Service bulletin SA-020-24b
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 11008419 |
| Published by NHTSA | 2024-10-04 |
| Manufacturer's number | SA-020-24b |
| Manufacturer's date | 2024-09-11 |
| NHTSA component | ELECTRICAL SYSTEM; LANE DEPARTURE: WARNING; ENGINE; LANE DEPARTURE: BLIND SPOT DETECTION; FORWARD COLLISION AVOIDANCE: ADAPTIVE CRUISE CONTROL |
NHTSA's summary
The CX-70 and CX-90 have new and revised features that are different from previous models and may be difficult to understand. This Service Alert provides valuable information to support potential dealer and customer concerns.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance, Electrical system, Engine, Adaptive cruise control, Blind spot detection, Lane departure and lane keeping
| MAZDA CX-70 | 2025 |
|---|---|
| MAZDA CX-90 | 2024, 2025 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 15-001-26 | 2026-06-02. Service bulletin. DESCRIPTION Some customers may experience that the BSM (Blind Spot Monitoring) warning light remains on while driving, even though no vehicle is present behind. This may be caused by electrical noise in the BSM control module power supply and vibration noise from the rear bumper that falsely detects a vehicle behind. To eliminate this concern, the control software of the BSM has been modified to prevent the influence of noise. Customers having this concern should have their vehicle repaired using the following repair procedure. REPAIR PROCEDURE 1. Verify the customer concern. NOTE: This issue may have two causes: the BSM software not at the latest version and the BSM insufficiently fastened. The issue may occur due to either one or both. Therefore, it is necessary to strictly follow the procedure outlined below. 2. Reprogram ECU with the Mazda Modular Diagnostic System (M-MDS), using Mazda Diagnostic and Repair Software (MDARS). Refer to MDARS ECU Reprogramming Procedure. 3. Remove the rear bumper according to the instructions in MGSS (REAR BUMPER REMOVAL/INSTALLATION). |
|---|---|
| SA-027-25 | 2025-06-05. Service bulletin. The CX-70 and CX-90 have new and revised features that are different from previous models and may be difficult to understand. This Service Alert provides valuable information to support potential dealer and customer concerns. |
| SSPD6 FC | 2024-08-06. Service campaign. SSPD6 - SPECIAL SERVICE PROGRAM - VEHICLE CONTROL MODULE (VCM) PROGRAMMING - 2024 CX-90 SSPD6 - 2024 CX-90 - Vehicle Control Module (VCM) Reprogramming: This campaign will resolve three different concerns. Unintentional warning or braking when backing up. When backing up the vehicle in a parking lot or similar area, the View Monitor Camera (VMC) may detect certain physical obstacles lower to the ground such as, the tires of an adjacent vehicle, parking lines, plants, etc. even though there are no obstacles behind the vehicle. Under this condition, the Smart Brake Support (SBS) system may determine that there is a possibility of a collision, notifying with a visual (screen display) and audible (warning sound), and the brakes possibly being applied in certain cases. Driver recognition result is not displayed (on equipped vehicles) The Driver Personalization system may not recognize the driver’s face to change the seat position settings that have been programmed. In this case the vehicle interprets the driver as a “guest” (non-personalized). The vehicle driver must be in the driver’s seat within 15 seconds of unlocking the vehicle to initiate the Driver Recognition function. Mazda Radar Cruise Control (MRCC) may reduce speed to match adjacent lane vehicle While driving on a curved road condition with the Mazda Radar Cruise Control (MRCC) activated, a vehicle in the right or left lane may be detected as a vehicle in front of the CX-90 and the MRCC will unexpectedly reduce vehicle speed to match the detected vehicle. The repair will be reprogramming the VCM with modified software via M-MDS, using MDARS. There are 28,404 vehicles in the campaign in the U.S. and U.S. Territories. |
| 15-001-24a | 2024-08-02. Service bulletin. Update software release for emergency lane keeping and/or smart brake support operation. This TSB has been superseded by SSPD6. |
| SSPD6 Warranty | 2024-06-05. Service campaign. SSPD6 - SPECIAL SERVICE PROGRAM - VEHICLE CONTROL MODULE (VCM) PROGRAMMING - 2024 CX-90 SSPD6 - 2024 CX-90 - Vehicle Control Module (VCM) Reprogramming: This campaign will resolve three different concerns. Unintentional warning or braking when backing up. When backing up the vehicle in a parking lot or similar area, the View Monitor Camera (VMC) may detect certain physical obstacles lower to the ground such as, the tires of an adjacent vehicle, parking lines, plants, etc. even though there are no obstacles behind the vehicle. Under this condition, the Smart Brake Support (SBS) system may determine that there is a possibility of a collision, notifying with a visual (screen display) and audible (warning sound), and the brakes possibly being applied in certain cases. Driver recognition result is not displayed (on equipped vehicles) The Driver Personalization system may not recognize the driver’s face to change the seat position settings that have been programmed. In this case the vehicle interprets the driver as a “guest” (non-personalized). The vehicle driver must be in the driver’s seat within 15 seconds of unlocking the vehicle to initiate the Driver Recognition function. Mazda Radar Cruise Control (MRCC) may reduce speed to match adjacent lane vehicle While driving on a curved road condition with the Mazda Radar Cruise Control (MRCC) activated, a vehicle in the right or left lane may be detected as a vehicle in front of the CX-90 and the MRCC will unexpectedly reduce vehicle speed to match the detected vehicle. The repair will be reprogramming the VCM with modified software via M-MDS, using MDARS. There are 28,404 vehicles in the campaign in the U.S. and U.S. Territories. |
| SSPD6 Repair | 2024-06-05. Service campaign. SSPD6 - SPECIAL SERVICE PROGRAM - VEHICLE CONTROL MODULE (VCM) PROGRAMMING - 2024 CX-90 SSPD6 - 2024 CX-90 - Vehicle Control Module (VCM) Reprogramming: This campaign will resolve three different concerns. Unintentional warning or braking when backing up. When backing up the vehicle in a parking lot or similar area, the View Monitor Camera (VMC) may detect certain physical obstacles lower to the ground such as, the tires of an adjacent vehicle, parking lines, plants, etc. even though there are no obstacles behind the vehicle. Under this condition, the Smart Brake Support (SBS) system may determine that there is a possibility of a collision, notifying with a visual (screen display) and audible (warning sound), and the brakes possibly being applied in certain cases. Driver recognition result is not displayed (on equipped vehicles) The Driver Personalization system may not recognize the driver’s face to change the seat position settings that have been programmed. In this case the vehicle interprets the driver as a “guest” (non-personalized). The vehicle driver must be in the driver’s seat within 15 seconds of unlocking the vehicle to initiate the Driver Recognition function. Mazda Radar Cruise Control (MRCC) may reduce speed to match adjacent lane vehicle While driving on a curved road condition with the Mazda Radar Cruise Control (MRCC) activated, a vehicle in the right or left lane may be detected as a vehicle in front of the CX-90 and the MRCC will unexpectedly reduce vehicle speed to match the detected vehicle. The repair will be reprogramming the VCM with modified software via M-MDS, using MDARS. There are 28,404 vehicles in the campaign in the U.S. and U.S. Territories. |
| SSPD6 Dlr Ltr | 2024-06-05. Service campaign. SSPD6 - SPECIAL SERVICE PROGRAM - VEHICLE CONTROL MODULE (VCM) PROGRAMMING - 2024 CX-90 SSPD6 - 2024 CX-90 - Vehicle Control Module (VCM) Reprogramming: This campaign will resolve three different concerns. Unintentional warning or braking when backing up. When backing up the vehicle in a parking lot or similar area, the View Monitor Camera (VMC) may detect certain physical obstacles lower to the ground such as, the tires of an adjacent vehicle, parking lines, plants, etc. even though there are no obstacles behind the vehicle. Under this condition, the Smart Brake Support (SBS) system may determine that there is a possibility of a collision, notifying with a visual (screen display) and audible (warning sound), and the brakes possibly being applied in certain cases. Driver recognition result is not displayed (on equipped vehicles) The Driver Personalization system may not recognize the driver’s face to change the seat position settings that have been programmed. In this case the vehicle interprets the driver as a “guest” (non-personalized). The vehicle driver must be in the driver’s seat within 15 seconds of unlocking the vehicle to initiate the Driver Recognition function. Mazda Radar Cruise Control (MRCC) may reduce speed to match adjacent lane vehicle While driving on a curved road condition with the Mazda Radar Cruise Control (MRCC) activated, a vehicle in the right or left lane may be detected as a vehicle in front of the CX-90 and the MRCC will unexpectedly reduce vehicle speed to match the detected vehicle. The repair will be reprogramming the VCM with modified software via M-MDS, using MDARS. There are 28,404 vehicles in the campaign in the U.S. and U.S. Territories. |
| SSPD6 Dlr Email | 2024-06-05. Service campaign. SSPD6 - SPECIAL SERVICE PROGRAM - VEHICLE CONTROL MODULE (VCM) PROGRAMMING - 2024 CX-90 SSPD6 - 2024 CX-90 - Vehicle Control Module (VCM) Reprogramming: This campaign will resolve three different concerns. Unintentional warning or braking when backing up. When backing up the vehicle in a parking lot or similar area, the View Monitor Camera (VMC) may detect certain physical obstacles lower to the ground such as, the tires of an adjacent vehicle, parking lines, plants, etc. even though there are no obstacles behind the vehicle. Under this condition, the Smart Brake Support (SBS) system may determine that there is a possibility of a collision, notifying with a visual (screen display) and audible (warning sound), and the brakes possibly being applied in certain cases. Driver recognition result is not displayed (on equipped vehicles) The Driver Personalization system may not recognize the driver’s face to change the seat position settings that have been programmed. In this case the vehicle interprets the driver as a “guest” (non-personalized). The vehicle driver must be in the driver’s seat within 15 seconds of unlocking the vehicle to initiate the Driver Recognition function. Mazda Radar Cruise Control (MRCC) may reduce speed to match adjacent lane vehicle While driving on a curved road condition with the Mazda Radar Cruise Control (MRCC) activated, a vehicle in the right or left lane may be detected as a vehicle in front of the CX-90 and the MRCC will unexpectedly reduce vehicle speed to match the detected vehicle. The repair will be reprogramming the VCM with modified software via M-MDS, using MDARS. There are 28,404 vehicles in the campaign in the U.S. and U.S. Territories. |
| SA-028-24 | 2024-06-03. Other. The CX-70 has new and revised features that are different from previous models and may be difficult to understand. This Service Alert provides valuable information to support potential dealer and customer concerns. Index: i-ACTIVSENSE Cruising and Traffic Support- Risk Mitigation Function (CTS-RMF) Private e-call (Canada Only) Trailer Hitch View MAZDA CONNECT Alexa Built-In Mazda Online Navigation In Vehicle Recall Notification Mazda Smart Cards Web-Based Training Courses |