WenmarOpen by Wenmar Pro

Service bulletin 1801202

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id630965
Published by NHTSA2002-04-30
Manufacturer's number1801202
Manufacturer's date2002-02-25
NHTSA componentENGINE AND ENGINE COOLING:ENGINE:GASOLINE

NHTSA's summary

SUBJECT REGARDING COLD START RPM FLARE. *JG

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Engine

Vehicles listed
JEEP GRAND CHEROKEE1999, 2000

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
06V1990002006-06-08. ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN
20020742002-04-17. Engine

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
05191925A2022-12-19. Service bulletin. Radiator If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the radiator, please perform the following before replacing the radiator/cooler:~ 1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings on the radiator. ~ 2. Remove hex nut and the top flared fitting on the radiator tank.~ 3. Using a wire brush and gasket remover, clean off the old sealant on the smaller threaded portion of the flared fitting. Do the same for the threads on the trans oil cooler.~ 4. Apply a new application of Mopar PN 04318032 to the flared fitting, leaving the first threads free for ease of engagement.~ 5. Install the top flared fitting by hand, then torque the fitting to 235 +/- 15 Lb-In.~ 6. Install the hex nut and torque to 100 +/- 10 Lb-In.~ 7. Repeat steps 2-6 for bottom flared fitting.~ 8. Reinstall transmission line per normal installation procedures and ensure correct fluid level.~
R2118796A2021-05-03. Service bulletin. Valve Body. These may cause over drive cycling.
05191925A$2020-10-26. Service bulletin. Radiator If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the radiator, please perform the following before replacing the radiator/cooler:~ 1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings on the radiator. ~ 2. Remove hex nut and the top flared fitting on the radiator tank.~ 3. Using a wire brush and gasket remover, clean off the old sealant on the smaller threaded portion of the flared fitting. Do the same for the threads on the trans oil cooler.~ 4. Apply a new application of Mopar PN 04318032 to the flared fitting, leaving the first threads free for ease of engagement.~ 5. Install the top flared fitting by hand, then torque the fitting to 235 +/- 15 Lb-In.~ 6. Install the hex nut and torque to 100 +/- 10 Lb-In.~ 7. Repeat steps 2-6 for bottom flared fitting.~ 8. Reinstall transmission line per normal installation procedures and ensure correct fluid level.~
18031032003-11-11. Service bulletin. 4.0L ROUGH ENGINE IDLE AFTER RESTART FOLLOWING A HOT SOAK. *TT
09003032003-10-23. Service bulletin. 4.0L MULTIPLE CYLINDER MISFIRE. *TT
25004012001-07-11. Service bulletin. SUBJECT REGARDING ADDITIONAL DIAGNOSTIC FOR DIAGNOSTIC TROUBLE CODES CAUSED BY AN EVAPORATIVE SYSTEM LEAK. *TT
18013012001-07-11. Service bulletin. SOME VEHICLE ENGINES MAY EXHIBIT A ROUGH IDLE AND / OR MALFUNCTION INDICATOR LAMP (MIL) LIGHT ON CONDITION UPON INITIAL START-UP AFTER A COLD SOAK WHEN TEMPERATURES ARE BELOW 50 DEGREES F (10 DEGREES C). THIS BULLETIN INVOLVES SELECTIVELY ERASING AND REPROGRAMMING THE POWERTRAIN CONTROL MODULE (PCM) WITH NEW SOFTWARE. *TT
1802300A2001-04-12. Service bulletin. SUBJECT PERTAINING TO ENGINE PERFORMANCE ENHANCEMENTS. *JB
18001012001-04-12. Service bulletin. INFORMATION REGARDING ENGINE PERFORMANCE ENHANCEMENTS. *JB
18023002001-03-08. Service bulletin. SOME VEHICLE ENGINES MAY EXHIBIT PART THROTTLE OR WIDE OPEN THROTTLE SPARK KNOCK; SAG OR HESITATION FOLLOWING A COLD ENGINE START; ROUGH IDLE; IDLE SAG WHEN DECELERATING TO A STOP. *TT