Service bulletin 24-BE-003G
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10249710 |
| Published by NHTSA | 2024-02-05 |
| Manufacturer's number | 24-BE-003G |
| Manufacturer's date | 2024-01-26 |
| NHTSA component | EXTERIOR LIGHTING |
NHTSA's summary
This bulletin provides information on the Integrated LED Control Unit (ILCU) which is now available as a separate service part from the head lamp assembly for certain G70 (IK), GV70 (JK1), GV70 Electrified (JK1a EV), and GV80 (JX1) vehicles. For G70 (IK) vehicles, the ILCU is called LED Drive Module (LDM). In cases where the head lamp assembly needs replacement due to exterior damage such as a cracked lens, broken housing, etc., it is recommended to replace the head lamp sub-assembly only (not the entire head lamp assembly) and reuse the existing ILCU or LDM if no problem is found with it.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Lighting
| GENESIS G70 | 2022, 2023 |
|---|---|
| GENESIS GV70 | 2022, 2023, 2024 |
| GENESIS GV70 ELECTRIFIED | 2023, 2024 (the catalog's model; the bulletin names a series or trim of it) |
| GENESIS GV80 | 2021, 2022, 2023, 2024 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2025091 | 2025-02-19. Lights And Instruments |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 26-AD-001G | 2026-03-30. Service bulletin. Some 2020MY and newer vehicles equipped with a front view camera may illuminate certain warning lights and trigger DTC C272246 fault code for the front camera. In the following cases, the front camera auto-calibration range may be exceeded while driving: • If the front camera is not properly installed and is completely or partially detached. • In case of excessive changes affecting the vehicle's balance (e.g., loading excessively heavy cargo in a specific location of the vehicle, or significant under-inflation of the tires). • Specific road conditions affecting the vehicle's balance (e.g., excessive road crown) This TSB provides instructions on how to service the vehicle when the front camera related warning light(s) are triggered due to system out of calibration (DTC_C272246). |
|---|---|
| 25-BD-012H TSB | 2025-11-12. Service bulletin. This bulletin provides information regarding condensation related to the accumulated moisture in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. This TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes or during normal driving operation. |