Service bulletins for the 2017 Ford Expedition
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
115 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Throttle and cruise control are shown. Show all
| TSB 20-2189 | 2020-07-06. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; VEHICLE SPEED CONTROL:ACCELERATOR PEDAL; EQUIPMENT. This article supersedes TSB 20-2028 to update the description of Labor Operation D. Some 2013-2018 F-150/Expedition/Navigator vehicles equipped with 4-wheel drive (4WD) may exhibit an intermittent grinding noise while driving in 2-wheel drive (2WD) mode most commonly on acceleration. This may be due to a loss of vacuum to the integrated wheel end (IWE) actuators and/or wear of the IWE components. To correct the condition, follow the Service Procedure steps to reprogram the transfer case control module (TCCM) and replace any worn vacuum and/or IWE components. |
|---|---|
| SSM 48361 | 2019-12-05. Service bulletin. VEHICLE SPEED CONTROL; ELECTRICAL SYSTEM. Some 2017 Expedition vehicles may exhibit a greater than 120 Km/h (75 MPH) overspeed warning in the IPC even though the vehicle has not hit that speed. This my be due to a software error in the cluster. To correct this condition, perform a software update to the IPC using the appropriate Ford diagnostic scan tool. For claiming, use causal part 10849 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.