WenmarOpen by Wenmar Pro

Recalls that may apply to the 2010 BMW 328i

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

Only campaigns about Engine are shown.

United States: NHTSA, as of 2026-10-19
None found.
Canada: Transport Canada, as of 2026-10-19
20235682023-10-20. Engine. Issue: On certain vehicles, the variable camshaft timing (VANOS) adjustment unit housing bolts could loosen or break. As a result, the camshaft could become incorrectly adjusted and cause the engine to enter a reduced power mode (limp mode) or to stall while driving. Safety Risk: A sudden loss of engine power could increase the risk of a crash. Corrective Actions: BMW will notify owners by mail and advise you to take your vehicle to a dealership to replace the VANOS bolts.
20220952022-03-02. Engine. Issue: On certain vehicles equipped with an N52 or N52K 6-cylinder engine, a manufacturing problem could cause the PCV valve heater (blow-by heater) to short circuit and overheat. Note: This replaces Transport Canada recalls 2017-470 and 2019-170. Only vehicles equipped with an N52 or N52K engine require this repair. Safety Risk: An overheated engine PCV valve heater could create the risk of a fire, even while the vehicle is parked and turned off. Corrective Actions: BMW will notify owners by mail and instruct you to take your vehicle to a dealer to install a wire harness repair kit. BMW recommends that you should park your vehicle outdoors until the recall repairs have been completed.
20174702017-09-28. Engine. On certain vehicles equipped with the N52 6-cylinder engine, an electrical short could occur in the PCV valve heater due to manufacturing irregularities. If this occurs, the surrounding plastics could overheat, melt and potentially cause a fire, which could increase the risk of injury and/or damage to property. Correction: Dealers will replace the PCV valve heater.
20141702014-05-13. Engine. On certain vehicles, housing bolts for the variable camshaft timing system could break, allowing camshaft timing to deviate. If this occurs, the engine would revert to "limp home mode", limiting available engine power. In rare instances the engine could stall, increasing the risk of a collision causing injury and/or damage to property. Correction: Dealers will replace housing bolts that break and perform associated repairs for 10 years/unlimited mileage from the vehicle's in-service date. Note: This applies only to vehicles not covered by recall 2014-127.
20141272014-04-10. Engine. On certain vehicles, housing bolts for the variable camshaft timing system could break, allowing camshaft timing to deviate. If this occurs, the engine would revert to "limp home mode", limiting available engine power. This could increase the risk of a collision causing injury and/or damage to property. Correction: Dealers will replace affected bolts.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.