WenmarOpen by Wenmar Pro

Service bulletins for the 2016 Ford C-max

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

140 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Labels and manuals are shown. Show all

Bulletins, newest first
SSM 485982020-03-03. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. 2013-2018 C-Max, 2013-2020 Fusion Hybrid/MKZ Hybrid vehicles may exhibit a MIL with Diagnostic Trouble Code (DTC) P0340 and/or P0344. This may occur due to excessive moisture build up in the engine oil. Excess moisture occurs when the vehicle is driven short distances and/or less than 6,000 combined miles per year. To correct the condition, replace the camshaft position sensor (CMP) and change the engine oil. Advise the customer to perform more frequent oil changes and allow the internal combustion engine to reach operating temperature when running to prevent reoccurrence. Refer to the owners guide - maintenance - engine oil check - operating in cold climates and short driving cycles.
SSM 477032019-03-04. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Some 2014-2019 Escape, 2014-2018 C-MAX,Focus, and Transit Connect vehicles may exhibit a concern of not able to program and/or no electrical power after installation of a service part Body Control Module(BCM). Inspect the BCM for the presence of fuse F88. If the fuse is missing, install the correct size replacement fuse as outlined in the Wiring Manual and then re-evaluate the concern.
SSM 464542017-05-22. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SOME 2013-2017 C-MAX/FUSION ENERGI AND 2017 C-MAX/FUSION/MKZ HYBRID VEHICLES MAY EXHIBIT AN ILLUMINATED MIL WITH DIAGNOSTIC TROUBLE CODE (DTC) P04B5. THIS MAY BE DUE TO INADVERTENT ACTUATION OF THE FUEL DOOR RELEASE BUTTON BY THE CUSTOMER WHEN EXITING THE VEHICLE. IF THE FUEL FILLER DOOR IS NOT FULLY CLOSED AFTER A REFUELING EVENT, OR THE FUEL FILLER DOOR IS OPEN FROM ERRONEOUSLY PRESSING THE FUEL DOOR RELEASE BUTTON, A MESSAGE DISPLAYS DURING THE THIRD DRIVE CYCLE TO INDICATE THE FUEL FILLER DOOR IS NOT CLOSED AND THE DTC SETS. BEFORE PERFORMING WORKSHOP MANUAL DIAGNOSTICS, CONSULT THE CUSTOMER ABOUT THE POTENTIAL FOR ACCIDENTAL FUEL DOOR ACTUATION AND EXPLAIN THE NEED TO FULLY LATCH THE FUEL DOOR AFTER EVERY REFUELING EVENT.
SSM-458092016-08-30. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. SYNC 3 ACCESSORY PROTOCOL INTERFACE MODULE (APIM) DTCS U3000 OR B108E OR U1A00

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.