Transport Canada recall 2025168
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2025168 |
| Manufacturer's number | 12 82 25RC / 12 83 25RC |
| Reported | 2025-04-01 |
| Component | Electrical |
| Notification type | Safety Mfr |
| Units potentially affected | 228 |
What is wrong
Issue:
On certain vehicles, the power connector for the starter-generator may not have been manufactured properly. As a result, the connection between the connector and the positive battery cable may be loose. If this happens, there could be a loss of power to the wheels and/or the connection could overheat.
Safety Risk:
A loss of power to the wheels could increase the risk of a crash. Wiring that overheats could increase the risk of a fire.
Corrective Actions:
BMW will notify owners by mail and advise you to take your vehicle to a dealership. For certain vehicles, the dealer will replace the starter-generator and positive battery cable. For other vehicles, the dealer will inspect and, if necessary, replace the starter-generator and positive battery cable.
| 2025 BMW 3 SERIES | Listed under a family name that covers this model. |
|---|---|
| 2025 BMW 3 SERIES | Listed under a family name that covers this model. |
| 2025 BMW 4 SERIES | |
| 2025 BMW 5 SERIES | |
| 2025 BMW X3 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| B611226 | 2026-10-02. Service campaign. The BCP controls several vehicle functions, including the windscreen wipers and air conditioning actuators. Low current flow may cause excessive current in parts of the BCP circuit board and damage the unit. If a fault occurs, the wipers or air flap controls may operate incorrectly or fail. A wiper failure is indicated by a yellow warning light and the “Windscreen wiper fault” Check Control message. |
|---|---|
| B611526 | 2026-08-28. Service campaign. In vehicles equipped with the Roof Function Center “FZD‑21” variant, a quiescent‑current violation mayoccur if the system fails to enter sleep mode. When this sleep error is present, a remote software upgrade(RSU) may be aborted and the FZD can become degraded. The following Check Control Messages (CCMs) may be displayed: “Energy Management — Increased Energy Consumption While Parked.” “Software Upgrade Failed — Workshop Visit Required.” |
| B651826 | 2026-07-03. Service bulletin. If BMW Intelligent Personal Assistant is active in the vehicle, once the customer exits the vehicle and a newkey cycle starts, the Intelligent Personal Assistant is deactivated and no longer available. |
| B651726 | 2026-07-03. Service bulletin. After a factory reset of the head unit, the navigation voice input cannot be activated or deactivated. |
| B651426 | 2026-07-03. Service bulletin. The vehicle may experience various operational issues with Apple CarPlay Projected Modes such as: Dropped connections No automatic reconnection Display errors |
| B651226 | 2026-07-03. Service bulletin. The voice command to deactivate Automatic Engine Start/Stop function can also trigger the activation ofIconic Sounds. |
| B610126 | 2026-07-03. Service bulletin. During vehicle start-up the Secure Element (SE) of the BCP may fail causing communication errors. TheCheck Control message “Drive carefully. Driving stabilisation.” will appear. In addition, the fault memoryentries below will be stored within 40 seconds of each other. ACSM: 02010A - Coding: Coding data not qualified VIP: 02390A - VIP control unit: Coding data not released, signature IB: 02290A - DSC control unit: Coding data not released, signature HKFM: 020D0A - HKFM: Coding data are not qualified |
| B120326 | 2026-07-03. Warranty extension. Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications. |
| B652025 | 2026-05-18. Service bulletin. After replacing the Multifunctional Display (MFD), the Central Information Display (CID) is black. The backlight of the CID is illuminated, and touch function does register an audible sound. |
| B651226 | 2026-04-27. Service bulletin. After updating the vehicle to I-level …25-07-5XX, the spoken language of the navigation instructions changes from the set language for the voice assistant without the customer initiating the change. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.