Recalls that may apply to the 1985 Chevrolet Corvette
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 91V143000 | 1991-09-04. SEAT BELTS:FRONT:ANCHORAGE. UNDER CERTAIN VEHICLE OPERATIONS AND OCCUPANT USAGE CONDITIONS, THE SAFETY BELTS CAN LOCKUP OR JAM IN THE SAFETY BELT RETRACTOR. Built 1983-02-01 to 1991-05-01. |
|---|
| 1991126 | 1991-09-11. Seats And Restraints. NOTE: OWNER SELF INSPECTION - REPAIR ONLY IF PROBLEM OCCURS. THE SEAT BELT MAY LOCK-UP OR JAM IN THE RETRACTOR. IF THIS OCCURS, VEHICLE OCCUPANTS WILL BE UNABLE TO USE THE SEAT BELT. THUS, IN THE EVENT OF A VEHICLE CRASH, UNBELTED OCCUPANTS WILL BE MORE AT RISK OF INJURY. CORRECTION: VEHICLES WILL BE INSPECTED AND ANY RETRACTOR SIDE BELTS LOCKING UP OR JAMMED WILL BE REPLACED. |
|---|---|
| 1986092 | 1986-08-19. Engine. Certain Camaro, Firebird, Monte Carlo and Grand Prix equipped with a 5.0L engine, and 5.7L Corvettes. High ignition coil temperatures combined with the stress of higher voltage may break down the coating of the high output ignition coil secondary windings. Declining ignition voltage may lead to engine misfire, hesitation sags or no re-start. Depending on road condition, this could result in a significant safety hazard. Correction: High output ignition coil will be replace, spark plug gap will be revised and a spark plug gap revision label will be installed. |
| 1985101 | 1985-09-18. CORROSION AND DETERIORATION OF AN ELECTRONIC COMPONENT WITHIN THE MASS AIR FLOW SENSOR RESULTS IN A LOW SIGNAL VOLTAGE TO THE ELECTRONIC CONTROL MODULE REDUCING FUEL DELIVERY. THIS CAUSES STALLING AT ENGINE IDLE OR A NO-START CONDITION. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.