Service bulletins for the 2019 Chrysler Pacifica
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
523 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Transmission and driveline are shown. Show all
| 21-036-20 REV. A | 2020-06-22. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; POWER TRAIN. Transmission Case Oil Leak This bulletin involves tightening the lower transmission bolts to updated torque specifications to possibly eliminate a leak at the case split line of the transmission. Customers may notice (possibly transmission) fluid leaking on the ground from the left front of the vehicle. |
|---|---|
| 21-036-20 | 2020-06-22. Service bulletin. FUEL SYSTEM, GASOLINE; POWER TRAIN; EQUIPMENT. Transmission Case Oil Leak This bulletin involves tightening the lower transmission bolts to updated torque specifications to possibly eliminate a leak at the case split line of the transmission. Customers may notice (possibly transmission) fluid leaking on the ground from the left front of the vehicle. |
| 9004244 | 2020-05-26. Service bulletin. POWER TRAIN; FUEL SYSTEM, GASOLINE. COOLER, Transmission Oil Work procedure to address fluid leak issue with the transmission oil cooler on the MP (Part # 68249191A$), KL (Part # 68399021A$) and RU (Part # 68217322A$) needs to be followed. Service Instructions for the Condition of a TOC fluid leak: 1) Mark the leakage area if visible to assist in diagnosis and determination of the area where the leak has occurred. 2) If fluid leak was caused by damage or leakage at the transmission oil cooler: - Replace transmission oil cooler - Test drive and verify no additional fluid leaks 3) If fluid leak was caused by leak at quick connect fittings: - Replace transmission oil cooler lines - Test drive and verify no additional fluid leaks |
| 9003730 | 2019-12-16. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; POWER TRAIN; ELECTRICAL SYSTEM. SI-eVT Transmission - China Variant & 9 inertia ring bolts For SI-eVT Transmission ONLY: Replace the nine (9) flywheel to damper bolts (68382486AA) when replacing the SI-eVT per TechConnect procedure. SI-eVTs built prior to January 11, 2019 had a 05192374AB level cooler. Using service SI-evT built after Jan 11 2019 with the 05192374AC level cooler requires new 68238385AB inlet hose and 68238386AC outlet hose. The service SI-eVT is shipped with a non-China wiring harness (68241331AC). China market replacement must replace wiring harness with 68368596AA. The China variant 68368596AA wiring harness has an interlock to the electrical charge door. |
| 9004164 | 2019-12-16. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION:COLUMN SHIFT ASSEMBLY; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; POWER TRAIN:MANUAL TRANSMISSION:FLOOR SHIFT ASSEMBLY. SHIFTER, Transmission For concern of Service Shifter Message in Cluster with associated DTCs: U11C3 and/or U11E3, please contact Zef Ivanaj at (586) 604-6738 or Neeshim Roy at (248) 512-1433 prior to replacing shifter assembly. If no response in 15 minutes, proceed with repair. |
| 9004150 | 2019-12-02. Service bulletin. FUEL SYSTEM, GASOLINE; POWER TRAIN. SEAL, Input If looking to replace stubshaft due to ATX fluid leaking, do not replace PTU seals. None of the seals from the PTU side will need to be replaced whenever the ATX stubshaft is replaced, even though V-seal (68408748A$) is in direct contact with the stubshaft, it will not avoid grease/oil leakage from transmission side. PTU V-seals are intended to act as a dust cover for stubshaft - PTU input shaft spline interface. PTU Input shaft seal (68408749A$) is intended to hold PTU oil and debris ingress; it should be replaced only if the fluid leakage is confirmed to be PTU oil and not ATX trans. fluid. |
| TS-WI-0421 | 2019-05-13. Service bulletin. POWER TRAIN; SUSPENSION; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. Notify dealers and end users of the availability of a improved pinion bracket |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.