WenmarOpen by Wenmar Pro

Recalls that may apply to the 1995 Ford Crown Victoria

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
08V0510002008-02-04. VEHICLE SPEED CONTROL:CRUISE CONTROL. FORD IS RECALLING 225,000 MY 1992-2003 ECONOLINE, MY 1993-1995 TAURUS SHO, MY 1992-1998 CROWN VICTORIA, MY 1993 BRONCO, F-SERIES, MY 1995-1997 F-SERIES SUPER DUTY STRIPPED CHASSIS, MY 1992-1998 MERCURY GRAND MARQUIS, AND MY 1992-1995 LINCOLN TOWN CAR VEHICLES. THE AFFECTED VEHICLES WERE PREVIOUSLY REPAIRED USING A WIRING HARNESS THAT IS NOT COMPATIBLE WITH THE VEHICLE CIRCUIT POLARITY. Built 1992-02-05 to 1997-10-31.
07V3360002007-08-03. VEHICLE SPEED CONTROL. ON CERTAIN PICKUP TRUCKS, PASSENGER VEHICLES, SPORT UTILITY VEHICLES, AND MOTOR HOMES CHASSIS, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN. Built 1992-02-05 to 1998-02-28.
98V3220001998-12-16. SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT. VEHICLE DESCRIPTION: CERTAIN 1996-1999 FORD CROWN VICTORIA POLICE, FLEET, NATURAL GAS, AND 1996-1999 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT WERE PRODUCED WITH A LOWER CONTROL ARM BALL JOINT CONTAINING A ONE PIECE BEARING; AND 1990-1996 FORD CROWN VICTORIA POLICE, FLEET, AND NGV VEHICLES AND 1990-1996 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT HAVE BEEN SERVICED WITH EITHER A BALL JOINT CONTAINING THE ONE-PIECE BEARING OR A FRONT LOWER CONTROL ARM CONTAINING A BALL JOINT WITH A ONE-PIECE BEARING. THE ONE-PIECE BEARING WITHIN THE LOWER CONTROL ARM BALL JOINT CAN WEAKEN SLOWLY DURING USE AND EVENTUALLY CRACK. THIS COULD RESULT IN SEPARATION OF THE BALL AND CAP OF THE JOINT, ALLOWING THE CONTROL ARM TO DROP TO THE GROUND.
97V0240001997-03-04. LATCHES/LOCKS/LINKAGES:HOOD:LATCH. VEHICLE DESCRIPTION: POLICE AND TAXI VEHICLES. THE HOOD LATCH STRIKER CAN WEAR OR BECOME DETACHED FROM THE HOOD. Built 1991-03-01 to 1996-10-07.
96V1350001996-07-18. STEERING:LINKAGES. THE PITMAN ARMS WERE NOT FULLY LUBRICATED AT THE ASSEMBLY PLANT. THE "BALL JOINT" AT THE OUTER END OF THE PITMAN ARM CAN BECOME CONTAMINATED AND CORRODE. Built 1994-08-01 to 1996-04-01.
96V0450001996-03-05. SEAT BELTS:FRONT:ANCHORAGE. THE RIVETS HOLDING THE REAR OUTBOARD BELT D-RINGS WERE NOT HEAT TREATED PROPERLY CAUSING THE HEADS OF THE RIVETS TO FRACTURE UNDER LOAD AND FAIL TO HOLD THE D-RINGS TO THE STRAPS. THIS DOES NOT CONFORM TO THE REQUIREMENTS OF FMVSS NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." Built 1994-08-01 to 1994-10-01.
95V1890001995-10-02. ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS. THESE VEHICLES WERE BUILT WITH THE NON-CYCLING POWER WINDOW CIRCUIT BREAKER AND THE CYCLING HEADLAMP CIRCUIT BREAKER INTERCHANGED. Built 1994-08-01 to 1994-11-01.
95V0630001995-03-27. FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP. THE SEAL MATERIAL BETWEEN THE FUEL FILLER PIPE AND FUEL TANK MAY NOT HAVE BEEN FULLY CURED DURING THE MOLDING PROCESS WHICH COULD ALLOW FOR FUEL LEAKAGE. Built 1994-06-01 to 1994-12-01.
Canada: Transport Canada, as of 2026-10-19
20080382008-02-06. Electrical. On certain vehicles, a wiring harness that is not compatible with the vehicle circuit polarity may have been inadvertently installed during servicing for recall 2005028 or 2007258. As a result, the fuse is located in the output circuit rather than in the input power feed circuit, and will not offer the intended protection in the event of an electrical short to ground. This could result in a vehicle fire, causing property damage and/or personal injury. Correction: Dealers will install an updated wiring harness.
20072582007-08-07. Electrical. On certain vehicles, the speed control deactivation switch may overheat, smoke, or burn, potentially resulting in an underhood fire. The failure mode appears to be different than that of Recall 2005028 (05S28). This time, the concern is with long term durability performance issues causing the switch to fail. Correction: Initially as an interim repair, owners will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. As soon as replacement parts are available, owners will be instructed to return to the dealers for installation of a fused wiring harness designed to eliminate the potential risk of fire.
19982511998-12-22. Suspension. Note: 1996-99 crown victoria police, fleet and ngv and lincoln town car limousine equipped with a lower control arm ball joint containing a one piece bearing and 1990-96 crown victoria police, fleet and ngv and lincoln town car limousine that were serviced with either a ball joint containing an one piece bearing or a front lower control arm with a one piece bearing. High bearing loads can lead to thinning and eventual cracking of the lower control arm ball joint. This can result in separation of the ball and cap of the joint. Should this occur, the control arm to which the cap is mounted will drop to the ground. Should this occur while the vehicle is moving, reduced steering control could result in a collision. Correction: Lower control arm ball joints will be replaced.
19970691997-04-01. Structure. NOTE: POLICE AND TAXI VEHICLES ONLY. THE HOOD LATCH STRIKER MAY EITHER WEAR OR BECOME DETACHED FROM THE HOOD. EITHER OF THESE CONDITIONS MAY RESULT IN THE HOOD OPENING WITHOUT WARNING WHILE THE VEHICLE IS BEING OPERATED RESULTING IN REDUCED DRIVER VISIBILITY AND A POSSIBLE CRASH. CORRECTION: VEHICLES WITH 1992 MODEL HOODS WILL HAVE AN IMPROVED HOOD LATCH STRIKER INSTALLED AND REVISED STRIKER PLATE ATTACHING FASTENERS WILL BE INSTALLED ON VEHICLES WITH 1993-97 HOODS.
19961211996-08-02. Steering. NOTE: CROWN VICTORIA POLICE INTERCEPTORS AND UNITS FOR COMMERCIAL APPLICATIONS. TOWN CARS WITH LIMOUSINE BUILDER PACKAGE OR TRAILER TOW PACKAGE. THE PITMAN ARMS ON THESE VEHICLES WERE NOT FULLY LUBRICATED DURING VEHICLE ASSEMBLY. IF NOT PROPERLY LUBRICATED IN ACCORDANCE WITH THE MAINTENANCE SCHEDULE, THE PITMAN ARM BALL JOINT MAY BECOME CONTAMINATED AND CORRODE. THIS COULD RESULT IN ABNORMAL WEAR AND POSSIBLE PITMAN ARM BALL JOINT SEPARATION CAUSING SUBSEQUENT LOSS OF STEERING CONTROL AND A POSSIBLE CRASH. CORRECTION: PITMAN ARMS WILL BE INSPECTED AND THOSE WITH SIGNIFICANT WEAR WILL BE REPLACED. THOSE PITMAN ARMS NOT REPLACED WILL HAVE THE BALL JOINT FULLY GREASED.
19960611996-04-17. Seats And Restraints. THE REAR OUTBOARD SEAT BELT D-RINGS ARE RIVETED TO METAL STRAPS WHICH ARE BOLTED THE THE C-PILLAR STRUCTURE. SOME OF THESE RIVETS WERE NOT PROPERLY HEAT TREATED AND MAY FRACTURE UNDER LOAD AND FAIL TO HOLD THE D-RINGS TO THE STRAPS. IF THE RIVETS WERE TO SEPARATE DURING A CRASH, THERE WOULD BE ADDITIONAL SLACK IN THE BELT SYSTEM AND THE POTENTIAL FOR MORE OCCUPANT MOVEMENT WHILE BEING RESTRAINED BE THE BELTS. CORRECTION: BOTH REAR OUTBOARD RESTRAINTS WILL BE INSPECTED AND, IF REQUIRED, A REINFORCEMENT PLATE WILL BE INSTALLED ON THE AFFECTED SEAT BELT ASSEMBLY.
19951921995-10-25. Lights And Instruments. THE NON-CYCLING POWER WINDOW CIRCUIT BREAKER AND THE CYCLING LOW-BEAM CIRCUIT BREAKER MAY BE INTERCHANGED AT THE INSTRUMENT PANEL FUSE PANEL. IN THE EVENT OF A SHORT OR OVERLOAD IN THE HEADLAMP CIRCUIT, BOTH HEADLAMPS COULD GO OUT WITHOUT WARNING, RATHER THAN FLASHING AS INTENDED WITH THE CYCLING CIRCUIT BREAKER. THIS COULD LEAD TO REDUCED NIGHTTIME DRIVER VISIBILITY, WHICH COULD RESULT IN AN ACCIDENT. CORRECTION: CIRCUIT BREAKERS WILL BE REMOVED AND REINSTALLED IN THE CORRECT LOCATIONS.
19950661995-04-07. Fuel System. THE FUEL TANK MAY LEAK AT THE SEAL BETWEEN THE FUEL FILLER PIPE AND THE FUEL TANK. FUEL LEAKAGE, IN THE PRESENCE OF AN IGNITION SOURCE COULD POTENTIALLY RESULT IN A FIRE. CORRECTION: A FUEL FILLER PIPE TO FUEL TANK SEAL, WHICH IS MADE FROM DIFFERENT MATERIAL, WILL BE INSTALLED ON AFFECTED VEHICLES.
19950321995-02-21. Seats And Restraints. THE PASSENGER SIDE SUPPLEMENTAL RESTRAINT SYSTEM (AIR BAG) MAY HAVE A CRACKED INFLATOR BODY. IF THE VEHICLE IS INVOLVED IN A DEPLOYMENT LEVEL CRASH, THE PASSENGER SIDE AIR BAG MAY NOT INFLATE PROPERLY WHICH COULD RESULT IN REDUCED OCCUPANT PROTECTION. IN ADDITION, THE IGNITER PLUG COULD SEPARATE FROM THE INFLATOR, WHICH COULD RESULT IN THE RELEASE OF HOT GASES AND COULD IGNITE FLAMMABLE MATERIAL OR POTENTIALLY CAUSE PERSONAL INJURY. CORRECTION: VEHICLES WILL BE INSPECTED AND A NEW PASSENGER SIDE AIR BAG MODULE WILL BE INSTALLED IF NECESSARY.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.