Recalls that may apply to the 2005 Chevrolet Corvette
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
Only campaigns about Brakes are shown.
| None found. |
| 2010134 | 2010-04-27. Brakes. Certain vehicles equipped with tilt and telescoping steering column may have an intermittent or open condition in a connector in the Steering Wheel Position Sensor (SWPS) circuit located in the steering column. If this intermittent or open condition occurs, the “SERVICE ACTIVE HANDLING SYSTEM” message is displayed, and a short-duration brake apply may occur if the signals for steering wheel rotation or ground are corrupted. The manufacturer assessed the brake application as observable, but controllable and vehicle handling is maintained by minor corrections in steering, however, if the driver does not respond to the change in vehicle movement, it could result in a crash causing property damage, personal injury or death. Correction: Dealers will inspect and, if necessary, install a terminal position assurance clip to the connector. |
|---|---|
| 2004389 | 2004-10-29. Brakes. Certain vehicles were produced with one or both rear brake hydraulic lines that can come in contact with or be affected by heat from the left engine exhaust manifold and the left exhaust pipe. Also, on some 2005 vehicles, the crossover brake line to the right rear brake can come in contact with the rear differential case. In both cases, a half system brake failure could occur, resulting in increased stopping distances. Correction: Dealers will repair/reposition the rear brake lines. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.