Service bulletin 0900801
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 632197 |
| Published by NHTSA | 2002-07-11 |
| Manufacturer's number | 0900801 |
| Manufacturer's date | 2001-11-02 |
| NHTSA component | ENGINE AND ENGINE COOLING:ENGINE |
NHTSA's summary
SUBJECT REGARDING CAMSHAFT / BEARING SERVICE. *TT
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine
| CHRYSLER CONCORDE | 1993, 1994, 1995, 1996 |
|---|---|
| CHRYSLER TOWN AND COUNTRY | 1996, 1997, 1998, 1999, 2000, 2001, 2002 |
| CHRYSLER VOYAGER | 2001, 2002 |
| DODGE CARAVAN | 1996 to 2001 |
| DODGE CARAVAN | 2002 |
| DODGE INTREPID | 1993, 1994, 1995, 1996 |
| EAGLE VISION | 1993, 1994, 1995, 1996 |
| PLYMOUTH VOYAGER | 1996, 1997, 1998, 1999, 2000 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 96V006000 | 1996-01-11. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE |
|---|---|
| 1996009 | 1996-01-10. Engine |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 05191925A | 2022-12-19. Service bulletin. Radiator If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the radiator, please perform the following before replacing the radiator/cooler:~ 1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings on the radiator. ~ 2. Remove hex nut and the top flared fitting on the radiator tank.~ 3. Using a wire brush and gasket remover, clean off the old sealant on the smaller threaded portion of the flared fitting. Do the same for the threads on the trans oil cooler.~ 4. Apply a new application of Mopar PN 04318032 to the flared fitting, leaving the first threads free for ease of engagement.~ 5. Install the top flared fitting by hand, then torque the fitting to 235 +/- 15 Lb-In.~ 6. Install the hex nut and torque to 100 +/- 10 Lb-In.~ 7. Repeat steps 2-6 for bottom flared fitting.~ 8. Reinstall transmission line per normal installation procedures and ensure correct fluid level.~ |
|---|---|
| 68332810 | 2022-10-17. Service bulletin. Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m [21 ft. lbs.]. |
| R2118796A | 2021-05-03. Service bulletin. Valve Body. These may cause over drive cycling. |
| 05191925A$ | 2017-11-03. Service bulletin. Radiator If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the radiator, please check the following before replacing the radiator/cooler:~ 1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings on the radiator. ~ 2. Loosen the hex nut on the top flared fitting on the radiator tank.~ 3. Torque the top flared fitting to 235 +/- 15 Lb-In.~ 4. Torque hex nut to 100 +/- 10 Lb-In.~ 5. Repeat for bottom flared fitting.~ 6. Reinstall transmission line per normal installation procedures and ensure correct fluid level.~ ~ If vehicle is in need of a new radiator for another reason, check the new radiator for correct torque on the trans-oil cooler fitting per steps 2-5 above.~ ~ If radiator has a yellow mark by the trans-oil cooler fittings the torque does not have to be checked. |
| 1802505 | 2005-10-04. Service bulletin. LONG CRANK OR IDLE FLUCATION IN COLD TEMPERATURE WITH E20 - E30 ETHANOL FUEL BLENDS. *TT |
| 0900704 | 2004-05-03. Service bulletin. IRREGULAR ENGINE SNAPPING SOUND. *TT |
| 2500102A | 2004-04-21. Service bulletin. MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION, DIAGNOSTIC TROUBLE CODE (DTC) P0442, P0455, OR P0456 - LEAK DETECTION PUMP (LDP), LEAK DETECTED. THIS BULLETIN SUPERSEDES 25-001-02 DATED FEB 11, 2002. *TT |
| 0900104 | 2004-03-04. Service bulletin. OIL CONSUMPTION DUE TO RESTRICTED AIR FILTER. THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 2.5L TURBO DIESEL ENGINE BUILT ON OR AFTER MARCH 1, 2002. *MN |
| 0900403 | 2003-10-23. Service bulletin. OIL CONSUMPTION DUE TO RESTRICTED AIR FILTER. 2004 INCLUDED. *TT |
| 1802803 | 2003-10-20. Service bulletin. VEHICLE WITH PROPERLY FUNCTIONING EVAPORATIVE EMISSIONS SYSTEM REPEATEDLY SETS DIAGNOSTIC TROUBLE CODE P0456 WHEN CUSTOMER REGULARLY COMMUTES ON A STEEP GRADE. *TT |