Recalls that may apply to the 2004 Ford Excursion
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Fuel System are shown.
| None found. |
| 2005183 | 2005-06-20. Fuel System. On certain vehicles equipped with a 6.0L diesel engine, the Fuel Injection Control Module (FICM) wire harness may chafe against an engine bolt. Also, the Injection Control Pressure (ICP) sensor connector terminals may have an improper crimp height that may result in intermittent or permanent loss of the ICP sensor signal. FICM wire harness chafes or improper ICP sensor connector crimps may cause the vehicle to stall without warning while driving. If the vehicle stalls, it may or may not restart. Correction: For all F-Superduty and Excursion vehicles, dealers will inspect the FICM wire harness for chafing. If bare wires have not been exposed, dealers will install a wire protection kit. If bare wires have been exposed, dealers will install a new wire harness. For all E-Series and, depending on build date, some F-Superduty and Excursion vehicles, dealers will install a new ICP sensor connector with certified crimps. |
|---|
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.