Service bulletin 180200
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 609989 |
| Published by NHTSA | 2000-04-12 |
| Manufacturer's number | 180200 |
| Manufacturer's date | 2000-02-04 |
| NHTSA component | ENGINE AND ENGINE COOLING:ENGINE |
NHTSA's summary
CONCERNS WITH THE PCV VALVE FREEZING UNDER EXTREMELY COLD CONDITIONS. *TT
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine
| CHRYSLER TOWN AND COUNTRY | 1996, 1997, 1998, 1999, 2000 |
|---|---|
| DODGE CARAVAN | 1996 to 2000 |
| PLYMOUTH VOYAGER | 1996, 1997, 1998, 1999, 2000 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 96V006000 | 1996-01-11. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE |
|---|---|
| 1996009 | 1996-01-10. Engine |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 05191925A | 2022-12-19. Service bulletin. Radiator If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the radiator, please perform the following before replacing the radiator/cooler:~ 1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings on the radiator. ~ 2. Remove hex nut and the top flared fitting on the radiator tank.~ 3. Using a wire brush and gasket remover, clean off the old sealant on the smaller threaded portion of the flared fitting. Do the same for the threads on the trans oil cooler.~ 4. Apply a new application of Mopar PN 04318032 to the flared fitting, leaving the first threads free for ease of engagement.~ 5. Install the top flared fitting by hand, then torque the fitting to 235 +/- 15 Lb-In.~ 6. Install the hex nut and torque to 100 +/- 10 Lb-In.~ 7. Repeat steps 2-6 for bottom flared fitting.~ 8. Reinstall transmission line per normal installation procedures and ensure correct fluid level.~ |
|---|---|
| R2118796A | 2021-05-03. Service bulletin. Valve Body. These may cause over drive cycling. |
| 05191925A$ | 2017-11-03. Service bulletin. Radiator If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the radiator, please check the following before replacing the radiator/cooler:~ 1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings on the radiator. ~ 2. Loosen the hex nut on the top flared fitting on the radiator tank.~ 3. Torque the top flared fitting to 235 +/- 15 Lb-In.~ 4. Torque hex nut to 100 +/- 10 Lb-In.~ 5. Repeat for bottom flared fitting.~ 6. Reinstall transmission line per normal installation procedures and ensure correct fluid level.~ ~ If vehicle is in need of a new radiator for another reason, check the new radiator for correct torque on the trans-oil cooler fitting per steps 2-5 above.~ ~ If radiator has a yellow mark by the trans-oil cooler fittings the torque does not have to be checked. |
| 0900801 | 2002-07-11. Service bulletin. SUBJECT REGARDING CAMSHAFT / BEARING SERVICE. *TT |
| 0900800 | 2001-04-12. Service bulletin. THIS BULLETIN INVOLVES INSTALLATION OF A NEW COMPONENT TO ASSIST CAM SEAL RETENTION. *JB |
| 180300 | 2000-09-29. Service bulletin. SUBJECT REGARDING EGR MONITOR DIAGNOSTIC TEST DIFFICULT TO COMPLETE OR NOT READY AT HIGH ALTITUDES (ABOVE 4000 FEET). *TT |
| 090600 | 2000-05-09. Service bulletin. SUBJECT PERTAINS TO CHANGES TO THE TIMING BELT TENSIONER COMPONENTS. *TT |
| 180100 | 2000-04-12. Service bulletin. SUBJECT REGARDING MISDIAGNOSED LEAK DETECTION PUMP SYSTEMS WITH DIAGNOSTIC TROUBLE CODES P1494, P0442 P0455, OR P0456. *TT |
| 8251 | 2000-02-24. Service bulletin. EMISSIONS RECALL STATING THAT THE RADIATOR FAN RELAY MAY NOT TURN ON THE RADIATOR COOLING FANS. *TT |
| 182497 | 2000-01-11. Service bulletin. INFORMATION ON NO START DIAGNOSTIC CAM/CRANK SENSOR $01 AND $28. *NLM |