WenmarOpen by Wenmar Pro

Service bulletins for the 2013 Audi A8

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1506 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
A011455 2036169-2017-11-08. Service bulletin. ENGINE; FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP. The MIL is on. DTC P0087 may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20° F (-7° C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No. 2 Diesel is blended by refineries to various levels of winterization (minimum useable temperature) based on month, geographical location, and the 10th percentile minimum ambient air temperature for the given region. Although rare, during sudden periods of extreme low temperatures (record lows), fuel stations may not be adequately prepared with No. 2 Diesel fuel with sufficient winterization to resist wax formation or ?gelling?.
A011451 2030580-2017-11-08. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 01 number 13-19 dated August 1, 2013. The customer complains that the vehicle sporadically cannot be started. The yellow gearbox warning light may be illuminated. DTCs may be present. The remote key being used is transmitting incomplete immobilizer information to the vehicle, resulting in the condition.
A001458 2026692-2017-11-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. Supersedes Technical Service Bulletin Group 00 number 12-43 dated December 21, 2012. If a 2012 - 2015 Audi A8 L W12 arrives at an Audi dealership and requires diagnosis or repair, a Repair Authorization must be obtained. Prior to any repair, a Technical Assistance Center (TAC) ticket must be created for engine and transmission concerns only. Routine maintenance and PDI do not require prior authorization or a Technical Assistance Center (TAC) ticket. These procedures are mandatory until further notice. Warranty repairs without repair authorization via a TAC contact will not be reimbursed.
Update Bulletin2017-11-03. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM; EQUIPMENT. quality package has been defined for Audi vehicles with 4.0L TFSI engine manufactured within a specific period. This Update is in effect until removed. Procedure is valid only for vehicles that show the 19J1 code in the ElsaWeb Campaign/Action Information screen on the day of repair. Vehicle must be within the New Vehicle Limited Warranty. Procedure must be performed within the allotted time frame stated in this Technical Service Bulletin. Procedure must be performed on applicable vehicles in dealer inventory prior to sale. A quality package has been defined for Audi vehicles with 4.0L TFSI engine manufactured within a specific period.
Update Bulletin2017-11-03. Service bulletin. EQUIPMENT; STRUCTURE. A quality package has been defined for Audi vehicles with 4.0L TFSI engine manufactured within a specific period. This Update is in effect until removed. Procedure is valid only for vehicles that show the 19J1 code in the ElsaWeb Campaign/Action Information screen on the day of repair. Vehicle must be within the New Vehicle Limited Warranty. Procedure must be performed within the allotted time frame stated in this Technical Service Bulletin. Procedure must be performed on applicable vehicles in dealer inventory prior to sale. A quality package has been defined for Audi vehicles with 4.0L TFSI engine manufactured within a specific period.
Update Bulletin2017-11-03. Service bulletin. ENGINE; STRUCTURE. A quality package has been defined for Audi vehicles with 4.0L TFSI engine manufactured within a specific period. This Update is in effect until removed. Procedure is valid only for vehicles that show the 19J1 code in the ElsaWeb Campaign/Action Information screen on the day of repair. Vehicle must be within the New Vehicle Limited Warranty. Procedure must be performed within the allotted time frame stated in this Technical Service Bulletin. Procedure must be performed on applicable vehicles in dealer inventory prior to sale. A quality package has been defined for Audi vehicles with 4.0L TFSI engine manufactured within a specific period.
Reference-Oil Ca2017-11-03. Service bulletin. ENGINE; EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This document contains the Audi oil capacity chart.
A961378 2034000-2017-11-03. Service bulletin. LANE DEPARTURE; LANE DEPARTURE: ASSIST. Supersedes Technical Service Bulletin Group 96 number 13-74 dated September 11, 2013. Customer complains that Audi Lane Change Assistant deactivates or is sporadically inoperative. Message ?Side Assist Unavailable? is displayed in the Driver Information Display when the system deactivates. Workshop finds that Audi Lane Change Assistant can be activated without issue. DTCs are stored in the Lane Change Assistance control module. A software issue within J769 causes a diagnostic fault, which deactivates the Audi Lane Change Assistant temporarily.
A911311 2027718-2017-11-03. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 91 number 13-86 dated June 11, 2013. When the driver uses the Bluetooth hands-free telephone system to make a call, the listener on the other end cannot clearly understand the driver. The driver?s voice sounds muffled, as if it is being heard from under water. The microphone seal is damaged during installation into the roof module.
A871346 2035582-2017-11-03. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; ENGINE AND ENGINE COOLING. The A/C Compressor has been diagnosed as faulty and will be replaced under warranty. When performing replacement of an A/C Compressor under warranty, the amount of refrigerant and oil recovered must be documented.
741312 2004327-42017-11-03. Service bulletin. STRUCTURE; EQUIPMENT. Supersedes Technical Service Bulletin Group 70 number 08-39 dated December 4, 2008. Leather upholstery is dirty or stained.
MY 2014 Audi A82017-10-31. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This document contains the Audi delivery report checklist.
MY 2014 A8 S8 PD2017-10-31. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This document contains the Audi delivery report checklist.
MY 2013 A8 S8 PD2017-10-31. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. This document contains the Audi delivery report checklist.
A911316 2035912-2017-10-31. Service bulletin. EQUIPMENT:ELECTRICAL; BACK OVER PREVENTION: CAMERA SYSTEM. After the camera control module, J928, has been replaced, the front image is upside down and cannot be changed (Figure 1). The calibration cannot be completed. The coding of the camera control module is not completed correctly.
A911314 2013790-2017-10-31. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 91 number 11-25 dated November 29, 2011. The navigation DVD or other CD/DVD cannot be ejected. There are no DTCs stored in the corresponding module. The eject button is not stuck. When the eject button is pushed, the drive does not sound as if it is trying to eject the CD/DVD. Vehicles with DVD-based navigation systems now have the navigation DVD installed during production. To prevent theft of the DVD during transportation, the eject button of the navigation drive is disabled. The navigation system itself (e.g., route guidance) functions as specified. The eject buttons of vehicles without DVD-based navigation systems are not disabled during production, but could behave as described in the Condition section of this bulletin. The eject button can be enabled through Guided Fault Finding.
A741315 2035757-2017-10-31. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; SEATS. Customer may complain that the seat pneumatics (side bolsters and lumbar support) actuate without any input from the customer. This condition can occur when the vehicle is driven at high altitudes or when the outside temperature fluctuates. DTCs may be present in the front seat pneumatics control modules, J873 and J872 (address words 88 and 89) or in the rear seat pneumatics control modules (in certain A8 models only), J875 and J874 (address words 8A and 8D). No leak is present. There is a software issue in the seat pneumatics control modules that causes the seat pneumatics to automatically actuate in high altitudes (change in air pressure) or in fluctuating temperatures in order to maintain pressure.
A441344 2022563-2017-10-31. Service bulletin. STEERING; SUSPENSION. Supersedes Technical Service Bulletin Group 44 number 13-42 dated September 27, 2013. Customer feels vibration in the seat, vehicle floor, footwell, pedals, or steering wheel. This condition does not lead to any handling concerns or loss of vehicle control. The customer feels the vibration while driving at highway speeds from 55 - 80 mph (88 - 128 km/h). This bulletin is not applicable if this vehicle has a Repair Authorization on this topic.
A171347 2035463-2017-10-31. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 17 number 13-44 dated October 22, 2013. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine, and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner?s Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, and the ambient temperature and road conditions. Additional factors include the amount of oil dilution from water condensation or fuel residue and the oxidation level of the oil. Utilizing the advanced sensor technology integrated in models equipped with the 3.0 TFSI engine, it is possible to measure oil consumption electronically via a Guided Function test plan. If the electronic oil consumption test is not available for this model, perform the test with the conventional scale/oil weighing method. See TSB 2018550 for instructions for the conventional scale/oil weighing method.
Update Bulletin-2017-10-31. Service bulletin. ENGINE AND ENGINE COOLING. A quality package has been defined for Audi vehicles with 4.0L TFSI engine manufactured within a specific period. This Update is in effect until removed. Procedure is valid only for vehicles that show the 19J1 code in the ElsaWeb Campaign/Action Information screen on the day of repair. Vehicle must be within the New Vehicle Limited Warranty. Procedure must be performed within the allotted time frame stated in this Technical Service Bulletin. Procedure must be performed on applicable vehicles in dealer inventory prior to sale. quality package has been defined for Audi vehicles with 4.0L TFSI engine manufactured within a specific period.
A441346 2010334-2017-10-31. Service bulletin. WHEELS:LUGS/NUTS/BOLTS/STUDS; WHEELS. Supersedes Technical Service Bulletin Group 44 number 12-32 dated August 2, 2012. Wheel bolt requires torque adjustment. Torque sticks, torque extension bars, and impact guns/wrenches are not approved by Audi of America, Inc., and should not be used to apply torque to wheel bolts. Always use a calibrated torque wrench to attain the correct wheel bolt torque and follow the proper wheel tightening procedure as outlined in Elsa. Proper use of a calibrated torque wrench ensures that all wheel bolts are tightened equally and reduces the chances of repeat repairs. Using methods other than a calibrated torque wrench to attain correct wheel bolt torque may lead to problems.
A961374 2034000-2017-10-31. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Supersedes Technical Service Bulletin Group 96 number 13-63 dated May 29, 2013. Audi Lane Change Assistant deactivates or is sporadically inoperative. Message ?Side Assist Unavailable? is displayed in the Driver Information Display when the system deactivates. Audi Lane Change Assistant can be activated without issue. DTCs are stored in the Lane Change Assistance control module. A software issue within J769 causes a diagnostic fault, which deactivates the Audi Lane Change Assistant temporarily.
A911308 2028190-2017-10-31. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Supersedes Technical Service Bulletin Group 91 number 11-28 dated December 9, 2011. Customer is inquiring about retrofitting the MMI system with a language pack or map database outside of factory-available options.
A911307 2030465-2017-10-31. Service bulletin. EQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM). Supersedes Technical Service Bulletin Group 91 number 13-98 dated August 5, 2013. MMI 3G+ Sound system "popping" and various other technical Issues (K0715 Update). This bulletin only applies to vehicles with Navigation Plus (PR Number 8DY). The applicable vehicles can be clearly identified by the SIM card slot on the faceplate of the front MMI mainunit.
A911304 2013422-2017-10-31. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 91 number 12-49 dated July 31, 2012. The Bluetooth® telephone cannot be connected to the vehicle?s Infotainment system. Certain restrictions are present when a Bluetooth device is connected to the vehicle. The restrictions vary depending on the vehicle system present.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.