Recalls that may apply to the 1997 Ford Contour
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Powertrain are shown.
| None found. |
| 2001195 | 2001-07-16. Powertrain. Certain passenger vehicles. The rough surface of the heater blower resistor's stainless steel blades can damage the copper surface of the wiring harness connector. The damage could, over time, cause increased resistance in the connector and, due to subsequent terminal relaxation, result in an open circuit condition. The heater blower resistor may overheat causing the attached electrical connector to melt, creating the potential for a fire. Correction: Dealers will install a new heater blower resistor and a new wire jumper harness. |
|---|---|
| 1998208 | 1998-10-21. Powertrain. On certain vehicles, the floor shift automatic transmission control may be damaged if subjected to certain vehicle interior cleaning products. If exposed to these products, the transmission gear position indicator may deteriorate and not correctly indicate the actual gear position. If this occurs, the shifter will continue to operate normally, but there is the potential for incorrect gear selection. Correction: Automatic transmission floor shift control will be replaced. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.