Service bulletins for the 2020 BMW M2
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
55 on file from NHTSA, as of 2026-10-19.
By type
By component
Only bulletins with component: Engine are shown. Show all
| B110420 | 2020-12-21. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING:ENGINE; EQUIPMENT ADAPTIVE/MOBILITY. CONNECTING ROD BEARING: BMW AG has issued a Delivery Stop (effective November 20, 2020) on a small number of Model Year 2020-2021 BMW vehicles that were produced between May 15, 2019 and October 23, 2020. |
|---|---|
| B610520 | 2020-04-20. Service bulletin. ENGINE. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: This Service Information Bulletin (Revision 1) replaces SI B61 05 20 dated February 2020. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation. |
| B640416 | 2020-03-16. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS. Water Ingress In Footwell Area From A/C Condensate Drain: This Service Information Bulletin (Revision 1) replaces SI B64 04 16 dated March 2016. The condensate drain hose is blocked by the heat shield The condensate drain hose is not attached properly to the housing The condensate drain hose was damaged during installation |
| B111219 | 2020-02-18. Service bulletin. ENGINE AND ENGINE COOLING. MALFUNCTION INDICATOR LAMP IS ILLUMINATED WITH A CRANKSHAFT ADAPTION FAULT: When diagnosing an illuminated malfunction indicator lamp (MIL) and/or a different issue the following faults may also be stored in the Digital Motor Electronics (DME). Fault code Control module Fault code text 213A2B DME Increment wheel adaption faulty This situation is not associated with any drivability complaints and only affects vehicles built with a Factory I-level of 19-07-500 and later. An unfavorable DME diagnostic calibration may cause the fault code to be stored. In most circumstances this will cause the MIL to be illuminated. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.