Recalls that may apply to the 1990 Chrysler Dynasty
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| None found. |
| 1996063 | 1996-04-29. Brakes. Note: Vehicles equipped with Bendix-10 Antilock Brake System (ABS) Vehicles with ABS brakes may experience premature actuator piston seal wear in the ABS hydraulic control unit and/or actuator pump motor deterioration. If this occurs, the ABS function may be lost and reduced power assist may be experienced during vehicle braking. Correction: Vehicles with ABS malfunction will be repaired as necessary. Warranty on all ABS components will be extended to 10 years or 160,000 km (except for the brake actuator piston assembly and the pump-motor assembly which will have lifetime coverage). |
|---|---|
| 1991157 | 1991-11-20. Brakes. On certain vehicles equipped with an anti-lock brake system (ABS), the high pressure hose may leak or detach due to inadequate crimping of the hose-to-end fittings. This condition could result in loss of brake power assist and a possible increase in stopping distances. Correction:(526) ABS high pressure hose will be replaced with a hose of different design and construction. (527) four hundred and twenty six of the identified mini vans will also have the ABS pump casting inspected for porosity. Leaking pumps, if found, will be replaced. |
| 1991008 | 1991-01-10. Lights And Instruments. NOTE: VEHICLES LOCATED IN ONTARIO, QUEBEC, NEW BRUNSWICK, NOVA SCOTIA, PRINCE EDWARD ISLAND AND NEWFOUNDLAND. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING DUE TO CORROSION FAILURE OF THE DAYTIME RUNNING LIGHT MODULE. CORRECTION: DRL MODULE WILL BE REPLACED WITH ONE HAVING ADDITIONAL POTTING MATERIAL THAT COVERS ALL PREVIOUSLY EXPOSED COMPONENTS. |
| 1991003 | 1991-01-03. Electrical. VEHICLES BUILT WITHOUT THE AUTOMATIC TEMPERATURE CONTROL SYSTEM MAY BE SUSCEPTIBLE TO WATER ENTRY AT THE WINDSHIELD COWL ABOVE THE HEATER BLOWER MOTOR RESISTOR BLOCK. MOISTURE CORROSION OF THE RESISTOR TERMINALS COULD CAUSE AN INCREASE IN ELECTRICAL RESISTANCE WHICH COULD CAUSE OVERHEATING AND POSSIBLY RESULT IN A COWL AREA FIRE. CORRECTION: BLOWER MOTOR RESISTOR BLOCK WILL BE REPLACED AND A MASTIC PATCH WILL BE APPLIED TO SEAL THE COWL AGAINST WATER ENTRY. ALREADY DAMAGED WIRING CONNECTORS WILL ALSO BE REPLACED AS REQUIRED. |
| 1989178 | 1989-12-20. Engine. ON VEHICLES WITH 2.2 LITRE OR 2.5 LITRE EFI(NON-TURBO) ENGINE, THE VALVE COVER GASKET MAY LEAK OIL CREATING THE POTENTIAL FOR AN ENGINE COMPARTMENT FIRE. CORRECTION: VALVE COVER GASKET WILL BE REPLACED WITH A REVISED COVER AND RTV SEALANT APPLIED IN PLACE OF THE GASKET. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.