Service bulletins for the 2010 Chevrolet Suburban
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1552 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Backup camera are shown. Show all
| 15NA082B | 2024-02-12. Service bulletin. BACK OVER PREVENTION. Clunking Noise from Front of Vehicle During Turns and/or Bumps |
|---|---|
| 15NA082 | 2024-02-12. Service bulletin. BACK OVER PREVENTION. Clunking Noise from Front of Vehicle During Turns and/or Bumps |
| PIT4684A | 2023-12-26. Service bulletin. BACK OVER PREVENTION. Rear Camera Display Blank. |
| PIT4684A | 2023-11-20. Service bulletin. BACK OVER PREVENTION. Rear Camera Display Blank. |
| 070601016G | 2022-06-13. Service bulletin. BACK OVER PREVENTION. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement. |
| PI0608A | 2018-04-23. Service bulletin. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. This preliminary information bulletin provides information and additional diagnostics on park assist blocked being messaged on the DIC. |
| 10-00-89-006C | 2018-04-16. Service bulletin. BACK OVER PREVENTION: SENSING SYSTEM: RADAR. This informational bulletin provides directions on submitting different PIRs |
| PIT5209A | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM; BACK OVER PREVENTION: BACK-UP ALARM; BACK OVER PREVENTION; STRUCTURE. This Preliminary Information communication provides information to the technician about vehicles that for no reason the alarm will go active. Technician will need to use a scan tool to verify that the alarm was activated by the inclination sensor. If the trigger is the inclination sensor, inspect the sensor's mounting location. Technician will need to relocate the sensor if it is attached to the driver's side lower Heater-Vent-Air Conditioning duct. Technician will need to reinstall the sensor to the top of the Body Control Module bracket. |
| PIT4684B | 2017-08-15. Service bulletin. BACK OVER PREVENTION: CAMERA SYSTEM; ELECTRICAL SYSTEM:WIRING. This Preliminary Information communication provides information to the technician about vehicles that have a rear camera display being inoperative when shifting into reverse. Technician should check for a loose or disconnected X421/X322 connector behind the right side "C" pillar trim. Technician should also check for pinched, Open or shorted wires on camera circuits 7641, 7642, and 6799. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.