WenmarOpen by Wenmar Pro

Recalls that may apply to the 2000 Chevrolet Blazer

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
08V2310002008-05-21. EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH. GENERAL MOTORS IS RECALLING 5,862 MY 2000-2002 CHEVROLET BLAZER, MY 2000-2001 GMC JIMMY, AND MY 2000 OLDSMOBILE BRAVADA SPORT UTILITY VEHICLES. THE MULTIFUNCTION SWITCH COULD DEVELOP AN OPEN CIRCUIT CONDITION THAT RESULTS IN THE STOP LAMPS AND THE REAR HAZARD LAMPS BECOMING INOPERATIVE. THE CENTER HIGH MOUNTED STOP LAMP AND TURN SIGNAL FUNCTIONS ARE NOT AFFECTED. Built 1999-09-01 to 2000-07-31.
01V3640002001-12-03. EXTERIOR LIGHTING:HAZARD FLASHING WARNING LIGHTS:SWITCH; EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH. VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE MULTIFUNCTION SWITCH COULD DEVELOP AN OPEN CIRCUIT CONDITION THAT RESULTS IN THE STOP LAMPS AND THE REAR HAZARD LAMPS BECOMING INOPERATIVE. THE CENTER HIGH MOUNTED STOP LAMP AND TURN SIGNAL FUNCTIONS ARE NOT AFFECTED. Built 1999-09-01 to 2000-07-31.
00V2280032000-08-07. SEAT BELTS. VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT DUTY TRUCKS, SPORT UTILITY VEHICLES, AND MINI VANS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES." Built 2000-04-01 to 2000-05-31.
99V2200001999-08-11. SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP. VEHICLE DESCRIPTION: S -TRUCKS EQUIPPED WITH 2 WHEEL DRIVE. THESE VEHICLES MAY HAVE HAD THE RIGHT-HAND ANTILOCK BRAKE SYSTEM (ABS) MODULE FEED PIPE AND/OR BRAKE CROSSOVER PIPE TUBE NUTS TIGHTENED WITHOUT SEATING THE PIPE-FLARED-ENDS ENOUGH TO WITHSTAND NORMAL ASSEMBLY AND VEHICLE INPUTS WITHOUT PARTIALLY UNSEATING. THIS DOES NOT COMPLY WITH REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC SERVICE BRAKE NORMAL, EMERGENCY, AND PARK BRAKING PERFORMANCE." Built 1999-03-01 to 1999-07-31.
Canada: Transport Canada, as of 2026-10-19
20081782008-05-22. Electrical. On certain vehicles, the multifunction switch may develop an open circuit condition with the bottom contact of the hazard switch, causing the stop lamps and the hazard lamps to become inoperable (the center high mounted stop lamp and turn signal functions are not affected). The loss of stop lamp and rear hazard lamp function could fail to warn a following driver that the vehicle is braking and/or is stopped, which could result in a crash causing personal injury or death. Correction: Dealers will inspect and replace either the hazard warning switch, or the multifunction switch assembly. Note: This campaign expands the population of recall 2001285.
20012852001-12-05. Electrical. Certain sport utility vehicles. The multifunction switch could develop an open circuit condition with the bottom connector in the hazard switch carrier that results in the stop lamps and the hazard lamps becoming inoperative. The center high mounted stop lamp and turn signal functions are not affected. The loss of stop lamps and rear hazard lamps could fail to warn a following driver that the vehicle is braking and/or is stopped and could result in a crash. Correction: Dealers will replace the hazzard warning flasher switch.
20002012000-09-19. Other. Certain vehicles may have incorrect payload information on the vehicle certification label. The payload shown on the label is greater than the maximum validated payload. If the vehicle is loaded to the incorrectly labeled payload, it may not ride and handle in the manner expected by the operator and could lead to loss of vehicle control and and/or an inability to stop the vehicle within expected stopping distances. Correction: Dealers will install a new label, directing operators to their owner's manual for payload information.
20001962000-09-15. Seats And Restraints. Certain vehicles do not comply with the requirements of C.M.V.S.S. 209 - Seat Belt Assemblies. Vehicles may have seat belt assemblies that will not withstand the force requirements of the standard. In a crash, if the belt buckle fails, there is an increased risk of injury to the occupant. Correction: Suspect buckle assemblies will be replaced.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.