Service bulletins for the 2020 Bentley Continental
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
905 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Body and frame are shown. Show all
| 2060120/2 | 2020-11-06. Service bulletin. EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY; STRUCTURE; LATCHES/LOCKS/LINKAGES:HOOD:LATCH. Convertible hood cannot close - Temporary repair solution - Header trim flap eyelet broken. Customer statement/workshop findings: Convertible hood cannot close/latch due to a broken eyelet. The eyelet is part of the header trim flap (Figure 1) Technical background: CAUTION: The Operative MUST ensure that all interior/exterior trim assemblies are suitably protected. Warranty payments will not be considered under any circumstances for any damage Option 1 - Manually assist the flap to allow the hood to fully close and latch as shown in the video within the Bentley Hub reference TPI 2060120/- Great care must be taken when conducting the manual assist procedure |
|---|---|
| 2059333/2 | 2020-11-05. Service bulletin. STRUCTURE:BODY:DOOR; ELECTRICAL SYSTEM; LATCHES/LOCKS/LINKAGES. Unable to open, or delay in opening the Drivers or Front passenger door from outside using the door handle (Keyless). Customer statement / workshop findings: Unable to open, or a delay in opening the driver or passenger front door from the outside of the vehicle when using the door handle (keyless entry) Technical background: In the event there is a customer complaint regarding the opening of the door from the outside of the vehicle when using the door handle (Keyless entry) please refer to the Measure section of this TPI |
| 2051526/5 | 2020-11-04. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; STRUCTURE. Rotating screen alignment. Customer statement / workshop findings: The chrome brightware strip on the veneer face fascia panel of the Bentley Rotating Display (BRD) may appear to be misaligned with the chrome strips on the passenger and drivers side fascia panels. In addition, the gapping and fit between the veneer face fascia panel of the BRD and the passenger and drivers side fascia panels may differ from one side to the other. Technical background: The chrome brightware strip is fixed to the veneer face fascia panel with no separate adjustment and as such can appear to be misaligned. The veneer face fascia panel relies on fixed location pins that may be out of tolerance. Rework the veneer face fascia panel to align the chrome brightware strip and/or the gapping between the BRD and the passenger and drivers side fascia panels. |
| 2052394/9 | 2020-11-03. Service bulletin. LATCHES/LOCKS/LINKAGES; STRUCTURE:BODY:DOOR. New Continental GT - New Continental GTC and Bentayga Driver/Passenger door power latch creak on close |
| 2060646/1 | 2020-10-08. Service bulletin. STRUCTURE; LATCHES/LOCKS/LINKAGES; ELECTRICAL SYSTEM. New Continental GTC - Boot open/close function inoperative. Customer statement / workshop findings Boot operational issues for example: The boot does not open or close as expected Technical background VERY IMPORTANT: Please ensure all VIN applicable TPIs and VIN applicable Service Campaigns are checked and conducted prior to conducting the instructions within this TPI NOTE: The operative MUST submit the following information to a new DISS query or an existing query relating to boot operational issues -Completed check list -Images of the vehicle condition - In particular the boot area (Ensure license plate and VIN details are not visible) -Video of the failure NOTE: Please capture the rear of the vehicle for at least one open/close operation (when possible) before zooming or moving in closer to the issue, the video MUST be recorded in a quiet environment Battery health - Print out of the results NOTE: Please ensure any other findings or issues relating to the boot are clearly described within the DISS query |
| 2055580/3 | 2020-10-08. Service bulletin. SUSPENSION; EQUIPMENT; ELECTRICAL SYSTEM; STRUCTURE. Rotating Display - Fault Diagnosis. Customer statement / workshop findings Various rotating display operational complaints or noises. Technical background: Follow the measure section of this TPI that relates to your customer complaint. |
| 2060652/1 | 2020-10-08. Service bulletin. LATCHES/LOCKS/LINKAGES; STRUCTURE. New Continental GT - Boot open/close function inoperative. Customer statement / workshop findings: Boot operational issues for example: -The boot does not open or close as expected Technical background VERY IMPORTANT: Please ensure all VIN applicable TPIs and VIN applicable Service Campaigns are checked and conducted prior to conducting the instructions within this TPI NOTE: The operative MUST submit the following information to a new DISS query or an existing query relating to boot operational issues -Completed check list -Images of the vehicle condition - In particular the boot area (Ensure license plate and VIN details are not visible) -Video of the failure NOTE: Please capture the rear of the vehicle for at least one open/close operation (when possible) before zooming or moving in closer to the issue, the video MUST be recorded in a quiet environment -Battery health - Print out of the results NOTE: Please ensure any other findings or issues relating to the boot are clearly described within the DISS query |
| 2060120/1 | 2020-08-08. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; STRUCTURE:BODY:HOOD. Convertible hood cannot close - Temporary repair solution - Header trim flap eyelet broken. Customer statement/workshop findings: Convertible hood cannot close/latch due to a broken eyelet. The eyelet is part of the header trim flap (Figure 1). Technical background: CAUTION: The Operative MUST ensure that all interior/exterior trim assemblies are suitably protected. Warranty payments will not be considered under any circumstances for any damage Option 1 - Manually assist the flap to allow the hood to fully close and latch as shown in the video within the Bentley Hub reference TPI 2060120/- |
| 2057841/2 | 2020-08-05. Service bulletin. STRUCTURE. Windscreen replacement criteria whilst under manufacturers warranty. Customer statement / workshop findings: Windscreen cracked/damaged Technical background: Please refer to the instructions within the Measure section of this TPI in the event that a windscreen is cracked/damaged |
| 2056582/3 | 2020-08-05. Service bulletin. STRUCTURE. Interior trim - Creak and rattle - Noise identification. Customer statement / workshop findings: Noise complaint from the interior Workshop findings: The noise can be reproduced and clearly assigned to the interior Prior to starting the instructions within this TPI, the Retailer must check and confirm the vehicle is in standard factory condition and has not had any non-approved aftermarket modifications conducted Should any aftermarket modifications be found, the Retailer must make Product Support aware by raising a DISS query to report the details of the modification, you must then await feedback from Product Support before conducting any further work |
| 2059333/1 | 2020-06-04. Service bulletin. STRUCTURE; LATCHES/LOCKS/LINKAGES; ELECTRICAL SYSTEM. Unable to open, or delay in opening the Driver's or Front passenger door from outside using the door handle (Keyless) Condition: Unable to open, or a delay in opening the driver or passenger front door from the outside of the vehicle when using the door handle (keyless entry) Technical Background: In the event there is a customer complaint regarding the opening of the door from the outside of the vehicle when using the door handle (Keyless entry) please refer to the Measure section of this TPI |
| 2059179/1 | 2020-06-04. Service bulletin. EQUIPMENT:OTHER:LABELS; STRUCTURE; EQUIPMENT. Vehicle emission control information label - Emission service action (SC20/10) Technical background: Incorrect vehicle emission control information label fitted to a small number of vehicles (Figure 1) Remedy: Label replacement must be conducted on all VIN affected vehicles DO NOT remove the old label until the new label is available to be fitted as per the Identification section, the application of the new label must be conducted by an authorised Bentley repair centre. |
| 2058424/3 | 2020-05-06. Service bulletin. STRUCTURE; VISIBILITY; ELECTRICAL SYSTEM. New Continental GT and New Continental GTC - Rear quarter glass not fully closing. Customer statement/workshop findings Referring to Figure 1 - During the window and/or door close operation, the front door drop glass closes and seals (Point A) however the rear quarter glass does not fully close and seal (Point B) leaving a gap between the front and rear glass (Point C). |
| 2058424/2 | 2020-05-06. Service bulletin. STRUCTURE:BODY:DOOR; VISIBILITY. New Continental GT and New Continental GTC - Rear quarter glass not fully closing. Customer statement / workshop findings: Referring to Figure 1 - During the window and/or door close operation, the front door drop glass closes and seals (Point A) however the rear quarter glass does not fully close and seal (Point B) leaving a gap between the front and rear glass (Point C). Technical background: Refer to the Measure section of this TPI |
| 2051526/4 | 2020-04-03. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM. Rotating screen alignment Customer statement / workshop findings The chrome brightware strip on the veneer face fascia panel of the Bentley Rotating Display (BRD) may appear to be misaligned with the chrome strips on the passenger and drivers side fascia panels. In addition, the gapping and fit between the veneer face fascia panel of the BRD and the passenger and drivers side fascia panels may differ from one side to the other. Technical background The chrome brightware strip is fixed to the veneer face fascia panel with no separate adjustment and as such can appear to be misaligned. The veneer face fascia panel relies on fixed location pins that may be out of tolerance. Rework the veneer face fascia panel to align the chrome brightware strip and/or the gapping between the BRD and the passenger and drivers side fascia panels. |
| 2052634/6 | 2020-03-04. Service bulletin. STRUCTURE; VISIBILITY. New Continental GT - Window drop glass concerns Customer statement / workshop findings: Window drop glass concerns. Technical background: Retailer to identify the reported concern, once identified please carry out the instructions within the Measure section Measure: On the receipt of a valid customer complaint relating to any window drop glass concerns, firstly the Software of all 4 door control modules must be updated. |
| 2058194/1 | 2020-02-08. Service bulletin. STRUCTURE. Door mirror mounting foot cracked Customer statement / workshop findings Door mirror mounting foot is cracked Technical background In the event the door mirror mounting is cracked, the mounting must be replaced as per the current Repair manual instructions. Please Note: The repair manual instructions will be revised to include the information within the Measure section of this TPI, these instructions MUST be followed until the repair manual is revised. |
| 2058424/1 | 2020-02-08. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. New Continental GT and New Continental GTC - Rear quarter glass not fully closing Customer statement / workshop findings: Referring to Figure 1 - During the window and/or door close operation, the front door drop glass closes and seals (Point A) however the rear quarter glass does not fully close and seal (Point B) leaving a gap between the front and rear glass (Point C) Measure: Retailers should advise customers to pull and hold the front window switch up manually (until the affected window is closed) the window close function should return when the customer exits the vehicle and closes the door Alternatively Close the windows by using the convenience close feature if fitted and active (Refer to Owners handbook) Or should the vehicle not have the convenience close feature Open and then immediately close the front door - Check and confirm the quarter glass window now automatically closes. |
| 2056582/2 | 2020-01-09. Service bulletin. STRUCTURE. Condition: Customer statement: Noise complaint from the interior Workshop findings: The noise can be reproduced and clearly assigned to the interior Prior to starting the instructions within this TPI, the Retailer must check and confirm the vehicle is in standard factory condition and has not had any non-approved aftermarket modifications conducted Should any aftermarket modifications be found, the Retailer must make Product Support aware by raising a DISS query to report the details of the modification, you must then await feedback from Product Support before conducting any further work Technical Background It is the retailers responsibility to check and confirm if there are any TPIs which are applicable to the customers complaint/issue if there is an applicable TPI available, apply it and complete a DISS complaint to include Workshop findings only (No repair query required). For correct diagnosis and repair the attached Flowchart must be followed in conjunction with the Measure section of this TPI |
| 2052431/3 | 2019-12-06. Service bulletin. STRUCTURE; EQUIPMENT. Customer statement / workshop findings: Rattle / buzzing noise from Control Unit for Head-Up display - dashboard upper trim panel. Technical background: Several known conditions may cause Rattle / buzzing noise from dashboard upper trim panels. • Relative movement between Control Unit for Head-Up Display and associated Trim Ring – figure 1. • Contact between the dashboard and dashboard upper trim panel. • Head-up Display internal fault |
| 2052394-4 | 2019-09-23. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY:DOOR. New Continental GT and New Continental GTC - Driver/Passenger door power latch creak on close |
| 2052092-3 | 2019-09-23. Service bulletin. STRUCTURE:BODY:DOOR. New Continental GT - Door 'soft close' functionality |
| 2051748-7 | 2019-09-23. Service bulletin. STRUCTURE:BODY. New Continental GT - Wind noises |
| 2051495-2 | 2019-09-23. Service bulletin. EXTERIOR LIGHTING:TAIL LIGHTS; STRUCTURE:BODY. New Continental GT - Rear lamps, Boot lid and Rear bumper moulding |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.