WenmarOpen by Wenmar Pro

Recalls that may apply to the 1994 Chevrolet Blazer

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
99V1930001999-07-19. SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP. VEHICLE DESCRIPTION: CERTAIN 4-WHEEL DRIVE PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH ABS (ANTILOCK BRAKING SYSTEM) MANUFACTURED FROM SEPTEMBER 1989 THROUGH AUGUST 1996. UNDER CERTAIN DRIVING CONDITIONS THE SWITCH WHICH SIGNALS THE ABS SYSTEM WHETHER THE VEHICLE IS IN 2-WHEEL OR 4-WHEEL DRIVE CAN MALFUNCTION CAUSING INCREASED STOPPING DISTANCES DURING ABS STOPS WHILE IN THE TWO-WHEEL DRIVE MODE.
94V1140001994-06-20. TRAILER HITCHES. THE TRAILER HITCH ATTACHING BOLTS WERE NOT TIGHTENED TO THE SPECIFIED TORQUE. THIS CAN LEAD TO LOOSENING AND SUBSEQUENT BREAKAGE OF THE FASTENERS. Built 1994-02-01 to 1994-03-01.
Canada: Transport Canada, as of 2026-10-19
19991351999-07-26. Brakes. Certain four wheel drive vehicles may experience increased stopping distances during ABS stops while in the two-wheel drive mode. A switch can erroneously signal the ABS system that the vehicle is in four-wheel drive when the vehicle is actually in two wheel drive. Correction: Dealers will replace the switch on affected vehicles.
19971521997-09-08. Seats And Restraints. On certain vehicles, the driver's and/or passenger's front outboard seat-belt webbing could separate during a frontal impact having at least the same dynamics as a 48 kph frontal barrier collision. If a separation occurred and there were secondary crash events or rollover, there would be no restraint of the occupant and increased injuries could occur. Correction: A protector cover will be installed over the recliner mechanism.
19941131994-06-22. Structure. NOTE: 4-DOOR VEHICLES LOCATED IN BRITISH COLUMBIA, ALBERTA, ONTARIO AND QUEBEC. THESE VEHICLES MAY HAVE TRAILER HITCH ATTACHING BOLTS TIGHTENED BELOW THE SPECIFIED TORQUE. THIS COULD LEAD TO LOOSENING AND SUBSEQUENT BREAKAGE OF THE FASTENERS. IF THIS WERE TO OCCUR WHILE A TRAILER WAS BEING TOWED, THE HITCH AND TRAILER COULD SEPARATE FROM THE VEHICLE. CORRECTION: TRAILER HITCH BOLTS WILL BE TORQUED TO SPECIFICATION.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.