WenmarOpen by Wenmar Pro

Service bulletins for the 2020 BMW 530e

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

247 on file from NHTSA, as of 2026-10-19.

By type

By component

Bulletins, newest first
B6105202020-04-20. Service bulletin. ENGINE. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: This Service Information Bulletin (Revision 1) replaces SI B61 05 20 dated February 2020. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B6103202020-04-20. Service bulletin. STRUCTURE; EXTERIOR LIGHTING. MIL MAY BE ILLUMINATED BY ERRONEOUS FAULT IN THE DME: The customer states that the malfunction indicator lamp (MIL) is illuminated. During diagnosis fault code 231507 "BDC RESET by watchdog" stored in the DME. CAUSE Software error in the Body Domain Control (BDC) unit.
B5130162020-04-20. Service bulletin. AIR BAGS; PARKING BRAKE. TAILGATE UNINTENTIONALLY OPENS: This Service Information Bulletin (Revision 4) replaces SI B51 30 16 dated March 2018. Trunk/tailgate may open when vehicle is locked Trunk/tailgate may open while the vehicle is in motion usually after stopping such as a traffic light etc. Vehicle key trunk/tailgate button may be accidentally pressed thus opening the tailgate.
B5108202020-04-20. Service bulletin. VEHICLE SPEED CONTROL; STRUCTURE:BODY:DOOR:HINGE AND ATTACHMENTS; BACK OVER PREVENTION. GROANING OR CRACKING NOISE WHEN OPENING OR CLOSING THE DOORS: A groaning or cracking sound is present when opening and/or closing any of the doors. Interference between the door panel and door.
B3405172020-04-20. Service bulletin. BACK OVER PREVENTION; SERVICE BRAKES, HYDRAULIC; WHEELS; POWER TRAIN. TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs.
B1706172020-04-20. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. COOLANT LEAK FROM LOW TEMPERATURE COOLING CIRCUIT (N63R): This Service Information Bulletin (Revision 5) replaces SI B17 06 17 dated June 2019. Traces of coolant leaking from the expansion tank of the low temperature cooling system. Coolant in the low temperature cooling circuit may also have an acrid smell and discoloration (1). Aluminum corrosion in the charge air intercoolers or in the radiator for the low temperature cooling is causing an unfavorable chemical reaction to the coolant.
B1213182020-04-20. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. DME FC 21A02D - COMBUSTION CONTROL: VALVE LIFT AT IDLE This Service Information Bulletin (Revision 3) replaces SI B12 13 18 dated September 2019. The vehicle will run rough or hesitate when accelerating from a stationary position.
B6105202020-03-16. Service bulletin. ELECTRICAL SYSTEM. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER. A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B1101202020-03-16. Service bulletin. ENGINE AND ENGINE COOLING. ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing (1).
B8402202020-02-18. Service bulletin. ELECTRICAL SYSTEM. REMOTE 3D VIEW NOT AVAILABLE: Remote 3D View cannot be launched In the BMW ConnectedDrive App. Software error in the Advanced Telematics Module 2 (ATM2).
B8401202020-02-18. Service bulletin. ELECTRICAL SYSTEM. BMW CONNECTEDDRIVE SERVICES ARE NOT AVAILABLE: The BMW ConnectedDrive services are not available for an extended period. This may include: Calls in the BMW Assistance app (Concierge Service) Vehicle data and status in the BMW ConnectedDrive app Remote services Remote 3D View Real Time Traffic Information (RTTI) Weather News Software error in Advanced Telematics Module 2 (ATM2).
B6620172020-02-18. Service bulletin. EQUIPMENT. DISPLAY KEY IS NON-FUNCTIONAL: This Service Information Bulletin (Revision 3) replaces SI B66 20 17 dated October 2019. The display key is non-functional. Display Key cannot be charged or switched on. An incorrect vehicle model appears on the key display. Possible defective display key battery or display key.
B6608172020-02-18. Service bulletin. BACK OVER PREVENTION; ELECTRICAL SYSTEM:SOFTWARE. REAR VIEW CAMERA FAILS TO DISPLAY IMAGE: This Service Information Bulletin (Revision 5) replaces SI B66 08 17 dated March 2018. Sporadically when the rear view camera is activated no image appears in the display. The rear view camera can be activated by either: 1. Selecting reverse with the shift selector 2. Camera activation via the button on the center console Camera function returns after a terminal change. Note: This error situation can rarely if ever be duplicated on demand. Head-unit interface software start-up synchronization error for the rear view camera.
B6505202020-02-18. Service bulletin. AIR BAGS; ELECTRICAL SYSTEM:SOFTWARE. FAULT 930C1E IS FOUND IN THE ACSM: Vehicle comes into the workshop with the following illuminated: Check Engine Light DSC warning lamp Air bag warning lamps During diagnosis the following fault code is found stored in the ASCM (Advanced Crash Safety Module): 930C1E internal ECU error If the fault is cleared it returns immediately. The root cause is under investigation.
B1204192020-02-18. Service bulletin. ENGINE AND ENGINE COOLING. DME FAULT MEMORY ENTRY FOR THE CRANKSHAFT SENSOR: This Service Information Bulletin (Revision 1) replaces SI B12 04 19 dated February 2019. Technicians may notice this fault logged during a diagnostic session: Fault code: Control module: Fault Text: 160021 DME Crankshaft sensor: general loss of synchronism Environmental conditions are vehicle speed 0 (stationary) and engine speed less than 1500 rpm. There is no customer-facing symptom nor related check control message displayed. Phantom/pseudo fault due to unsuitable DME software. Background: After parking the vehicle and turning off the engine both DME control units go into sleep mode at different times. The DME of cylinder bank 2 ("secondary") goes into sleep mode first The DME of cylinder bank 1 ("primary") is still awake and can experience a reduction in signal voltage for the crankshaft sensor signal This signal change can mistakenly be evaluated as a skipped crankshaft sensor cog by the DME. If the engine is started while the primary DME is still awake this causes a brief loss of synchronization with the secondary DME. Fault 160021 is logged after three (3) consecutive engine starts with this momentary loss of synchronization. Note: Starting the engine after the primary DME has also gone into sleep mode will avoid the loss of synchronization.
B1112192020-02-18. Service bulletin. ENGINE AND ENGINE COOLING. MALFUNCTION INDICATOR LAMP IS ILLUMINATED WITH A CRANKSHAFT ADAPTION FAULT: When diagnosing an illuminated malfunction indicator lamp (MIL) and/or a different issue the following faults may also be stored in the Digital Motor Electronics (DME). Fault code Control module Fault code text 213A2B DME Increment wheel adaption faulty This situation is not associated with any drivability complaints and only affects vehicles built with a Factory I-level of 19-07-500 and later. An unfavorable DME diagnostic calibration may cause the fault code to be stored. In most circumstances this will cause the MIL to be illuminated.
B6210192020-01-21. Service bulletin. SERVICE BRAKES. INCORRECT CONDITION BASED SERVICE DATA FOR BRAKE FLUID SERVICE. "Brake fluid service due since 12/2001" is displayed in the instrument cluster although the vehicle is only a maximum of 1 year old. Software error in the KOMBI (Instrument Cluster).
B6209192020-01-21. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. INSTRUMENT CLUSTER REMAINS DARK AFTER STARTING THE VEHICLE: Instrument cluster remains dark after starting the vehicle. After a restart normal functionality is restored. Software error in the KOMBI (Instrument Cluster).
B6123192020-01-21. Service bulletin. ELECTRICAL SYSTEM. G30e WITH INDUCTIVE CHARGING: BMW is conducting a limited field test of an inductive HV charging system to learn more about customer's acceptance of such a "state of the art" technology. A small sample of 200 G30e 530e iPerformance vehicles has been retailed to customers in the San Francisco and Los Angeles areas. The customer may complain that there is an issue with the wireless charging system.
B5113192020-01-21. Service bulletin. LATCHES/LOCKS/LINKAGES. DOOR LATCHING COMPLAINTS IN COLD WEATHER: Below freezing ambient temperatures: One or more doors (front or rear) may not open when attempting to enter or After opening they may not correctly latch A leaking seal on the outer Bowden release cable may allow water to enter the cable sheathing and freeze.
B1203192020-01-21. Service bulletin. ELECTRICAL SYSTEM. ENGINE DOES NOT START BELOW FREEZING TEMPERATURES: Engine designation correction Parts availability Warranty. The engine will not start at temperatures below freezing. The starter does not turn and engage.
B1108192020-01-21. Service bulletin. FUEL SYSTEM, DIESEL; ENGINE. B57 DIESEL ENGINE - CHECK CONTROL MESSAGE OIL LEVEL TOO HIGH. Check Control Message (CCM) "Engine oil level too high" is displayed. Fuel dilution into the engine oil due to the diesel particulate filter (DPF) regeneration strategy.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.