Recalls that may apply to the 1991 Eagle PREMIER
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 1998012 | 1998-01-23. Brakes. NOTE: VEHICLES ORIGINALLY RETAILED IN ONTARIO, QUEBEC AND THE MARITIME PROVINCES. THE COMPOSITE FRONT DISC BRAKE ROTORS ON THESE VEHICLES MAY FAIL DUE TO CORROSION. THE CAST IRON WEAR SURFACE MAY SEPARATE FROM THE HUB REDUCING THE BRAKING EFFECTIVENESS OF THE VEHICLE. CORRECTION: FRONT COMPOSITE ROTORS WILL BE REPLACED WITH ONES HAVING A REVISED CORROSION PROTECTION COATING. |
|---|---|
| 1996063 | 1996-04-29. Brakes. Note: Vehicles equipped with Bendix-10 Antilock Brake System (ABS) Vehicles with ABS brakes may experience premature actuator piston seal wear in the ABS hydraulic control unit and/or actuator pump motor deterioration. If this occurs, the ABS function may be lost and reduced power assist may be experienced during vehicle braking. Correction: Vehicles with ABS malfunction will be repaired as necessary. Warranty on all ABS components will be extended to 10 years or 160,000 km (except for the brake actuator piston assembly and the pump-motor assembly which will have lifetime coverage). |
| 1991157 | 1991-11-20. Brakes. On certain vehicles equipped with an anti-lock brake system (ABS), the high pressure hose may leak or detach due to inadequate crimping of the hose-to-end fittings. This condition could result in loss of brake power assist and a possible increase in stopping distances. Correction:(526) ABS high pressure hose will be replaced with a hose of different design and construction. (527) four hundred and twenty six of the identified mini vans will also have the ABS pump casting inspected for porosity. Leaking pumps, if found, will be replaced. |
| 1991059 | 1991-04-08. Brakes. THE FUEL TANK HEAT SHIELD MAY CONTACT THE REAR BRAKE TUBE WHEN THE SUSPENSION IS IN THE FULL JOUNCE POSITION. CONTINUED CONTACT COULD CAUSE THE BRAKE TUBE TO WEAR THROUGH CAUSING LOSS OF BRAKE FLUID AND A PARTIAL BRAKE SYSTEM LOSS WHICH WOULD RESULT IN INCREASED STOPPING DISTANCES. CORRECTION: HEAT SHIELD WILL BE MODIFIED TO ELIMINATE POTENTIAL FOR HEAT SHIELD TO REAR BRAKE TUBE CONTACT. ALL BRAKE TUBES DAMAGED DUE TO CONTACT WITH THE HEAT SHIELD WILL BE REPLACED. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.