WenmarOpen by Wenmar Pro

Service bulletins for the 2014 BMW 428i

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

422 on file from NHTSA, as of 2026-10-19.

By type

By component

Bulletins, newest first
B6104192020-07-27. Service bulletin. ELECTRICAL SYSTEM. VEHICLE DOES NOT START BATTERY TOTALLY DISCHARGED: The customer's vehicle does not start due to a totally discharged battery.
B0126182020-07-27. Service bulletin. STEERING:ELECTRIC POWER ASSIST SYSTEM; POWER TRAIN. EPS STEERING ELECTRIC MOTOR MOUNTING BOLTS LIMITED WARRANTY EXTENSION: There are front end noises when turning the steering wheel and/or there is limited power steering assist when maneuvering or parking the vehicle. For the basic steering gears, one possible cause is that the mounting bolts for the electric motor may become loose, missing and/or broken due to corrosion.
B6105202020-06-15. Service bulletin. ELECTRICAL SYSTEM. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B1304202020-06-15. Service bulletin. ENGINE AND ENGINE COOLING. TANK VENTILATION AND MIXTURE CONTROL FAULTS STORED IN THE DME: The Engine Malfunction Warning is illuminated and one or more of the following faults are stored in the DME. All models: FC 191C02 - Fuel tank ventilation system 2nd discharge point: malfunction FC 195014 - Differential pressure sensor tank vent valve signal: fixed FC 118001 - Mixture control: mixture too lean FC 118401 - Mixture control: mixture too lean large deviation I01 only: FC 124103 - Mixture control: mixture too lean FC 124101 - Mixture control: Mixture lean large deviation CAUSE Internal mechanical defect in the tank ventilation valve. The defect can also result in a very loud clicking noise when the valve is cycling.
B1101202020-06-15. Service bulletin. ENGINE. B58C AND B58M ENGINES ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing.
B0126182020-06-15. Service bulletin. WHEELS; PARKING BRAKE; POWER TRAIN; ENGINE AND ENGINE COOLING; STEERING. EPS STEERING ELECTRIC MOTOR MOUNTING BOLTS - LTD WTY EXT TO 10 YRS/120000 MILES: There are front end noises when turning the steering wheel and/or there is limited power steering assist when maneuvering or parking the vehicle. For the basic steering gears one possible cause is that the mounting bolts for the electric motor may become loose missing and/or broken due to corrosion.
B8402142020-04-27. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT ADAPTIVE/MOBILITY. CONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.
B6522142020-04-20. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). AUTOMATED ACTIVATION OF NAVIGATION SYSTEM DURING PDI/QC1: This Service Information Bulletin (Revision 2) replaces SI B65 22 14 dated October 2015. The INITIAL NAV enabling code no longer needs to be pre-ordered through the Parts department! When the vehicle is connected to the diagnostic system ISTA to perform PDI/QC1 the step to activate the navigation system (part of Delete Transport Mode) will automatically request the INITIAL NAV enabling code (VIN-specific) without pre-ordering the enabling code. This enabling code will be automatically delivered through ISTA and it then activates the navigation system.
B6105202020-04-20. Service bulletin. ENGINE. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER: This Service Information Bulletin (Revision 1) replaces SI B61 05 20 dated February 2020. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B5130162020-04-20. Service bulletin. AIR BAGS; PARKING BRAKE. TAILGATE UNINTENTIONALLY OPENS: This Service Information Bulletin (Revision 4) replaces SI B51 30 16 dated March 2018. Trunk/tailgate may open when vehicle is locked Trunk/tailgate may open while the vehicle is in motion usually after stopping such as a traffic light etc. Vehicle key trunk/tailgate button may be accidentally pressed thus opening the tailgate.
B3405172020-04-20. Service bulletin. BACK OVER PREVENTION; SERVICE BRAKES, HYDRAULIC; WHEELS; POWER TRAIN. TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs.
B1213182020-04-20. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. DME FC 21A02D - COMBUSTION CONTROL: VALVE LIFT AT IDLE This Service Information Bulletin (Revision 3) replaces SI B12 13 18 dated September 2019. The vehicle will run rough or hesitate when accelerating from a stationary position.
B6105202020-03-16. Service bulletin. ELECTRICAL SYSTEM. CCM DISPLAYED "INCREASED BATTERY DRAIN" CAUSED BY CONTROLLER. A yellow CCM (Check Control Message) ID 415 is displayed- "Increased battery drain! // Battery. Electrostatic discharge at standstill / start engine. Energy management" The results of the Energy Diagnosis test plan identifies the Controller as the root cause of the CCM. The Controller delays the vehicle going to sleep by up to 6 minutes. In some cases this will cause the CCM 415 to be displayed when starting the vehicle. Replacing the Controller in this case will not correct this situation.
B1233142020-03-16. Service bulletin. ENGINE AND ENGINE COOLING. Fault Code 1D2008 Stored in DME: This Service Information Bulletin (Revision 5) replaces SI B12 33 14 dated February 2016. The Service Engine Soon light is on. There may also be a complaint of low heat output with lower outside temperatures. CAUSE During the engine warm-up the engine coolant does not reach operating temperature within the DME's allowable time limits. This is caused by either a faulty thermostat inside the transmission oil heat exchanger or a faulty engine characteristic map thermostat.
B1101202020-03-16. Service bulletin. ENGINE AND ENGINE COOLING. ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing (1).
B8404162020-02-18. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. SOS MALFUNCTION DISPLAYED This Service Information Bulletin (Revision 1) replaces SI B84 04 16 dated September 2016. One or all the following may be experienced in the vehicle: An SOS malfunction is seen in the Kombi (aka instrument cluster) When pressing the E-Call/SOS button in the overhead console nothing happens Fault code B7F33C (internal ECU error) is stored in the Telematics control unit (ATM/TCB2) There are 2 known causes for this failure. They are as follows: Software file missing from the ATM/TCB2 control module Water leak at the "shark fin" roof antenna (aka roof aerial) leading to corrosion in the ATM/TCB2 control module.
B1203192020-01-21. Service bulletin. ELECTRICAL SYSTEM. ENGINE DOES NOT START BELOW FREEZING TEMPERATURES: Engine designation correction Parts availability Warranty. The engine will not start at temperatures below freezing. The starter does not turn and engage.
B6526172019-12-16. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; EQUIPMENT:ELECTRICAL. NBT EVO CHANGES BETWEEN SELECTIONS BY ITSELF WITHOUT DRIVER INPUT- GHOST BEHAVIOR: The Central Information Display (CID) changes between selections ("ghost behavior") and sounds an audio tone without the CID Screen being touched. The audio tone is the same one that sounds when you touch the CID with your finger to make a 'touch' selection.
B6521192019-12-16. Service bulletin. EQUIPMENT:ELECTRICAL; EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT. AUDIO PLAYBACK NOT POSSIBLE: No audio heard inside the vehicle. Failure of the audio amplifier due to water ingress in the luggage compartment.
B6123152019-12-16. Service bulletin. EQUIPMENT; VISIBILITY:WINDSHIELD WIPER/WASHER. Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full : The low washer fluid warning is illuminated even though the washer fluid reservoir is full. There are no faults stored in the system for the washer fluid level switch. A non-approved washer fluid was used that is silicone-based. Silicone-based fluids are not compatible with the contactless capacitive level sensor. Fluids that contain a silicone additive are normally colored other than blue.
B6514192019-10-21. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ELECTRICAL SYSTEM:12V/24V/48V BATTERY. HEAD UNIT NBT EVO (HU-H2) PROGRAMMING ABORT: The CID screen may light up blue. When this occurs A battery reset is not successful in restoring head unit operation Software error in the Bootloader file (BTLD) of the head unit.
B3208192019-10-21. Service bulletin. STEERING:GEAR BOX (OTHER THAN RACK AND PINION). THUMPING NOISE FROM FRONT AXLE WHILE STEERING: A "thumping" noise is heard from the front axle area during slow speed steering.
B3105142019-10-21. Service bulletin. SUSPENSION. Front Suspension Ride Height Has Dropped: The front suspension ride height has dropped on one or both sides due to overload. This is caused by driving over obstacles (e.g. potholes) or an impact severe enough for the front spring strut damper to slip through the clamp of the steering knuckle.
B0126182019-10-21. Service bulletin. STEERING. EPS STEERING GEAR FOR CERTAIN VEHICLES: ELECTRIC MOTOR MOUNTING BOLTS - LIMITED WARRANTY EXTENSION TO 10 YEARS/120000 MILEAGE.
B3208182019-09-23. Service bulletin. STEERING. SERVICE ACTION: REWORK THE STEERING GEAR. Screws attaching the power pack to the steering gear may be broken. Broken screws result in noises during steering motions and variable steering assistance. A Check Control Message (CCM) may be displayed.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.