Recalls that may apply to the 1993 Ford Crown Victoria
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Suspension are shown.
| 98V322000 | 1998-12-16. SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT. VEHICLE DESCRIPTION: CERTAIN 1996-1999 FORD CROWN VICTORIA POLICE, FLEET, NATURAL GAS, AND 1996-1999 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT WERE PRODUCED WITH A LOWER CONTROL ARM BALL JOINT CONTAINING A ONE PIECE BEARING; AND 1990-1996 FORD CROWN VICTORIA POLICE, FLEET, AND NGV VEHICLES AND 1990-1996 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT HAVE BEEN SERVICED WITH EITHER A BALL JOINT CONTAINING THE ONE-PIECE BEARING OR A FRONT LOWER CONTROL ARM CONTAINING A BALL JOINT WITH A ONE-PIECE BEARING. THE ONE-PIECE BEARING WITHIN THE LOWER CONTROL ARM BALL JOINT CAN WEAKEN SLOWLY DURING USE AND EVENTUALLY CRACK. THIS COULD RESULT IN SEPARATION OF THE BALL AND CAP OF THE JOINT, ALLOWING THE CONTROL ARM TO DROP TO THE GROUND. |
|---|---|
| 95V194000 | 1995-10-11. SUSPENSION:FRONT:CONTROL ARM:UPPER ARM. THE BOLTS THAT ATTACH THE FRONT UPPER CONTROL ARMS TO THE FRAME MOUNTING BRACKETS CAN LOOSEN AND FRACTURE AT ONE OF THE BOLT HOLES CAUSING SUBSTANTIAL NEGATIVE CAMBER AND STEERING PULL TO THE AFFECTED SIDE. Built 1992-08-01 to 1994-07-01. |
| 1998251 | 1998-12-22. Suspension. Note: 1996-99 crown victoria police, fleet and ngv and lincoln town car limousine equipped with a lower control arm ball joint containing a one piece bearing and 1990-96 crown victoria police, fleet and ngv and lincoln town car limousine that were serviced with either a ball joint containing an one piece bearing or a front lower control arm with a one piece bearing. High bearing loads can lead to thinning and eventual cracking of the lower control arm ball joint. This can result in separation of the ball and cap of the joint. Should this occur, the control arm to which the cap is mounted will drop to the ground. Should this occur while the vehicle is moving, reduced steering control could result in a collision. Correction: Lower control arm ball joints will be replaced. |
|---|---|
| 1995203 | 1995-11-16. Suspension. NOTE: POLICE PACKAGE VEHICLES ONLY. THE BOLTS THAT ATTACH THE FRONT UPPER CONTROL ARMS TO THE FRAME MOUNTING BRACKETS MAY LOOSEN WHEN SUBJECTED TO EXTREME OPERATING CONDITIONS. THIS COULD CAUSE THE BRACKET TO FRACTURE AT ONE OF THE BOLT HOLES, RESULTING IN A SUBSTANTIAL NEGATIVE CAMBER TO THE ASSOCIATED FRONT WHEEL AND A STEERING "PULL" TO THE COURSE OF VEHICLE TRAVEL. IF A VEHICLE WITH A LOOSE BRACKET ON THE LEFT SIDE WERE OPERATED UNTIL THE BRACKET FRACTURED AT BOTH BOLT HOLES, THE STEERING CONTROL ARM COULD CONTACT THE STEERING COLUMN SHAFT AND POSSIBLY RESULT IN LOSS OF STEERING CONTROL AND AN ACCIDENT. CORRECTION: TORQUE LEVELS OF THE FOUR UPPER CONTROL ARM BOLTS WILL BE CHECKED. IF ANY OF THE BOLTS ARE LOOSE, THE BRACKET(S) WILL BE INSPECTED FOR DAMAGE. IF DAMAGE IS PRESENT IT WILL BE REPAIRED. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.