WenmarOpen by Wenmar Pro

Service bulletins for the 2012 Chrysler 300

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

275 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Throttle and cruise control are shown. Show all

Bulletins, newest first
68277402A2022-10-24. Service bulletin. VEHICLE SPEED CONTROL:CRUISE CONTROL. Adaptive Cruise Control Sensor
68277402A2022-09-15. Service bulletin. VEHICLE SPEED CONTROL:CRUISE CONTROL. Adaptive Cruise Control Sensor
23-009-12 REV. A2022-07-25. Service bulletin. VEHICLE SPEED CONTROL; STRUCTURE:INTERIOR PANELS:DOOR. Incorrect Rear Door Trim Panel Inspect and if necessary remove and replace the right and left rear door trim panel. Incorrect right and left rear door trim panel.
23-004-132021-03-29. Service bulletin. VEHICLE SPEED CONTROL; BACK OVER PREVENTION. Right And/Or Left Rear Door Contacts Inner Quarter Panel This bulletin involves inspecting and if necessary installing a new rear door bumper stop. Right and/or left rear door contacts inner quarter panel.
S15080004802020-05-26. Service bulletin. VEHICLE SPEED CONTROL. Speed Control Operates Intermittently
S15080004802020-05-18. Service bulletin. VEHICLE SPEED CONTROL. Speed Control Operates Intermittently
S19080002122020-04-27. Service bulletin. EXTERIOR LIGHTING; VEHICLE SPEED CONTROL. High Beams Are Inop, Shutter Door On High Beams Open And Then Close In Cold Ambient Temperatures. DTC B1632-11 And B1636-11 Set
68277402A2018-06-11. Service bulletin. VEHICLE SPEED CONTROL:CRUISE CONTROL. Adaptive Cruise Control Sensor 1) If you are replacing this part due to the cluster displaying Clean Radar Sensor in Front of Vehicle or DTC C1266 ACC Sensor Blinded, please verify that there is no blockage in front of the sensor. Blockage can occur from mud, ice, snow, front end damage, bracket damage, the sensor not attached to the bracket properly or an aftermarket fascia installed. This fault can occur intermittently in muddy or icy/snowy conditions and is considered normal operation. Under some circumstances, a misaligned sensor can also cause the C1266 DTC, please complete an alignment procedure. No replacement is required.~ 2) If you are replacing this part due to the cluster displaying ?ACC/FCW Unavailable Service Required?, please check the DTC fault codes. This will indicate which module needs to be serviced (TCM, PCM, ESP/ABS, etc). This fault is not due to the ACC Sensor. No sensor replacement is required.~ 3) If you have fault code DTC C125E ACC Sensor Adjustment Required, please verify that the radar sensor is fully seated in the clips and there is no damage (if clips are damaged on a 2013 or earlier vehicle, order P/N 68085813A$, otherwise please replace the module), please verify there is no blockage to the sensor due to mud, ice, snow, front end damage, bracket damage or the sensor not attached to the bracket properly. Perform the Vertical Alignment and the Electronic Horizontal Alignments procedure as stated in the service manual. Please note, if the horizontal alignment procedure will not complete, check the vertical alignment and confirm that the sensor is seated properly. Rerun the horizontal alignment procedure. No sensor replacement is required. **Hints for running Horizontal Alignment procedure: A) Verify speed is between 45 and 75 mph, B) verify the road is relatively straight with signs, poles, guard rails, etc C) Do not tail a vehicle too closely this inhibits the learning procedure

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.