Service bulletins for the 2020 Bentley Bentayga
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
753 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Body and frame are shown. Show all
| 2075034/1 | 2024-09-10. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY. EPB Warning light in DIP - Front door/s power latch system intermittent - DTC U112300 within Address 03 and Address 46. Technical background: The micro switch signal of the door lock is not recognised or is recognised briefly, a counter press of the door by the operative is required to clearly recognise the signal Insufficient back pressure of door (door closing loads / seal load) results in the pawl microswitch signal becoming too short. This short signal is then calculated as an error state by address 0003 -Brake electronics. |
|---|---|
| 2049193/2 | 2024-02-07. Service bulletin. STRUCTURE; EQUIPMENT. Bentayga - A Post Water Deflector - Surface Contamination. Customer statement / workshop findings: Mottled appearance on A post water deflectors. Surface deposits on A post water deflectors cannot be removed by washing with car shampoo. Technical background: Surface deposits are caused by UV protection additives contained within the A post water deflector migrating to the surface. This migration process is intentionally designed to protect parts from brittleness and ageing, the mottled appearance may occur after a certain length of time and is also dependent on temperature and humidity. Deposits on the surface are normally removed by weathering during normal driving or when washing the vehicle. |
| 2071525/1 | 2024-01-03. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM; LATCHES/LOCKS/LINKAGES. Driver / Passenger door(s) creak on close - All models (frond and/or rear). Customer statement / workshop findings: Driver and / or Passenger door creak during the Power close function - Front and / or rear (Depending on vehicle type) Technical background: Ensure the fault is as described within the Customer statement Workshop findings section before continuing. |
| 2061582.8 | 2023-11-08. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY:DOOR; STRUCTURE. Driver/Passenger door/s creak on close - Bentayga Customer Statement: -Driver and/or Passenger door creak during the (Power close) function |
| 2060458.3 | 2023-11-08. Service bulletin. VISIBILITY; ELECTRICAL SYSTEM; STRUCTURE. Water Ingress onto the front reading light Customer Statement: -Water drips from the front interior light. The water drips directly from the electric drive of the front sun roof motor. |
| 2055540.4 | 2023-11-06. Service bulletin. STEERING; SUSPENSION; STRUCTURE; ELECTRICAL SYSTEM. Rumble noise and/or floor pan/steering column vibration Customer Statement: -Floor pan or steering column/steering wheel vibration when manoeuvring/steering at slow speeds with steering wheel input |
| 2069806/4 | 2023-10-06. Service bulletin. EQUIPMENT; VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM; STRUCTURE. HVAC refrigerant leakage suspected or reports of a damp/musty smell within the cabin - Diagnosis guidelines. Condition HVAC not cooling / HVAC cooling less than expected / HVAC refrigerant leakage confirmed Or The customer reports a damp/musty smell within the cabin. - Should no HVAC leak be evident and a damp/musty smell has been reported/identified the operative should first confirm that water is not leaking into the cabin please refer to all VIN applicable TPIs particularly TPI 2062622/- - Should there be no water leaks evident, the operative should check the HVAC and body drains for blockages, in the event the drains are blocked the drains must be unblocked, once this has been completed the operative should confirm if the damp/musty smell is still evident. |
| 2068829.1 | 2023-02-03. Service bulletin. STRUCTURE:BODY:TRUNK LID; STRUCTURE. Rear lid or boot - Water Ingress Diagnosis Customer Statement: -Water ingress within the rear lid -Water dripping from the rear lid -Water ingress is evident within the boot -Water in some isolated cases may be heard moving/sloshing from inside of the rear lid |
| 2062622.2 | 2023-02-03. Service bulletin. STRUCTURE. Water Leak/Wind Noise Diagnosis Customer Statement: -Water leak/wind noise evident -The instructions within this TPI should be followed to assist in the diagnosis of water leaks or wind noise. |
| 2054210.4 | 2023-01-06. Service bulletin. VISIBILITY; STRUCTURE; VISIBILITY:SUN/MOON ROOF ASSEMBLY. Noises from Panoramic Sun Roof Customer Statement: -Noises from the panoramic sun roof when driving. The noises occur mainly when the sun roof is closed |
| 2055540.3 | 2022-12-08. Service bulletin. STEERING; STRUCTURE. Rumble noise and/or floor pan/steering column vibration Customer Statement: -Floor pan or steering column/steering wheel vibration when maneuvering/steering at slow speeds with steering wheel input |
| 2065197.2 | 2022-12-08. Service bulletin. STRUCTURE; SUSPENSION. Squeaking/creaking noises from the front axle and/or leaks at the lower ball joint/s Customer Statement: -A leak is visible at the boot of the lower ball joint (grease emerging) however the boot does not show any damage |
| 2061582.6 | 2022-11-08. Service bulletin. LATCHES/LOCKS/LINKAGES; STRUCTURE; ELECTRICAL SYSTEM. Driver/Passenger door/s creak on close - Bentayga Customer Statement: -Driver and/or Passenger door creak during the "Power close" function |
| 2067489/1 | 2022-10-07. Service bulletin. STRUCTURE; VISIBILITY. Window side glass - Identification - Standard (STD) or Privacy (PRV) Customer Statement: - Incorrect side glass fitted - Standard (STD) not Privacy (PRV) or visa versa and/or Defects are evident within the glass Technical Background: -The instructions within the Measure section MUST only be followed if the glass is to be replaced |
| 2067740/1 | 2022-08-31. Service bulletin. STRUCTURE. Tailgate interior trim - Specification guidelines Customer Statement: -Suspected tailgate lower trim surface damage issues Technical Background: -The complaint could be received for the right and/or left hand side -Refer to the Measure section for further clarification |
| 2067488/1 | 2022-08-05. Service bulletin. STRUCTURE. Veneer/trim mismatch - DISS query requirements. Customer statement / workshop findings: In the event that a trim mismatch is detected for example: - Piano black veneer is supplied although the customer ordered walnut veneer Or - The interior trim colour is incorrect for example: Cricket ball interior trim is supplied although the customer ordered Hotspur The operative should refer to the Technical background section |
| 2066502/1 | 2022-04-07. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM. Charging starts and stops when using a public charging unit. Customer statement / workshop findings: When using a public charging unit to charge the high voltage battery, charging starts and is then interrupted/stops Workshop findings The following DTC is also evident: P33E800: Charge socket A, charge connector lock mechanical malfunction passive/sporadic. Measure: 1) Referring to Rep.Gr 93 - Carry out an Inspection and classification of the Hybrid battery unit AX1 VERY IMPORTANT: In the event that the classification result of the battery is Normal the operative should conduct the remaining steps of this TPI from step 2 However If the classification result of the battery is either Danger or Warning then move the car to the quarantine area and raise a DISS immediately, the operative MUST NOT continue with any other work unless instructed via the open DISS query 2) Check the operation of the charging system using the customers and the retailers own charging equipment 3) Run a full diagnostic log and check if the DTC within the Technical background section are evident. |
| 2065760/1 | 2022-02-05. Service bulletin. STRUCTURE; EQUIPMENT. Rear Jacking point - Sill damage found during PDI. Customer statement / workshop findings: Damage found around the rear sill Jacking point during PDI (Figure 1). Measure: In the event the issue is as described, please raise a technical DISS query ensuring clear photographs are attached The operative MUST await feedback from Product Support before conducting any further work Note to Product Support: The DISS query should be second levelled to the applicable Senior Engineer for review before responding to the retailer Technical product information Rear Jacking point - Sill damage found during PDI Transaction No.: 2065760/1 |
| 2057988/6 | 2022-01-08. Service bulletin. EQUIPMENT; STRUCTURE. Bentayga Hybrid - Accessory Embargo. Customer statement / workshop findings Customer request to install fixed sill steps, deploying sill steps or Illuminated tread plates to Bentayga Hybrid vehicle. Technical background Due to the routing and proximity of high voltage cables it is strictly prohibited to install the following accessories on Bentayga Hybrid vehicles. - Fixed sill steps. - Deploying sill steps. - Illuminated tread plates NOTE: Tow bars cannot be fitted to Bentayga Hybrid vehicles due to certification IMPORTANT: Bentayga Styling Specification MUST NOT be fitted to Bentayga Hybrid vehicles from 19 to 20 Model year due to certification reasons However From 21 Model year onwards the Bentayga Styling specification can be fitted Note: Failure to observe these instructions may invalidate certain aspects of the vehicle warranty. In all instances, when placing an order for spare parts or accessories please refer to the electronic parts catalogue (ETKA) |
| 2065567/1 | 2022-01-07. Service bulletin. STRUCTURE. Front wing Flying B detached, loose and/or rattling noise from the front wing(s). Customer statement / workshop findings The front wing Flying B is loose/rattling Or The front wing Flying B is detached from the front wing. Measure In the event the front wing Flying B brightware is loose/rattling carry out the onward instructions from step 1 However In the event the front wing Flying B brightware is detached (not damaged) carry out the instructions from step 2 HINT: The front wing does not require removal to conduct this procedure 1) Referring to Rep.Gr 66 - Remove the front wing 'Flying B' 2) Using a suitable cleaning agent for example 3M surface cleaner and suitable cloth, thoroughly clean the brightware aperture and the front wing 'Flying B' 3) Using the adhesive as per the Parts information section - Apply the adhesive in the three locations shown in Figure 3 |
| 2051045/4 | 2022-01-06. Service bulletin. EQUIPMENT; STRUCTURE. Night vision camera - Washer jet leaking. Customer statement / workshop findings: Washer fluid dripping/leaking from the night vision camera washer jet. Technical background: Please note: The photographs shown within this TPI are based on a New Continental GT/C vehicle however the process is similar regardless of vehicle type Referring to Figure 1 - In the event the afore mentioned symptom is evident the operative should refer to the Measure section of this TPI to replace the night vision washer jet (short link hose -Circled) which connects the night vision camera washer jet (A) to the washer jet supply hose connector (B) |
| 2064779/1 | 2021-11-05. Service bulletin. SUSPENSION; STRUCTURE. Customer statement: Creaking/squeak noise from the front suspension. Workshop findings: Defective upper inner lever bush. Technical background Verify that the customer complaint matches the sound file within the Bentley Hub Reference TPI Transaction number 2064779/-. The noise present in the sound file is caused by defective upper inner lever bush/bushes, the noise can appear in the following possible scenario. -When the vehicle is moved with steering input over uneven surfaces (for e.g. a ramp or speed bump). If the customer complaint occurs in any of the above circumstances and the noise can be clearly assigned to the noise within the sound file Refer to the instructions within the Measure section of this TPI. VERY IMPORTANT NOTE FOR HYBRID VEHICLES: -Hybrid vehicles use a High voltage system and MUST only be worked on by suitably qualified personnel. -Please ensure all guidelines within the repair manual are strictly followed before and whilst conducting any work on vehicles with a High voltage system |
| 2064469/1 | 2021-10-07. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM. Bentayga - Rear Window Blinds Do Not Fully Retract. Customer statement / workshop findings: Rear window blind/s do not fully retract (Jammed) |
| 2053351/7 | 2021-10-06. Service bulletin. ENGINE AND ENGINE COOLING; STRUCTURE. Buzzing noise from engine area. Customer statement / workshop findings Workshop findings: Buzzing noise heard at idle from the sump area when the vehicle is elevated on a workshop ramp. The noise cannot be heard from inside the cabin or outside of the vehicle in normal circumstances. Technical background: A buzzing noise can be generated by the oil pump when the engine is running at idle. Measure: Test a comparable vehicle with the same Engine derivative. If the same noise is apparent on the comparable vehicle and no oil pressure warnings or relevant DTCs are stored then the noise can be considered a characteristic of the vehicle and no further action should be taken. |
| 2057841/3 | 2021-10-06. Service bulletin. VISIBILITY; STRUCTURE. Windscreen replacement criteria whilst under manufacturers warranty Customer statement / workshop findings: Windscreen cracked/damaged Technical background: Please refer to the instructions within the Measure section of this TPI in the event that a windscreen is cracked/damaged NOTE: The instructions MUST be followed to help the retailer clarify if the windscreen should be replaced under manufacturers warranty (Stress crack) or Customer pay/insurance (external influence damage) |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.