Recalls that may apply to the 1994 Buick Regal
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
By component
| 97V017000 | 1997-02-11. VISIBILITY:WINDSHIELD WIPER/WASHER:SWITCH/WIRING. SOME OF THESE VEHICLES HAVE A STRAINED OR SEPARATED WASHER/WIPER SWITCH POWER FEED WIRE. Built 1993-06-01 to 1994-08-31. |
|---|---|
| 95V152000 | 1995-08-08. EXTERIOR LIGHTING. INCORRECT CLEAR FRONT SIDE MARKER BULBS WERE INSTALLED RATHER THAN AMBER BULBS. THIS DOES NOT CONFORM TO THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." Built 1991-06-01 to 1995-02-01. |
| 95V061000 | 1995-03-22. SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS. THE REAR WHEEL BRAKE HOSE(S) CAN CONTACT THE REAR SUSPENSION COMPONENTS CAUSING THE BRAKE HOSE(S) TO WEAR THROUGH. Built 1993-06-01 to 1994-10-01. |
| 1997039 | 1997-02-18. Visual System. Certain vehicles may have a strained or separated washer/wiper power feed wire. This may cause the windshield washer/wiper to work intermittently and could ultimately result in inoperative wipers. This would result in reduced driver visibility during inclement weather conditions and a crash could occur. Correction: Windshield washer/wiper switch will be replaced with a redesigned switch. |
|---|---|
| 1995147 | 1995-08-04. Lights And Instruments. NOTE: INCLUDES COUPES ONLY AND DOES NOT INCLUDE 1993 REGAL GRAN SPORT. DEFECT: VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING EQUIPMENT. THESE VEHICLES WERE ASSEMBLED WITH INCORRECT FRONT SIDE-MARKER BULBS WHICH ARE CLEAR INSTEAD OF AMBER. DURING ILLUMINATION, THE BULBS WILL SHOW CLEAR RATHER THAN AMBER. CORRECTION: THE INCORRECT BULBS WILL BE REPLACED WITH THE CORRECT BULBS. |
| 1995051 | 1995-03-22. Brakes. On certain vehicles, the rear wheel brake hose(s) may be contacting rear suspension components. This could cause the brake hose(s) to wear through, resulting in loss of brake fluid and eventual loss of the braking system. This could result in increased stopping distances and a possible crash without prior warning. Correction: Vehicles will be inspected and brake hoses found in the incorrect position will be replaced with new hoses and correctly routed. |
A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.