WenmarOpen by Wenmar Pro

Recalls that may apply to the 2007 Aston Martin DB9

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

By component

United States: NHTSA, as of 2026-10-19
17V7950002017-12-11. ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES. Aston Martin The Americas (Aston Martin) is recalling certain 2005-2009 DB9, and DBS vehicles. The battery supply cable on these vehicles may become damaged when the driver seat is positioned in the full rearward location. Built 2004-07-21 to 2008-10-07.
14V7530002014-11-25. SEATS:FRONT ASSEMBLY:SEAT HEATER/COOLER. Aston Martin Lagonda of North America (Aston Martin) is recalling certain model year 2006-2014 DB9, V12 Vantage, V8 Vantage, DBS, and Virage vehicles manufactured July 3, 2006, to November 5, 2014. In the affected vehicles, the electronic control module for the driver and front passenger seat heaters may fail, preventing the seat heaters from being able to be turned off. Built 2006-07-03 to 2014-11-05.
10V4490002010-09-28. SUSPENSION:FRONT:CONTROL ARM:LOWER ARM. ASTON MARTIN IS RECALLING CERTAIN MODEL YEAR 2007-2008 DB9 COUPE, DB9 VOLANTE, V8 VANTAGE COUPE, V8 VANTAGE ROADSTER, AND DBS COUPE VEHICLES. THE FRONT BOTTOM SUSPENSION ARM CAM BOLT COULD CRACK ALONG ITS SHANK ALLOWING THE LOWER CONTROL ARM TO MOVE. Built 2007-03-01 to 2007-09-30.
Canada: Transport Canada, as of 2026-10-19
20145432014-12-03. Electrical. On certain vehicles, a defect in the seat heater wiring could cause the front seat heaters to remain on even when the control switch is in the "off" position. This could cause certain areas of the seats to overheat, which could result in injury to seat occupants and increase the risk of a fire causing damage to property. Correction: Dealers will install an additional module which will isolate power supply in the event of a malfunction.
20133672013-10-23. Powertrain. On certain vehicles, the accelerator pedal arm may fail. This would cause the throttle control to return to the idle position, causing a reduction in engine power and propulsive force. Loss of vehicle propulsion, in conjunction with traffic and road conditions, and the driver’s reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the accelerator pedal assembly and adjust the foot well scuff plate. Note: This recall supersedes recall 2013185. Vehicles that were repaired under the previous campaign will also need to be repaired under this campaign.
20103432010-10-08. Suspension. On certain vehicles, the front bottom suspension arm cam bolts may be out of specification. The bolts may be too hard due to incorrect heat treatment and may be prone to snap off along their shank. This failure could allow the lower control arm to move, which will influence the driver's steering control of the vehicle, increasing the risk of a crash. Correction: Dealers will replace the front suspension lower control arm cam bolts.

A campaign lists a year, a make and a model, and often only some of the vehicles built. A list with nothing on it is not a clearance either. The lookups below check one VIN.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.