result in unintended vehicle movement and a vehicle crash without prior warning. Correction: Dealers will modify the parking brake control and install a plate or over-bracket to the control to lock the self adjust mechanism in position following adjustment. |
| 1999176 | 1999-10-19. Seats And Restraints. On certain vehicles, the seat belt retractor in certain seating positions may have a pin shaft in the switchable ELR/ALR(emergency locking retractor/automatic locking retractor) mechanism that is incorrectly formed. In some circumstances, the switching mechanism could become non-functional, which could prevent the seat belt webbing from being extracted from the retractor. Correction: Affected vehicles will be inspected and suspect lap and shoulder belt assemblies will be replaced. |
| 1999153 | 1999-08-19. Emissions. On certain Mustang GT vehicles equipped with 4.6 litre, 2-valve engines, the transmission control wire harness may chafe against the EGR tube and sleeve possibly damaging the harness convolute and wires. This damage could cause powertrain and emission control concerns such as illumination of the Malfunction Indicator Lamp (MIL), engine not starting and the transmission failing to upshift. Correction: Transmission harness will be inspected for damage and repaired or replaced and rerouted as necessary. |
| 1999061 | 1999-04-15. Engine. On certain vehicles, the speed control cable may interfere with the speed control servo pulley and not allow the throttle to return to idle when disengaging the speed control. If the speed control is used and this condition is present, a stuck throttle could result, which could potentially cause an accident. By not using speed control, this condition will not occur. Correction: Vehicles will be inspected and, if required, speed control cable will be replaced. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.