Recalls that may apply to the 2000 Ford Focus
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Suspension are shown.
| None found. |
| 2002214 | 2002-11-15. Suspension. On certain vehicles, insufficient clamp load at the attachment of the lower control arm ball joint to the steering knuckle may result in separation of the joint or fracture of the ball joint stud. If this should occur while the vehicle is in motion, loss of vehicle control may result. Correction: Dealers will verify the torque of the steering knuckle pinch bolt and tighten as necessary. |
|---|---|
| 2000245 | 2000-10-25. Suspension. Certain vehicles may have rear wheel hubs that could loosen and allow the left rear wheel and brake drum assembly to separate from the vehicle. Separation of a rear wheel and brake drum could result in reduced vehicle control and a possible crash. Correction: Vehicles will be inspected and, if necessary, rear wheel hub and bearing assembly will be replaced. In addition, a redundant left rear wheel retention device will be added to the left rear spindle. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.