Recalls that may apply to the 1982 Ford F-350
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 82V104000 | 1982-10-26. POWER TRAIN:AXLE ASSEMBLY. ON CERTAIN VEHICLES, THE LOCK WEDGES USED TO SECURE THE AXLE BEARING NUTS TO THE AXLE HOUSING MAY FALL OUT OF POSITION, ALLOWING THE NUT TO LOOSEN. THE NUT ON THE LEFT SIDE MAY FALL OFF, ALLOWING MOVEMENT OF THE AXLE SHAFT. Built 1981-10-01 to 1982-09-01. |
|---|---|
| 82V098000 | 1982-10-12. VISIBILITY:REARVIEW MIRRORS/DEVICES:EXTERIOR. ON THE INVOVLED VEHICLES THE DRIVER"S SIDE AND PASSENGER"S OUTSIDE REAR VIEW MIRRORS MAY HAVE BEEN OMITTED. THIS FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 111, "REARVIEW MIRRORS". Built 1981-08-01 to 1982-06-01. |
| 1982088 | 1982-11-12. REVISED-DESIGN LOCK WEDGES ON REAR AXLE ASSEMBLIES MAY DISENGAGE FROM THE AXLE RETAINING NUT. IF THIS WERE TO OCCUR ON THE LEFT AXLE AND THE WEDGE BECAME JAMMED BETWEEN THE RETAINING NUT AND THE HUB, THE REATINING NUT COULD LOOSEN AND BACK OFF COMPLETELY, CREATING THE POSSIBILITY OF THE LEFT REAR AXLE, WHEEL AND BRAKE DRUM PARTIALLY OR COMPLETELY SEPARATING FROM THE REAR AXLE ASSEMBLY. PARTIAL SEPARATION WOULD RESULT IN LOSS OF REAR BRAKING CAPABILITY AND COMPLETE SEPARATION WOULD ADVERSELY AFFECT VEHICLE CONTROL. |
|---|---|
| 1982087 | 1982-10-19. THIS VEHICLE DOES NOT COMPLY WITH CMVSS 111 - REARVIEW MIRROR. NOTE: STYLSIDE MODELS ONLY. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.