WenmarOpen by Wenmar Pro

Service bulletins for the 2017 Cadillac Escalade

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1446 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
PIT5404E2019-06-03. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a buffeting vibration and/or drone type noise, exhaust tone change, and/or body pressure booming. Replace or repair any of the issue that was found in the inspection. If the vehicle is equipped with a 4.3 liter or 5.3 liter engine an updated exhaust system is now available.
PIP5423B (1)2019-06-03. Service bulletin. ELECTRICAL SYSTEM; ENGINE. This Preliminary Information communication provides information to the technician about vehicles that may have a Service Engine Soon Malfunction Indicator Lamp on. Technician may find Diagnostic Trouble Codes P0106 and P0506. Technician will inspect for a broken valve spring and replace as needed.
PIP5423A2019-06-03. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician about vehicles that may have a Service Engine Soon Malfunction Indicator Lamp on. Technician may find Diagnostic Trouble Codes P0106 and P0506. Technician will inspect for a broken valve spring and replace as needed.
PIP4670F2019-06-03. Service bulletin. ENGINE; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles.
140604004E2019-05-20. Service bulletin. ENGINE. This informational bulletin explains the normal noises an engine may make when the ambient temperature outside is cold or the vehicle has sat for a few hours.
17NA1662019-05-20. Service bulletin. ENGINE; EQUIPMENT. This technical bulletin provides a procedure to measure vibration and install engine mounts to correct a Rough Idle in Drive concern.
070601016D2019-05-13. Service bulletin. ENGINE. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
000601012H2019-05-13. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. This informational bulletin advises the possible issues that may occur using a scotch brite pad or highly abrasive disk on gasket sealing surfaces or reused parts.
150601002H2019-04-22. Service bulletin. EQUIPMENT; ENGINE; EQUIPMENT ADAPTIVE/MOBILITY. This technical bulletin provides a procedure to repair the valve lifter oil manifold and/or lifters to correct the customers concern of engine misfire, ticking noise and/or MIL on.
19NA0442019-04-22. Service bulletin. ENGINE. This informational bulletin provides information on a normal engine operating condition for faster emission warm up time.
19NA0362019-04-22. Service bulletin. ENGINE. This Bulletin provides the technician with information on how to perform a oil consumption test and a procedure to replace the pistons if found the cause of the oil consumption.
16NA1112019-04-22. Service bulletin. ENGINE; EQUIPMENT. This informational bulletin provides diagnostic/inspection information for the air box and air filter seal to correct a MIL and DTCs P0420 and P0430 setting.
PIP5382J2019-04-08. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication advises the technician that generation 5 engines with Regular Production Option Code L83, L86, or LV3 may have an oil consumption concern were one quart in 2000 miles is being used. Dealer will confirm oil level was properly checked per Owner’s Manual, and check the bolt torque on the Valve Lifter Oil Manifold Assembly, before doing any repairs to the vehicle.
PIT5350A2019-04-08. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ENGINE. This Preliminary Information communication advises the technician that there have been some reports that the current engine hours are not correct and display 0.0. Technician will need to program the Instrument Panel Cluster using Service Programming System.
PIP5501B2019-04-08. Service bulletin. ELECTRICAL SYSTEM; ENGINE. This Preliminary information communicates Vehicles may be setting DTC P2101 falsely. In 2017 the K2XX introduced a “ Driver Door Open Prime ” (DDOP) feature that improves cold startability. The engineering investigation has determined that an intermittent pulse on the ECM RUN/CRANK input (during vehicle door unlock), initializes the Electronic Throttle Control (ETC) diagnostics that falsely sets P2101 when the DDOP occurs as the customer opens the driver door. Many of the reported P2101 failures show that the vehicle battery was in a reduced charge state (new dealer stock or extended radio operation with the engine off). Run the engine for 1 minute, soak the vehicle for 5 hours (required to re-initialize the DDOP) and verify that the P2101 does not reset. Return the vehicle to the customer
PIP5427B2019-04-08. Service bulletin. FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY:PRESSURE RELIEF DEVICES; ENGINE. This Preliminary Information communication provides information to the technician about vehicle that may have a Service Engine Soon Malfunction Indicator Lamp on. Technician may find Diagnostic Trouble Codes P2635, U0074 and or U18A2. Technician will need to follow published diagnostics for Diagnostic Trouble Codes U0074 would take priority over U18A2 if both set before addressing DTC P2635.
PIP3119P2019-04-08. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CATALYTIC CONVERTOR; ENGINE. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have a Service Engine Soon Malfunction Indicator Lamp on at low mileage. Technician may find Diagnostic Trouble Codes P0420 and or P0430 stored. Technician should be advised that the catalytic converter efficiency Diagnostic Trouble Codes P0420 and P0430 are disabled for the first hour of engine run time to allow break-in of the catalytic converter. Technician will need to use a Tech2 to check the verify engine run time on the Engine Hour Meter in the Instrument Panel Cluster Data Display/Data 1 List in the scan tool match. If the engine run time is less than one hour, the battery may have been disconnected, or another vehicle power loss event may have occurred, during vehicle manufacturing. Technician will need to clear the Diagnostic Trouble Codes and perform a drive cycle. If the catalytic converter was replaced and the Diagnostic Trouble Codes set it may be a result of the engine run time restrictions no longer being in place since the vehicle is no longer new. Technician will need to clear the Diagnostic Trouble Codes and perform a drive cycle.
16NA3392019-03-25. Service bulletin. ENGINE. This informational bulletin aids the technician on diagnosing possible vibrations in a vehicle, methods used for testing each scenario and documenting findings.
PIP5212B2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have run hot and or has a tick noise. Technician should inspect the head gaskets to ensure are not installed backwards. Technician should replace the head gasket if they are found installed backwards.
PIP5503A2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the dealer additional information on checking for the engne crankcase being overfull on oil causing an engine vibration concern. The technician is advised to inspect for contaminnants and adjust the engine oil level as needed.
PIP5540B2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIP5382K2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication advises the technician that generation 5 engines with Regular Production Option Code L83, L86, or LV3 may have an oil consumption concern were one quart in 2000 miles is being used. Dealer will confirm oil level was properly checked per Owner's Manual, and check the bolt torque on the Valve Lifter Oil Manifold Assembly, before doing any repairs to the vehicle.
PIP4925B2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. This preliminary information document communicates a tip on the way to diagnose possible induction or exhaust air leaks using the evaporative emission cart smoke machine and ultrasonic leak detector tools.
PIP5540D2019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIP56282019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates information that will need to be provided to TAC to aid in diagnosing if a vehicle comes in with misfire and DTC Codes P0300 - P0308 and/or P050D

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.