Service bulletins for the 2016 Ford Fusion
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
173 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Labels and manuals are shown. Show all
| TSB 21-2347 | 2021-11-02. Service bulletin. ENGINE; EQUIPMENT; POWER TRAIN; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; EQUIPMENT ADAPTIVE/MOBILITY. Some 2015-2020 Fusion/MKZ vehicles equipped with a 2.0L EcoBoost engine may exhibit a rattle noise from the transmission bellhousing area. This may be more noticeable at idle. This may be due to a flexplate crack around the mounting area. To correct the condition, follow the Service Procedure steps to replace the flexplate, transmission fluid pump, and torque converter. |
|---|---|
| SSM 48598 | 2020-03-03. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. 2013-2018 C-Max, 2013-2020 Fusion Hybrid/MKZ Hybrid vehicles may exhibit a MIL with Diagnostic Trouble Code (DTC) P0340 and/or P0344. This may occur due to excessive moisture build up in the engine oil. Excess moisture occurs when the vehicle is driven short distances and/or less than 6,000 combined miles per year. To correct the condition, replace the camshaft position sensor (CMP) and change the engine oil. Advise the customer to perform more frequent oil changes and allow the internal combustion engine to reach operating temperature when running to prevent reoccurrence. Refer to the owners guide - maintenance - engine oil check - operating in cold climates and short driving cycles. |
| SSM 46454 | 2017-05-22. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SOME 2013-2017 C-MAX/FUSION ENERGI AND 2017 C-MAX/FUSION/MKZ HYBRID VEHICLES MAY EXHIBIT AN ILLUMINATED MIL WITH DIAGNOSTIC TROUBLE CODE (DTC) P04B5. THIS MAY BE DUE TO INADVERTENT ACTUATION OF THE FUEL DOOR RELEASE BUTTON BY THE CUSTOMER WHEN EXITING THE VEHICLE. IF THE FUEL FILLER DOOR IS NOT FULLY CLOSED AFTER A REFUELING EVENT, OR THE FUEL FILLER DOOR IS OPEN FROM ERRONEOUSLY PRESSING THE FUEL DOOR RELEASE BUTTON, A MESSAGE DISPLAYS DURING THE THIRD DRIVE CYCLE TO INDICATE THE FUEL FILLER DOOR IS NOT CLOSED AND THE DTC SETS. BEFORE PERFORMING WORKSHOP MANUAL DIAGNOSTICS, CONSULT THE CUSTOMER ABOUT THE POTENTIAL FOR ACCIDENTAL FUEL DOOR ACTUATION AND EXPLAIN THE NEED TO FULLY LATCH THE FUEL DOOR AFTER EVERY REFUELING EVENT. |
| SSM 46438 | 2017-05-17. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SOME 2016-2017 F150, EDGE, MKX, ESCAPE, FOCUS, MKC, FUSION, MKZ, TAURUS AND 2017 CONTINENTAL VEHICLES EQUIPPED WITH 2.0L, 2.7L OR 3.0L GASOLINE TURBOCHARGED DIRECT INJECTION(GTDI) ECOBOOST ENGINES MAY EXHIBIT MALFUNCTION INDICATOR LIGHT(MIL) ON WITH DIAGNOSTIC TROUBLE CODES(DTC) P1013, P1015 AND/OR P1016 STORED IN POWERTRAIN CONTROL MODULE(PCM). CHECK TURBOCHARGER WASTEGATE CONTROL HOSES FOR WATER/ICE RESTRICTIONS OR PINCHING AT ZIP-TIE ON ENGINE CAM COVER RETAINER(2.7L AND 3.0L ONLY). IF RESTRICTION IS FOUND ON CAM COVER RETAINER, CUT ZIP TIE AND CLEAR DTCS. IF WATER/ICE RESTRICTION IS FOUND, DRAIN HOSES, REASSEMBLE AND CLEAR DTCS. IF DTCS RETURN, REFER TO WORKSHOP MANUAL (WSM) OR POWERTRAIN CONTROL EMISSIONS DIAGNOSIS (PCED) MANUAL FOR NORMAL DIAGNOSTICS. ENGINEERING IS INVESTIGATING THE CONCERN, MONITOR OASIS FOR FURTHER UPDATES. |
| TSB 17-0028 | 2017-05-15. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SOME 2014-2017 FUSION AND 2017 ESCAPE VEHICLES EQUIPPED WITH A 1.5L GASOLINE TURBOCHARGED DIRECT INJECTION (GTDI) ENGINE AND AN ODOMETER READING 16,000 KM (10,000 MILES) OR ABOVE MAY EXHIBIT LOW COOLANT, WHITE EXHAUST SMOKE AND MAY ALSO EXHIBIT AN ILLUMINATED MIL WITH DIAGNOSTIC TROUBLE CODES (DTCS) P0217, P0300, P0301, P0302, P0303, P0304, P0316 AND/OR P1299. THIS CONDITION MAY BE DUE TO AN INTAKE MANIFOLD BOLT BACKING OUT CAUSING DAMAGE TO THE CHARGE AIR COOLER (CAC). FOLLOW THE SERVICE PROCEDURE STEPS TO CORRECT THE CONDITION |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.