WenmarOpen by Wenmar Pro

Service bulletins for the 2018 Chevrolet Colorado

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1262 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Wiring and fuses are shown. Show all

Bulletins, newest first
22NA0032022-05-31. Service bulletin. ELECTRICAL SYSTEM:WIRING. This technical bulletin provides a procedure to inspect and repair possible locations to wiring shorts in the wiring harness or wiring harness contact areas they may cause shorts.
PIP5416D2022-02-14. Service bulletin. UNKNOWN OR OTHER; ELECTRICAL SYSTEM:WIRING. This Preliminary Information communicates to the technician the potential areas of concern in which the engine wiring harness may chafe. It describes in detail what to look for. If you encounter any of these specific described chafes, inspect, repair (as necessary) and route the wiring harness away from these possible chafe points.
17-NA-2192021-04-14. Service bulletin. ELECTRICAL SYSTEM:WIRING. Diagnostic Tip for Malfunction Indicator Lamp (MIL) Illuminated - DTC P249D, P249E, U029D, U029E Set Some customers may comment that the MIL is illuminated. The technician may find one or more of the following DTCs set: • U029D • U029E • P249D • P249E Note: The graphic above depicts an example of a torn and missing seal. • Moisture intrusion past a damaged (1) seal located in the connector for the NOx sensor wiring harness. • Missing (2) seal located in the connector for the NOx sensor wiring harness. Correction If you encounter a vehicle with the above concern, perform normal diagnostics for the codes set. ⇒ If diagnostics lead to NOx sensor replacement, inspect the mating chassis electrical connector for corrosion. Clean and repair as necessary.
17-NA-2922021-04-14. Service bulletin. ELECTRICAL SYSTEM:WIRING:RELAYS/SOLENOIDS; ELECTRICAL SYSTEM:WIRING. Malfunction Indicator Lamp (MIL) Illuminated - DTC P3409 and/or P3433 Condition Some customers may comment that the MIL is illuminated. The technician may find one or more of the following DTCs set: • P3409 • P3433 Cause This condition may be caused by a wiring issue with both/either the cylinder 2 deactivation solenoid oil control valve circuit and/or the cylinder 5 deactivation solenoid oil control valve circuit. These codes may be active or stored in history. • This may also be a repeat concern. Correction Note: When replacing the solenoids, ensure there are no terminal issues at the connector. To correct this condition, refer to the information below: • If vehicle was built between 4/13/2017 and 8/7/2017, it will be necessary to replace both right and left bank Cylinder Deactivation Solenoids (AFM OCV). • If vehicle was built outside the date range, check for any terminal issues at the connector. If no trouble found, follow SI diagnostics for the applicable DTC.
17NA2922019-05-13. Service bulletin. ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM:WIRING. This technical bulletin provides a procedure to inspect the wires and/or replace the Valve Rocker Arm Oil Control Valves if the DTCs listed are set.
100089005G2019-05-13. Service bulletin. ELECTRICAL SYSTEM:WIRING. This warranty admin bulletin explains to the technician additional information may be needed when submitting transactions when doing wiring repairs.
PIP5416B2019-04-08. Service bulletin. ELECTRICAL SYSTEM:WIRING; ENGINE. This Preliminary Information communicates to the technician the potential areas of concern in which the engine wiring harness may chafe. It describes in detail what to look for. If you encounter any of these specific described chafes, inspect, repair (as necessary) and route the wiring harness away from these possible chafe points.
100089005H2019-03-18. Service bulletin. ELECTRICAL SYSTEM:WIRING. This warranty admin bulletin explains to the technician additional information may be needed when submitting transactions when doing wiring repairs.
PIP55712018-08-06. Service bulletin. ELECTRICAL SYSTEM:WIRING. This Preliminary information communicates a possible concern of two connectors being swapped during a repair causing a P0016 code to set.
17NA2922018-04-23. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ELECTRICAL SYSTEM:WIRING. This technical bulletin provides a procedure to inspect the wires and/or replace the Valve Rocker Arm Oil Control Valves if the DTCs listed are set.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.