P0CF3 on the 2018 Chrysler Pacifica
The bulletins listed name this code in NHTSA's summary, or are about the same components. A bulletin or a recall listed here may apply to the model year. None of it is a diagnosis.
Nobody has written a description of this code yet.
| 08-107-26 REV. B | 2026-06-03. Service bulletin. Flash: Hybrid Control Processor (HCP) / Auxiliary Hybrid Control Processor (AHCP) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0E15-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance. ● P06E4 - Control Module Wake-Up Circuit Performance. ● P2797-00 - Auxiliary Transmission Fluid Pump Performance. ● P07B5-00 - Park Pawl Position Sensor 1 Circuit Performance. ● P177C-00 - Park Lock-Pawl Actuator Motor Current Sensor Performance. ● P288B-00 - Park Lock-Pawl Actuator Circuit Performance. ● P0CF3-00 - Control Pilot Circuit Open (North America Only). ● P0CF4-00 - Control Pilot Circuit Performance (North America Only). ● P0D57-00 - Proximity Detection Circuit Performance (North America Only). ● P1C68-00 - Hybrid Perf Engine Speed Above Target Idle Speed During Autostop (APAC China Only). Customers may also comment on one or more of the following: ● Vehicle does not start / engine does not crank. ● Extended engine cranking time when starting the vehicle. ● Engine turns on when requesting cabin heat to turn on. ● Loss of heat from the engine. ● Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ● Vehicle will not start when it is cold (-30°C / -22°F and below). ● Heard and/or felt bump when the gas engine turns on while driving. This software release includes the following software enhancement: ● Corrections to allow the vehicle to clear the permanent fault codes This bulletin involves reprogramming the **HCP and then the AHCP** with the latest available software. |
|---|---|
| 08-107-26 REV. A | 2026-04-22. Service bulletin. Flash: Auxiliary Hybrid Control Processor (AHCP) / Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0E15-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance. ● P29BB-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance. ● P06E4 - Control Module Wake-Up Circuit Performance. ● P2797-00 - Auxiliary Transmission Fluid Pump Performance. ● P07B5-00 - Park Pawl Position Sensor 1 Circuit Performance. ● P177C-00 - Park Lock-Pawl Actuator Motor Current Sensor Performance. ● P288B-00 - Park Lock-Pawl Actuator Circuit Performance. ● P0CF3-00 - Control Pilot Circuit Open (North America Only). ● P0CF4-00 - Control Pilot Circuit Performance (North America Only). ● P0D57-00 - Proximity Detection Circuit Performance (North America Only). ● P1C68-00 - Hybrid Perf Engine Speed Above Target Idle Speed During Autostop (APAC China Only). Customers may also comment on one or more of the following: ● Vehicle does not start / engine does not crank. ● Extended engine cranking time when starting the vehicle. ● Engine turns on when requesting cabin heat to turn on. ● Loss of heat from the engine. ● Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ● Vehicle will not start when it is cold (-30°C / -22°F and below). ● Heard and/or felt bump when the gas engine turns on while driving. This software release includes the following software enhancement: ● Corrections to allow the vehicle to clear the permanent fault codes. This bulletin involves reprogramming the AHCP and then the HCP with the latest available software. |
| 08-107-26 | 2026-03-18. Service bulletin. Flash: Auxiliary Hybrid Control Processor (AHCP) / Customers **must** experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle **must** SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **P0E15-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance. ● P29BB-00 - Hybrid-EV Battery Pack Coolant Heater A Control Performance.** ● P06E4 - Control Module Wake-Up Circuit Performance. ● P2797-00 - Auxiliary Transmission Fluid Pump Performance. ● P07B5-00 - Park Pawl Position Sensor 1 Circuit Performance. ● P177C-00 - Park Lock-Pawl Actuator Motor Current Sensor Performance. ● P288B-00 - Park Lock-Pawl Actuator Circuit Performance. ● P0CF3-00 - Control Pilot Circuit Open (North America Only). ● P0CF4-00 - Control Pilot Circuit Performance (North America Only). ● P0D57-00 - Proximity Detection Circuit Performance (North America Only). ● P1C68-00 - Hybrid Perf Engine Speed Above Target Idle Speed During Autostop (APAC China Only). Customers may also comment on one or more of the following: ● **Vehicle does not start / engine does not crank. ● Extended engine cranking time when starting the vehicle. ● Engine turns on when requesting cabin heat to turn on. ● Loss of heat from the engine.** ● Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ● Vehicle will not start when it is cold (-30°C / -22°F and below). ● Heard and/or felt bump when the gas engine turns on while driving. This software release includes the following software enhancement: ● Corrections to allow the vehicle to clear the permanent fault codes. , Special Tools, LOP and Policy sections, updated Claims Data statements, and an updated Repair Procedure. |
| 08-010-21 | 2022-07-18. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates This bulletin involves reprogramming the HCP and AHCP or also known as Power Inverter Module (PIM) with the latest available software. Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states.Customers may also experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) have been set:P06E4 - Control Module Wake-Up Circuit Performance. P2797-00 - Auxiliary Transmission Fluid Pump Performance. P07B5-00 - Park Pawl Position Sensor 1 Circuit Performance. P177C-00 - Park Lock-Pawl Actuator Motor Current Sensor Performance. P288B-00 - Park Lock-Pawl Actuator Circuit Performance. P0CF3-00 - Control Pilot Circuit Open(North America Only). P0CF4-00 - Control Pilot Circuit Performance(North America Only). P0D57-00 - Proximity Detection Circuit Performance(North America Only). P1C68-00 - Hybrid Perf Engine Speed Above Target Idle Speed During Autostop(APAC China Only). Customers may also comment:Vehicle will not start when it is cold -30° C (-22° F) and below. Heard and/or felt bump when the gas engine turns on while driving. This software release includes the following software enhancement: Corrections to allow the vehicle to clear the permanent fault codes. Three modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this HCP&AHCP update:Powertrain Control Module (PCM) Electronic Brake Booster Module (EBBM). Anti-Lock Brake System Module (ABS). |
| 08-010-21 | 2021-02-16. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) Updates This bulletin involves reprogramming the HCP and AHCP or also known as Power Inverter Module (PIM) with the latest available software. Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states.Customers may also experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may find one or more of the following Diagnostic Trouble Codes (DTCs) have been set:P06E4 - Control Module Wake-Up Circuit Performance. P2797-00 - Auxiliary Transmission Fluid Pump Performance. P07B5-00 - Park Pawl Position Sensor 1 Circuit Performance. P177C-00 - Park Lock-Pawl Actuator Motor Current Sensor Performance. P288B-00 - Park Lock-Pawl Actuator Circuit Performance. P0CF3-00 - Control Pilot Circuit Open(North America Only). P0CF4-00 - Control Pilot Circuit Performance(North America Only). P0D57-00 - Proximity Detection Circuit Performance(North America Only). P1C68-00 - Hybrid Perf Engine Speed Above Target Idle Speed During Autostop(APAC China Only). Customers may also comment:Vehicle will not start when it is cold -30° C (-22° F) and below. Heard and/or felt bump when the gas engine turns on while driving. This software release includes the following software enhancement: Corrections to allow the vehicle to clear the permanent fault codes. Three modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this HCP&AHCP update:Powertrain Control Module (PCM) Electronic Brake Booster Module (EBBM). Anti-Lock Brake System Module (ABS). |
| 08-042-20 | 2020-05-26. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processer (AHCP) Diagnostic and System Updates This bulletin involves updating the HCP and the AHCP with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may one or more of the following DTCs have been set:P0CF3-00 - Control Pilot Circuit Open(North America Only). P0CF4-00 - Control Pilot Circuit Performance(North America Only). P0D57-00 - Proximity Detection Circuit Performance(North America Only). P1C68-00 - Hybrid Perf Engine Speed Above Target Idle Speed During Autostop(APAC China Only). |
| 08-042-20 | 2020-05-18. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processer (AHCP) Diagnostic and System Updates This bulletin involves updating the HCP and the AHCP with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may one or more of the following DTCs have been set:P0CF3-00 - Control Pilot Circuit Open(North America Only). P0CF4-00 - Control Pilot Circuit Performance(North America Only). P0D57-00 - Proximity Detection Circuit Performance(North America Only). P1C68-00 - Hybrid Perf Engine Speed Above Target Idle Speed During Autostop(APAC China Only). |
| 08-042-20 | 2020-04-27. Service bulletin. Flash: Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processer (AHCP) Diagnostic and System Updates This bulletin involves updating the HCP and the AHCP with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may one or more of the following DTCs have been set:P0CF3-00 - Control Pilot Circuit Open(North America Only). P0CF4-00 - Control Pilot Circuit Performance(North America Only). P0D57-00 - Proximity Detection Circuit Performance(North America Only). P1C68-00 - Hybrid Perf Engine Speed Above Target Idle Speed During Autostop(APAC China Only). |
8 on file from NHTSA, as of 2026-10-19. See them in the bulletin list. A bulletin lists model years: read the document for which vehicles it concerns.