Service bulletins for the 2022 Bentley Flying Spur
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
657 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Lighting are shown. Show all
| 2066480.3 | 2022-12-07. Service bulletin. VISIBILITY; EXTERIOR LIGHTING; ELECTRICAL SYSTEM. Headlamp Switch not working/illuminated - Numerous DTCs within 0009 - Central Electrics (BCM1) Customer Statement: -Headlamp switch not working/not illuminated when the ignition is switched on (following an ignition switch off) and/or -Yellow warning light/message within DIP (Adaptive lighting fault) and/or -Loss of rear fog light activation and/or -Loss of all-weather lighting mode activation and/or -Headlamps will default to dipped beam (however, high beam activation will still be possible manually) |
|---|---|
| 2061857.5 | 2022-12-07. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Headlamp switch - Inoperative/Not illuminated - DTC U110B00 within 09-Central Electrics (BCM1) Customer Statement: -Headlamp switch -Inoperative/Not Illuminated Workshop findings: -DTC U110B00 within 09-Central Electrics (BCM1) as shown in figure 1 |
| 2051511.8 | 2022-12-07. Service bulletin. ELECTRICAL SYSTEM; INTERIOR LIGHTING. Mood Lighting Customer Statement: -Mood lighting strip fixed on one colour regardless of which colour scheme is selected or not illuminated at all. |
| 2066480/2 | 2022-10-01. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING; ENGINE AND ENGINE COOLING. Headlamp Switch Not Working/Not Illuminated - Numerous DTCs within 0009 - Central Electrics (BCM1) Technical Background: -The condition will not occur when the ignition is on or whilst the vehicle is being driven -The condition only occurs as the headlamp switch goes into a "Sleep" state after the ignition is switched off -The condition is evident to the driver when the ignition is next switched on |
| 2066480/1 | 2022-07-08. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Headlamp switch not working/not illuminated - Numerous DTCs within 0009-Central Electrics (BCM1). Customer statement / workshop findings Customer statement: - Headlamp switch not working/not illuminated when the ignition is switched on (following an ignition switch off) And/or - Yellow warning light/message within DIP (Adaptive lighting fault) And/or - Loss of rear fog light activation And/or - Loss of all-weather lighting mode activation And/or - Headlamps will default to dipped beam (however, high beam activation will still be possible manually) Workshop findings: The following DTCs may also be evident within 0009 - Central Electrics control module U110B00 - Light switch no communication And/or B126A29 - Light switch signal not reliable And/or U1122300 - Fault value received by data bus Technical background - The condition will not occur when the ignition is on or whilst the vehicle is being driven - The condition only occurs as the headlamp switch goes into a Sleep state after the ignition is switched off - The condition is evident to the driver when the ignition is next switched on In the event the afore mentioned symptoms are evident please carry out the instructions within the Measure section |
| 2063777/3 | 2022-06-03. Service bulletin. EXTERIOR LIGHTING; ELECTRICAL SYSTEM. DTC's C119813 Low beam light bulb open circuit or C1198FA Low beam light bulb short circuit evident in D6 and/or D7. Condition: Customer statement: Headlamp low beam not functioning and/or warning within the DIP Workshop findings: DTCs C119813 Low beam light bulb open circuit active/static and/or C1198FA Low beam light bulb short circuit active/static logged within diagnostic address D6 (light control left) and/or D7 (light control right) Technical Background: The DTCs once triggered are unable to be cleared, with the DTCs logged the Headlamp low beam will not operate. In the event the symptoms are as described, conduct the instructions within the Measure section to completion noting the following: - The update to address D6 Must be done first followed by the update to address D7 - Regardless of the DTC which is evident or the address in which the DTC/DTCs are evident, both SVM codes MUST be applied IMPORTANT: There are separate SVM codes for each diagnostic address D6 (light control left) - 371D6HHZDC (MUST BE APPLIED FIRST) D7 (light control right) - 371D7HKZDC (MUST BE APPLIED SECOND) |
| 2066236/1 | 2022-04-06. Service bulletin. EXTERIOR LIGHTING; ELECTRICAL SYSTEM. Unintended sounding of the Alarm siren - Following activation of the ignition or whilst the vehicle is left standing. Customer statement / workshop findings: Unintended sounding of the alarm siren following activation of the ignition Or Unintended sounding of the alarm siren whilst the vehicle is left standing Workshop findings. The following DTCs could also be evident within diagnostic address 0046 and/or 00BB and/or 00BC - B131DF5: alarm system siren supply voltage lower limit value less than - B131D29: sirens / alarm horn for anti-theft warning system Range/Performance - B131D29: anti-theft alarm system siren / alarm horn signal, not valid Technical background: In the event the symptom(s) described are evident, please refer to the instructions within the Measure section of this TPI |
| 2064708/1 | 2021-11-05. Service bulletin. EXTERIOR LIGHTING:LIGHTING CONTROL MODULE:SOFTWARE; EQUIPMENT; ELECTRICAL SYSTEM. Customer statement / workshop findings: Unable to set the passenger side exterior mirror memory when reversing (as per the instructions within the owner handbook). Production change: Owner handbooks for later vehicles/models will be revised. Amended owner handbooks or addendums will not be available for this particular issue. |
| 2054599/7 | 2021-10-07. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Headlamp operation issues Condition: Headlamp operation issues. Technical Background: DTCs evident within the left light control unit (Diagnostic address D6) and/or the right light control unit (Diagnostic address D7) There are numerous static and intermittent DTCs which may be evident within the previously mentioned control units, ensure all steps within the Measure section are strictly adhered to. |
| 2054599/8 | 2021-10-07. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Customer statement / workshop findings: Headlamp operation issues Technical background: DTCs evident within the left light control unit (Diagnostic address D6) and/or the right light control unit (Diagnostic address D7) There are numerous static and intermittent DTCs which maybe evident within the previously mentioned control units, ensure all steps within the Measure section are strictly adhered to New Flying Spur (20 - 22 M/Y) and Bentayga (21 - 22 M/Y). In the event that DTCs C119813 Low beam light bulb open circuit or C1198FA Low beam light bulb short circuit are evident in D6 and/or D7. Please refer to and conduct the instructions within the following TPIs New Flying spur - TPI 2063777/- Bentayga applicable to 21 and 22 M/Y only - 2064497/-. For any other issues please refer to the instructions within the Measure section of this TPI. |
| 2059246/3 | 2021-10-06. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. Buzzing/vibration from the left and/or right headlamp and/or DTC's C119C01-C119D01 stored - Matrix beam headlamp only Customer statement: Buzzing noise may be evident from the left and/or right headlamp Workshop findings The following DTCs may also be evident in 00D6 Light control left 2 (Matrix beam) and/or 00D7 Light control right 2 (Matrix beam) C119C01 Fan for headlamp electrical error C119D01 Fan 2 for headlamp electrical error Technical background: Wiring harness routed incorrectly within the headlamp module at the rear of the headlamp, the noise and DTCs are evident due to the harness contacting the headlamp cooling fan |
| 2063777/2 | 2021-10-06. Service bulletin. EXTERIOR LIGHTING; ELECTRICAL SYSTEM. DTC's C119813 Low beam light bulb open circuit or C1198FA Low beam light bulb short circuit evident in D6 and/or D7 Customer statement: Headlamp low beam not functioning and/or warning within the DIP Workshop findings: DTCs C119813 Low beam light bulb open circuit active/static and/or C1198FA Low beam light bulb short circuit active/static logged within diagnostic address D6 (light control left) and/or D7 (light control right) |
| 2050542/5 | 2021-10-05. Service bulletin. EXTERIOR LIGHTING:FOG LIGHTS; EXTERIOR LIGHTING; EQUIPMENT. Service info: body/equipment: front exterior lighting steamed up/leaks. Customer statement / workshop findings Customer statement: 1. The lenses of the headlights (illustration 1a) /front fog lamps (illustration 1b) are steamed up/damp from the inside with minor drips. or 2. Water is in the headlight (illustration 2a) / front fog lamp (illustration 2b), big drips. Technical background 1. Damp air settles on the inner lens of the headlights/fog lamps, with recognisable misting in certain weather conditions (comparable with the steaming up of spectacle lenses when entering a warm room in winter or of the bathroom mirror after a shower). 2. Leak on the headlights/front fog lamps. For example through open covers, a damaged seal of the cap or similar. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.