Recalls that may apply to the 2000 Chevrolet Silverado
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Steering are shown.
| 00V054000 | 2000-02-28. STEERING:LINKAGES:DRAG:LINK:CONNECTION. VEHICLE DESCRIPTION: CHASSIS CABS. THE TAPERED HOLE IN THE DRAG LINK END THAT ATTACHES TO THE PITMAN ARM TAPERED BALL STUD MAY BE MACHINED TOO DEEP CAUSING THE HOLE TO BE OVERSIZED. A DRAG LINK WITH AN OVERSIZED HOLE MAY NOT "SEAT" THE PITMAN ARM TAPERED BALL WHEN ASSEMBLED. THIS COULD CAUSE HIGHER THAN NORMAL FRICTION BETWEEN COMPONENTS DURING OPERATION, AND POSSIBLY RESULT IN JOINT SEPARATION OR A BROKEN BALL STUD. Built 1999-08-01 to 1999-09-30. |
|---|
| 2000053 | 2000-03-08. Steering. On certain 3500HD vehicles, the tapered hole in the drag link end that attaches to the pitman arm tapered ball stud may be machined too deep causing the hole to be oversized. A drag link with an oversized hole may not "seat" the pitman arm tapered ball stud when assembled. This could cause higher than normal friction between components during operation, and over time, result in a joint separation or a broken ball stud. If the joint separated or the ball stud broke while the vehicle was moving, steering control would be lost and a vehicle crash could occur without prior warning. Correction: Dealers will inspect the steering linkage assembly, and if necessary, replace the drag link and pitman arm. |
|---|
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.