WenmarOpen by Wenmar Pro

Service bulletin B652025

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id11022855
Published by NHTSA2025-09-06
Manufacturer's numberB652025
Manufacturer's date2025-08-26
NHTSA componentELECTRICAL SYSTEM

NHTSA's summary

After replacing the Multifunctional Display (MFD), the Central Information Display (CID) is black. Thebacklight of the CID is illuminated, and touch function does register an audible sound.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Electrical system

Vehicles listed
BMW 230I2025
BMW 330I2025
BMW 430I2025
BMW 530I2025
BMW 740I2025
BMW M32025
BMW M42025
BMW M52025
BMW X32025
BMW X52025
BMW X62025
BMW X72025
BMW XM2025

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
26V0960002026-02-19. ELECTRICAL SYSTEM:WIRING
20251682025-04-01. Electrical
25V2020002025-04-01. ELECTRICAL SYSTEM:STARTER ASSEMBLY; ELECTRICAL SYSTEM:ALTERNATOR/GENERATOR/REGULATOR
20250962025-02-21. Electrical
25V1090002025-02-21. ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
B6112262026-10-02. Service campaign. The BCP controls several vehicle functions, including the windscreen wipers and air conditioning actuators. Low current flow may cause excessive current in parts of the BCP circuit board and damage the unit. If a fault occurs, the wipers or air flap controls may operate incorrectly or fail. A wiper failure is indicated by a yellow warning light and the “Windscreen wiper fault” Check Control message.
B6118262026-09-28. Service bulletin. Due to unfavorable software, the Storage Management Electronics (SME) will not show fault codes that trigger the Malfunction Indicator Lamp (MIL) when performing ISTA Service Function "Display Permanent SAE Fault Codes." As a result, workshops will have to identify SME-specific permanent SAE (emission related) Diagnostic Trouble Codes (DTCs) stored in the vehicle during diagnosis or when preparing a vehicle for a State Emission Inspection and Maintenance through a workaround procedure.
B6115262026-08-28. Service campaign. In vehicles equipped with the Roof Function Center “FZD‑21” variant, a quiescent‑current violation mayoccur if the system fails to enter sleep mode. When this sleep error is present, a remote software upgrade(RSU) may be aborted and the FZD can become degraded. The following Check Control Messages (CCMs) may be displayed: “Energy Management — Increased Energy Consumption While Parked.” “Software Upgrade Failed — Workshop Visit Required.”
B6305262026-08-27. Service bulletin. After programming the vehicle via ISTA/RSUto I-level …26-03-5xx, some of the interiorambient lighting strips (arrows) may begin tofail sporadically after a deep sleep cycle.
B6518262026-07-03. Service bulletin. If BMW Intelligent Personal Assistant is active in the vehicle, once the customer exits the vehicle and a newkey cycle starts, the Intelligent Personal Assistant is deactivated and no longer available.
B6517262026-07-03. Service bulletin. After a factory reset of the head unit, the navigation voice input cannot be activated or deactivated.
B6514262026-07-03. Service bulletin. The vehicle may experience various operational issues with Apple CarPlay Projected Modes such as: Dropped connections No automatic reconnection Display errors
B6512262026-07-03. Service bulletin. The voice command to deactivate Automatic Engine Start/Stop function can also trigger the activation ofIconic Sounds.
B6101262026-07-03. Service bulletin. During vehicle start-up the Secure Element (SE) of the BCP may fail causing communication errors. TheCheck Control message “Drive carefully. Driving stabilisation.” will appear. In addition, the fault memoryentries below will be stored within 40 seconds of each other. ACSM: 02010A - Coding: Coding data not qualified VIP: 02390A - VIP control unit: Coding data not released, signature IB: 02290A - DSC control unit: Coding data not released, signature HKFM: 020D0A - HKFM: Coding data are not qualified
B1206262026-07-03. Service campaign. In these vehicles with an S68 engine, an incorrect diagnosis of the Valvetronic (VVT) may occur. Undercertain operating conditions, the software may detect a short-circuit in the valve control system even thoughthere is no fault. When the above-mentioned fault occurs, the red Check Control warning light ‘Drive system fault’ illuminates.This can result in the intake valves closing gradually, which may lead to misfires while the engine is running.