WenmarOpen by Wenmar Pro

Service bulletin S2503000001

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id11014228
Published by NHTSA2025-02-12
Manufacturer's numberS2503000001
Manufacturer's date2025-02-10
NHTSA componentPOWER TRAIN
Manufacturer's systemDrivetrain Control Module, Front Axle Disconnect

NHTSA's summary

"Service 4WD Message, Diagnostic Trouble Codes (DTCs) C1463-94 Front Axle Disconnect Control-Unexpected Operation, and/or C1463-92 Front Axle Disconnect-Performance or Incorrect Operation, Set."

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Transmission and driveline

Trouble codes named

C1463

Vehicles listed
JEEP GRAND CHEROKEE2021, 2022, 2023, 2024, 2025
JEEP GRAND CHEROKEE 4XE2021, 2022, 2023, 2024 (the catalog's model; the bulletin names a series or trim of it)
JEEP GRAND CHEROKEE L2021, 2022, 2023, 2024, 2025

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
26V4130002026-06-30. POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL)
20233352023-06-08. Powertrain

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
S26210000042026-10-07. Service bulletin. The Customer May Complain About a Popping Noise, Grinding Noise, or an Intermittent No Reverse or Forward Transmission Engagement. The Tech May Find Damaged and/or Worn Transmission Output Shaft Splines (850RE Transmission Only)
1135282026-07-23. Service bulletin. SHAFT - AXLE HALF
1135292026-07-23. Service bulletin. SHAFT - AXLE HALF
21-041-26 REV. A2026-07-02. Service bulletin. Transmission Auxiliary Oil Pump Failure Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set **one or more the following Diagnostic Troubles Code (DTCs): ● U0287-00 - Lost Communication With Transmission Fluid Pump Module 1.** ● P0B0D-00 - Electric/Auxiliary Transmission Fluid Pump Motor Control Module. Customers may also comment on the following: ● Vehicle is in limp mode. This bulletin involves replacing the transmission oil pump.
21-041-262026-05-20. Service bulletin. Transmission Auxiliary Oil Pump Failure Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set the following Diagnostic Trouble Code (DTC): ● P0B0D-00 - Electric/Auxiliary Transmission Fluid Pump Motor Control Module. Customers may also comment on the following: ● Vehicle is in limp mode This bulletin involves replacing the transmission oil pump.
18-051-262026-04-22. Service bulletin. Flash: Powertrain Control Module (PCM) Updates **Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs):** ● **P0300 - Multiple Cylinder Misfire - In Active or Stored status set during cold start catalyst heating. ● P0301 - Cylinder 1 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0302 - Cylinder 2 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0303 - Cylinder 3 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0304 - Cylinder 4 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0305 - Cylinder 5 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0306 - Cylinder 6 Misfire - In Active or Stored status set during cold start catalyst heating. ● P2066 - Fuel Level Sensor 2 Performance. ● P152F - Engine Hood Switch 2 / Engine Hood Switch 1 Correlation.** ● C053D - Brake Pressure Sensor 1 Performance. **Customers may also comment on one or more of the following: ● Check engine illuminates when fueling the vehicle while the engine is running. ● Vehicle has a noticeable misfire. ● Vehicle idles rough. ● Engine noise. NOTE: Noise is heard coming from the valvetrain.** **In addition, the following software enhancement is available: ● Update to prevent customers from driving their vehicles while the Electric Park Brake (EPB) is engaged. Engine torque will be limited to prevent the Rear Drive Unit from being damaged. NOTE: Previously, the EPB would remain engaged without any torque limit which could lead to the Rear Drive Unit being damaged/broken.** This bulletin involves reprogramming the PCM with the latest available software.
18-050-262026-04-22. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0300 - Multiple Cylinder Misfire - In Active or Stored status set during cold start catalyst heating. ● P0301 - Cylinder 1 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0302 - Cylinder 2 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0303 - Cylinder 3 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0304 - Cylinder 4 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0305 - Cylinder 5 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0306 - Cylinder 6 Misfire - In Active or Stored status set during cold start catalyst heating. Customers may also comment on one or more of the following: ● Check engine illuminates when fueling the vehicle while the engine is running. ● Vehicle has a noticeable misfire. ● Vehicle idles rough. ● Engine noise. NOTE: Noise is heard coming from the valvetrain. In addition, the following software enhancement is available: ● Update to prevent customers from driving their vehicles while the Electric Park Brake (EPB) is engaged. Engine torque will be limited to prevent the Rear Drive Unit from being damaged. NOTE: Previously, the EPB would remain engaged without any torque limit which could lead to the Rear Drive Unit being damaged/broken. This bulletin involves reprogramming the PCM with the latest available software.
18-049-262026-04-22. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● **P0300 - Multiple Cylinder Misfire - In Active or Stored status set during cold start catalyst heating. ● P0301 - Cylinder 1 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0302 - Cylinder 2 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0303 - Cylinder 3 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0304 - Cylinder 4 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0305 - Cylinder 5 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0306 - Cylinder 6 Misfire - In Active or Stored status set during cold start catalyst heating. ● P2066 - Fuel Level Sensor 2 Performance. ● P152F - Engine Hood Switch 2 / Engine Hood Switch 1 Correlation.** ● P0401 - EGR System Performance. ● P00FD - Battery B State Of Charge Performance. **Customers may also comment on one or more of the following: ● Check engine illuminates when fueling the vehicle while the engine is running. ● Vehicle has a noticeable misfire. ● Vehicle idles rough. ● Engine noise. NOTE: Noise is heard coming from the valvetrain.** In addition, the following software enhancements are available: ● **Update to prevent customers from driving their vehicles while the Electric Park Brake (EPB) is engaged. Engine torque will be limited to prevent the Rear Drive Unit from being damaged. NOTE: Previously, the EPB would remain engaged without any torque limit which could lead to the Rear Drive Unit being damaged/broken.** ● Update to enable customers to operate at high state of charge range between 85 to 92%. This bulletin involves reprogramming the PCM with the latest available software.
S26230000232026-04-15. Service bulletin. Power Liftgate Inoperative.
S2621000003 REV.A2026-03-18. Service bulletin. The vehicle will exhibit a service transmission/check engine warning indicator for the following transmission models: 845RE, 8HP45, 850RE, 8HP50, 8HP70, 8HP75, 8HP75-PHEV, 8HP75-LCV, 8HP90, 8HP95. Transmissions may exhibit the following diagnostic codes: P07E4, P1DB2, P0716, P1B14, P0733, P1D90, P1DB7, P1B13.