WenmarOpen by Wenmar Pro

Service bulletins for the 2015 Chevrolet Impala

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1659 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Fuel system are shown. Show all

Bulletins, newest first
04-06-04-051D2018-05-21. Service bulletin. EQUIPMENT; FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM:INJECTORS. This informational bulletin provides information for maintenance cleaning of the fuel injectors.
18NA0722018-05-21. Service bulletin. FUEL SYSTEM, GASOLINE. This technical bulletin provides a procedure to inspect the fuel system and replace the high pressure fuel pump if faulty for a Reduced Engine Power, MIL On, DTC P228C condition.
15-NA-0632018-05-21. Service bulletin. FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP; EQUIPMENT. This technical bulletin provides repair information to correct a customer concern the CNG fill receptacle dust cap tether is prematurely wearing. The premature wear can be described as being cracked, weather checked or broken.
050604022N2018-05-07. Service bulletin. FUEL SYSTEM, GASOLINE. This informational bulletin provides information on the top tier fuels that are recommended in GM vehicles.
040604051D2018-05-07. Service bulletin. FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM:INJECTORS. This informational bulletin provides information for maintenance cleaning of the fuel injectors.
PIP5385D2018-02-21. Service bulletin. FUEL SYSTEM, OTHER:DELIVERY:FUEL PUMP; FUEL SYSTEM, GASOLINE. This Preliminary Information communication advises the technician on the steps to diagnose the concern, and the steps to repair the concern of Diagnostic Trouble Code P228C setting. The technician is to inspect the fuel and readings for the High Pressure Fuel Pump. The technician is to drain and clean fuel tank and all lines if contamination is found. The technician is to replace the high pressure fuel pump and the fuel inlet line to the high pressure fuel pump. The dealer is to request the customer complete the fuel survey attached and send to the fuel system engineer at the e-mail address provided. Latest revision added model years to the PI with no other changes. New revision adds model year and removes the customer surveys.
PIP53252018-01-22. Service bulletin. FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician to help determine if the vehicle is equipped with factory or aftermarket Compressed Natural Gas, Liquefied Petroleum Gas, or Bi-Fuel Systems. Technician will check for the Vehicle Emission Control Information Label. By using the engine Regular Production Option Code as well as the Vehicle Emission Control Information Label, technician can confirm the vehicle has a factory installed alternative fuel system or who the manufacturer is of the aftermarket fuel system.
05-00-89-072D2017-10-15. Service bulletin. FUEL SYSTEM, GASOLINE. This informational Bulletin provides Do's and Don'ts for maximizing gasoline engine fuel economy, other various tips and a list of websites for additional information.
PIP53392017-08-15. Service bulletin. FUEL SYSTEM, OTHER. This Preliminary Information communication provides information to the technician about a customer?s request to remove or disable the Bi-Fuel Compressed Natural Gas system. General Motors does not condone the removal of the original equipped Compressed Natural Gas systems.
PIT4943D2017-08-15. Service bulletin. FUEL SYSTEM, GASOLINE; FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp. Technician may find Diagnostic Trouble Code P0442. Technician will need to review Techlink article from May 2013 titled "Using the Evaporative Emissions System Tester" Technician will need to follow these steps to help diagnose the issue. First after the P0442 has been verified do not disturb any of the fuel system components. The technician now can use the scan tool to close the Evaporative Emissions System. If possible change the tank pressure sensor units from inch_H2O to milimeter_Hg for better resolution. Now the vehicle can be stared to monitor the tank pressure sensor output value for approximately two minutes. If the tank pressure sensor value does change, pressurize the fuel tank side of the purge solenoid with the GE 41413-A / J 41413-A and the necessary adaptors. Now add smoke and allow pressure to stabilize for 2 minutes. If smoke is allowed to pass through the purge solenoid, replace the purge solenoid. If the tank pressure sensor value does not change, then install CH-48096 adaptor between the purge line from the canister and the purge solenoid. With the Evaporative Emissions System closed, pressurize the system through the CH-48096 adaptor and allow the system to completely stabilize, by observing the Press / Vac Gauge for a minimum of 5 minutes. Now add smoke to the system with GE 41413-A / J 41413-A after system stabilization. Now inspect the purge solenoid, engine side, fuel cap, canister vent solenoid filter and any line quick connects. When the leak is unable to be located, test under a vacuum condition. his type of leak may be detected by using the scan tool Purge/Seal function to create a vacuum in the Evaporative Emissions System and then observe the FTP sensor parameter for vacuum decay.
PIP53262017-08-15. Service bulletin. FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY. This Preliminary Information communication advises the technician that the Compressed Natural Gas tank part number 23271790 has been placed on part restriction though General Motors Product Quality Center. Dealer will need to contact General Motors Product Quality Center for further assistance.
PIP5163B2017-08-15. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; FUEL SYSTEM, GASOLINE; ENGINE. This Preliminary Information communication provides information to the technician about engine block that have a possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, an out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.
07-06-04-025K2017-08-15. Service bulletin. FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP. This informational bulletin was provides information for the technician of cold start ticking noises in the engine compartment and may be caused by the fuel pump and/or the fuel injectors and no repairs are needed for a normal condition.
05-06-04-022L2017-08-15. Service bulletin. FUEL SYSTEM, GASOLINE. This informational bulletin provides information on top tier fuels and what brands are available.
PIP5507B2017-08-15. Service bulletin. FUEL SYSTEM, GASOLINE; FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP. This Preliminary information communicatesIn ambient temperatures 100F (37.7 C)degrees or higher, DTCs P2635 and/or P018B may set.The vehicle may also exhibit a hesitation or stalling condition.Excessively Hot and sustained ambient temperatures over 100F (37.7 C) degrees Mainly in TX, AZ, UT, NV, CA, NM (could be any state) causingVapor buildup in fuel feed line.Customers can be advised to utilize fuels with octane levels greater than 91, Refrain from extended idleing periods if possible, park vehicles in covered garage.Replacing the fuel pump will not repare this concern.
PIP5507A2017-08-15. Service bulletin. FUEL SYSTEM, OTHER:DELIVERY:FUEL PUMP. This Preliminary information communicatesIn ambient temperatures 100F (37.7 C)degrees or higher, DTCs P2635 and/or P018B may set.The vehicle may also exhibit a hesitation or stalling condition.Excessively Hot and sustained ambient temperatures over 100F (37.7 C) degrees Mainly in TX, AZ, UT, NV, CA, NM (could be any state) causingVapor buildup in fuel feed line.Customers can be advised to utilize fuels with octane levels greater than 91, Refrain from extended idleing periods if possible, park vehicles in covered garage.Replacing the fuel pump will not repare this concern.
PIP5371A2017-08-15. Service bulletin. FUEL SYSTEM, GASOLINE; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This Preliminary Information communication provides information to the technician about the multiple alternative gaseous fuel vehicles General Motors offers. Chevrolet Express and GMC Savana vans 2011 through 2016 offered a dedicated Compressed Natural Gas system. Refer to the latest version of PI0417 for more information. Chevrolet Express and GMC Savana 3500, 4500 Cutaway Vans 2012 through 2016 offered a dedicated Liquefied Petroleum Gas system. Refer to the latest version of PI0722 for more information. Chevrolet Silverado and GMC Sierra's 2013 through 2016 offered a combination of Compressed Natural Gas and Gasoline fuel systems. Refer to the latest version of PI0834 for more information. Chevrolet Impala's 2015 through 2016 offered a combination of Compressed Natural Gas and Gasoline fuel systems. Refer to the latest version of PI1330 for more information. The Compressed Natural Gas fuel system operates under high pressure up to 3600 psi. The Liquefied Petroleum Gas fuel system operates under high pressure up to 300 psi. Service and repair of this system should only be performed by a General Motors trained alternative fuels service technician with the proper knowledge and tools.
PIP53852017-08-15. Service bulletin. FUEL SYSTEM, GASOLINE. This Preliminary Information communication provides information to the technician with the steps to diagnose and repair vehicles that may have Service Engine Soon lamp or reduced engine power message came on and was cleared after cycling the key. Also technician may find a P228C set as current or history, and a prior history of High Pressure Fuel Pump replacement, and the customer has been using E85 fuel. If the Diagnostic Trouble Code is current follow Service Information instruction for the repair. If the code is set in history and there are no current drivability concerns take a large fuel sample and let it sit for a couple of hours looking for contamination. Verify the fuel pressure using a scan tool the actual and desired fuel pressures are very close to the same. If contamination is found in the tank then completely flush the fuel system and add e-10 fuel. Also remove the high pressure fuel pump inlet line from both ends. Using regulated air down to about 60 pounds per square inch or lower, blow through the inlet side of this pipe / hose. Inspect for restriction in the check valve built into this hose. If restricted then replace the pipe run a tank of premium fuel through the vehicle and reevaluate the concern.
05-06-04-035E2017-08-15. Service bulletin. FUEL SYSTEM, OTHER. This informational bulletin provides dealership personnel with information on flexible fuel vehicles (FFVs) and the usage of E85 fuel in GM vehicles.
15-06-04-0012017-08-15. Service bulletin. FUEL SYSTEM, OTHER:FUEL FILTER. This informational bulletin provides technicians with service tips for CNG high pressure fuel filter replacement (housing under rear of vehicle).
04-06-04-051D2017-08-15. Service bulletin. FUEL SYSTEM, GASOLINE:FUEL INJECTION SYSTEM. This informational bulletin provides information for maintenance cleaning of the fuel injectors.
PIP5385C2017-08-15. Service bulletin. FUEL SYSTEM, GASOLINE; FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP. This Preliminary Information communication advises the technician on the steps to diagnose the concern, and the steps to repair the concern of Diagnostic Trouble Code P228C setting. The technician is to inspect the fuel and readings for the High Pressure Fuel Pump. The technician is to drain and clean fuel tank and all lines if contamination is found. The technician is to replace the high pressure fuel pump and the fuel inlet line to the high pressure fuel pump. The dealer is to request the customer complete the fuel survey attached and send to the fuel system engineer at the e-mail address provided. Latest revision added model years to the PI with no other changes.
PIP5326A2017-08-15. Service bulletin. FUEL SYSTEM, OTHER:STORAGE; FUEL SYSTEM, OTHER. This Preliminary Information communication advises the technician that the Compressed Natural Gas tank is no longer on restriction through the General Motors Product Quality Center. Dealer can now order part through the normal Customer Care and Aftersales parts process.
PIT4943C2017-08-15. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; FUEL SYSTEM, GASOLINE; SERVICE BRAKES, HYDRAULIC. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp. Technician may find Diagnostic Trouble Code P0442. Technician will need to review Techlink article from May 2013 titled "Using the Evaporative Emissions System Tester" Technician will need to follow these steps to help diagnose the issue. First after the P0442 has been verified do not disturb any of the fuel system components. The technician now can use the scan tool to close the Evaporative Emissions System. If possible change the tank pressure sensor units from inch_H2O to milimeter_Hg for better resolution. Now the vehicle can be stared to monitor the tank pressure sensor output value for approximately two minutes. If the tank pressure sensor value does change, pressurize the fuel tank side of the purge solenoid with the GE 41413-A / J 41413-A and the necessary adaptors. Now add smoke and allow pressure to stabilize for 2 minutes. If smoke is allowed to pass through the purge solenoid, replace the purge solenoid. If the tank pressure sensor value does not change, then install CH-48096 adaptor between the purge line from the canister and the purge solenoid. With the Evaporative Emissions System closed, pressurize the system through the CH-48096 adaptor and allow the system to completely stabilize, by observing the Press / Vac Gauge for a minimum of 5 minutes. Now add smoke to the system with GE 41413-A / J 41413-A after system stabilization. Now inspect the purge solenoid, engine side, fuel cap, canister vent solenoid filter and any line quick connects. When the leak is unable to be located, test under a vacuum condition. his type of leak may be detected by using the scan tool Purge/Seal function to create a vacuum in the Evaporative Emissions System and then observe the FTP sensor parameter for vacuum decay.
SB-16NA-1312016-08-10. Service bulletin. FUEL SYSTEM, DIESEL; FUEL SYSTEM, OTHER; FUEL SYSTEM, GASOLINE. THIS INFORMATIONAL BULLETIN PROVIDES INFORMATION ON VEHICLES DESIGNED TO OPERATE ON GASEOUS FUELS.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.