Service bulletins for the 2008 Audi Q7
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
458 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
| A011495 2038434- | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. The MIL is on. DTCs are stored in the engine control module (ECM), J623 (address word 01). Software update needed. |
|---|---|
| A011496 2018260- | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 01 number 13-76 dated March 14, 2013. MIL on. A number of incident memory entries with regard to the throttle valve are stored in the engine control module (ECM), J623 (01). In most cases, the entries are sporadic. Contact resistance in the ECM wiring ? throttle valve. |
| A481462 2017266- | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 48 number 14-59 dated June 2, 2014. Electrically-adjustable steering column adjustment is restricted and does not adjust vertically. Incorrect operation of Easy Entry is not the cause. It is unlikely that external forces have led to the loss of the stored end positions of the adjustment movement. Seat adjustments can be used to maintain the 10-inch minimum recommended distance from the steering wheel in case of airbag deployment. The axial adjustment is still functional during this condition. |
| A641436 2020552- | 2017-12-05. Service bulletin. VISIBILITY:WINDSHIELD. Windshield is streaked, has a snakeskin appearance, or its surface feels rough. Residue from industrial fallout as well as normal road dirt and grime may accumulate on windshield. |
| A481463 2028220- | 2017-12-05. Service bulletin. STEERING. Supersedes Technical Service Bulletin Group 48 number 13-54 dated September 13, 2013. Steering wheel appearance damaged due to external impact (e.g., contact with finger nails, zippers, watches, rings, etc.). External impact (e.g., contact with finger nails, zippers, watches, rings etc.) can cause damage to the appearance of the steering wheel. This type of damage is not warrantable, as numerous investigations have shown that there is no fault in material or workmanship. |
| A441455 2010334- | 2017-12-05. Service bulletin. WHEELS. Supersedes Technical Service Bulletin Group 44 number 13-46 dated December 9, 2013. Wheel bolt requires torque adjustment. |
| 2013 06 Audi Bra | 2017-12-05. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; SERVICE BRAKES. This document contains information on the Audi braking guard. |
| A011322 2019208- | 2017-12-05. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL; ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 01 number 13-93 dated May 8, 2013. Engine does not start in extremely cold ambient temperatures. If, during winter months, the vehicle is used mainly for short trips, it is possible for an excessive amount of condensed water to collect in the rear muffler. When the condensed water level in the muffler reaches a certain point, it is possible for this water to run into the exhaust pipe and freeze overnight, preventing the engine from starting. |
| A431322 2018190- | 2017-12-05. Service bulletin. SUSPENSION. Supersedes Technical Service Bulletin Group 43 number 13-18 dated May 8, 2013. Customer may report a warning for self-leveling suspension in instrument cluster. DTCs may be stored in the self-leveling suspension control module. The DTC does not affect the operation of the shock absorbers. Due to manufacturing quality differences in the control module for the self-leveling suspension system, one of the DTCs listed above may be stored. |
| A461353 2034181- | 2017-12-05. Service bulletin. SERVICE BRAKES. Customer may report hearing brake noise from front or rear brakes. Customers may describe these noises as a squeal, squeak, grinding, groaning, thumping, or creaking. |
| A481348 2021191- | 2017-12-05. Service bulletin. STEERING. Supersedes Technical Service Bulletin Group 48 number 13-46 dated July 22, 2013. Customer hears squeaking noises when turning or maneuvering the steering wheel. The folds of the outer CV joint rubber boots can touch each other when the steering wheel is turned. |
| A481349 2015819- | 2017-12-05. Service bulletin. STEERING:ELECTRIC POWER ASSIST SYSTEM. Supersedes Technical Service Bulletin Group 48 number 13-43 dated April 19, 2013. The customer may report that the Easy Entry function of the power adjustable steering column intermittently does not work. |
| A481351 2017266- | 2017-12-05. Service bulletin. STEERING. Supersedes Technical Service Bulletin Group 48 number 10-09 dated August 13, 2010. Electric steering column adjustment is restricted or does not work at all. Incorrect operation of Easy Entry is not the cause. It is unlikely that external forces have led to the loss of the stored end positions of the adjustment movement. See TSB 2015819, 48 Easy Entry function of the power adjustable steering column intermittently does not work, for more information. The seat adjustments can be used to maintain the 10-inch minimum recommended distance from the steering wheel in case of airbag deployment. The steering column may be under tension due to unfavorable tolerances of the steering column and module cross carrier. As a result, the current draw of the regulator motors is above specification, so the electric steering column adjustment fails. |
| A571392 2022032- | 2017-12-05. Service bulletin. LATCHES/LOCKS/LINKAGES:DOORS:LATCH. Supersedes Technical Service Bulletin Group 57 number 11-49 dated August 8, 2011. The customer inquires about the operation of the vehicle locking, and may suggest that the vehicle "locked itself". The lock command history is stored in the convenience system control module (J393). |
| A641329 2020552- | 2017-12-05. Service bulletin. VISIBILITY:WINDSHIELD. Windshield is streaked, has a snakeskin appearance, or its surface feels rough. Residue from industrial fallout as well as normal road dirt and grime may accumulate on windshield. |
| A911302 2018187- | 2017-12-05. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. Supersedes Technical Service Bulletin Group 91 number 11-20 dated October 21, 2011. Customer may report that cracking, grinding, rattling, humming, whining, or similar interference is coming from one or more speakers. Parts of the speakers (such as the brackets, cables, or covers) or parts of the interior fittings (such as door covers, rear shelf, facings, or covers) can vibrate at certain frequencies, causing noises. The radio tuner or other control modules may be affected by electromagnetic interference from aftermarket electronic devices. |
| A941327 2033675- | 2017-12-05. Service bulletin. EXTERIOR LIGHTING:TAIL LIGHTS. Supersedes Technical Service Bulletin Group 55 number 13-31 dated July 18, 2013. The customer may report that the tail lamp lighting does not switch over from bumper to the lid, with lid closed. The rear bumper lights function normally (brake lights, reverse lights, driving lights, turn signals). The center mount brake light functions normally. DTC 03073 (Closed Rear Lid Sensor - Incorrect Signal) may be stored in the comfort system central control module, J393 (address word 46). |
| A941323 2033675- | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM:WIRING: REAR COMPARTMENT/TRUNK; ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 94 number 13-17 dated May 22, 2013. DTC 03073 (Closed Rear Lid Sensor - Incorrect Signal) may be stored in the comfort system central control module, J393 (address word 46). In order for the vehicle to receive a proper rear lid status signal when the lid is operated, the paddle switches on the rear sill trim must contact the opposing lid latch points uniformly. When the rear lid is opened, the paddle switches change state and the comfort system central control module 2, J773, will read G525 and G526. It will then communicate to the comfort system central control module, J393. |
| A961367 2019260- | 2017-12-05. Service bulletin. EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 96 number 12-37 dated June 11, 2012. The customer may report that the handheld transmitter cannot be programmed to the garage door opener control module, J530. The customer's door opener system may not be compatible with J530. The battery in the handheld transmitter may be too weak for a good signal. The battery charge may be sufficient to operate the garage door opener, but not enough to program the remote transmitter to the vehicle system. In A4 Model Years 2005 - 2006 and A3 Model Year 2009, the actual location of the garage door opener control module differs from the location shown in the owner's manual (opposite side of front bumper). The customer may misunderstand the programming procedure, particularly if the customer's HomeLink® opener system is using an alternate code. The handheld transmitter's programming function may become inoperative, or the transmitter is too far away from J530. Interference prevents the communication between handheld transmitter and J530. If the vehicle flashes during the programming of a handheld transmitter, this does not necessarily indicate that the programming was successful; it only indicates that the vehicle has recognized and saved a signal. |
| A911392 2030947- | 2017-12-05. Service bulletin. EQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM:SOFTWARE. Supersedes Technical Service Bulletin Group 91 number 12-61 dated September 25, 2012. The customer complains that when he or she is trying to place a phone call from the vehicle while using a Bluetooth®-connected phone, the phone call disconnects before it begins and an error shows on the MMI display. The message may be "Function not supported" or "Network error". The customer is using a phone with the Android operating system. In addition, Skype®, or another network-based communication software, is installed on the phone. Call can be placed directly from the phone without a problem. When the phone gets the request to place a call from the vehicle, a prompt appears on the phone asking the user to choose how the call should be placed. If the prompt is ignored, the MMI system disconnects the call assuming the phone is not responding. |
| A551331 2033675- | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM:WIRING: REAR COMPARTMENT/TRUNK. DTC 03073 (Closed Rear Lid Sensor - Incorrect Signal) may be stored in the comfort system central control module, J393 (address word 46). In order for the vehicle to receive a proper rear lid status signal when the lid is operated, the paddle switches on the rear sill trim must contact the opposing lid latch points uniformly. When the rear lid is opened, the paddle switches change state and the comfort system central control module 2, J773, will read G525 and G526. It will then communicate to the comfort system central control module, J393. |
| A481346 2021191- | 2017-12-05. Service bulletin. STEERING. Supersedes Technical Service Bulletin Group 40 number 09-06 dated August 3, 2009. Customer hears squeaking noises when turning or maneuvering the steering wheel. The folds of the outer CV joint rubber boots can touch each other when the steering wheel is turned. |
| A461347 2034387- | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM; PARKING BRAKE. Customer may report sporadically hearing the parking brake being actuated after the vehicle has been switched off. If the customer does not identify the sound as the sound of the parking brake being actuated, he or she may simply complain of hearing noises from the rear brakes. Ignition is switched off. Steering is locked. Park is selected. Parking brake is not engaged. If the electro-mechanical parking brake is not operated for some time, the free play between brake pads and brake discs increases because of normal brake pad wear. The parking brake control unit performs an automatic correction about every 621 miles (1,000 km). On A8 models, the brake pad thickness is also calculated. |
| A431320 2017325- | 2017-12-05. Service bulletin. ELECTRICAL SYSTEM; SUSPENSION. Supersedes Technical Service Bulletin Group 43 number 11-07 dated November 23, 2011. Immediately after the vehicle is started, the air suspension lowers the vehicle to its lowest possible position. The air suspension warning light blinks. An ignition off/on cycle will reboot the system and restore the functions.DTC 01487 (System function test incorrect signal sporadic) is stored in the level control system control module, J197 (address word 34). |
| A371309 2028715- | 2017-12-05. Service bulletin. POWER TRAIN. Supersedes Technical Service Bulletin Group 37 number 12-40 dated February 28, 2012. Rough gear changes, both when accelerating and when slowing down. There is a rough driving power disruption that occurs sporadically and lasts for less than a second. After a mechatronics, torque converter, or complete gearbox replacement, the clutches must be adapted to the new component. This requires a gradual move of the clutch linings toward the optimal operating points in the most diverse load conditions. As a result, sporadic driving power disruptions lasting for less than a second or reduced shift comfort are possible over the first 500 miles. This is normal, and these issues will decrease over time. The issues can also occur if the adaptation values of the gearbox were deleted. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.