Service bulletin 15-004-23
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10248346 |
| Published by NHTSA | 2024-01-05 |
| Manufacturer's number | 15-004-23 |
| Manufacturer's date | 2023-12-18 |
| NHTSA component | VISIBILITY |
NHTSA's summary
Some vehicles equipped with the Blind Spot Monitoring (BSM) may show the BSM indicator light is on in the outer door mirror, even if there are no vehicles in the alert area. This concern is caused by improper control logic of the side radar sensors. False detection may occur while driving. To eliminate this concern, the control software of the side radar sensors has been modified.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Glass, wipers and mirrors
| MAZDA MAZDA3 | 2024 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2023579 | 2023-10-26. Visual System |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| SA-043-26 | 2026-08-04. Service bulletin. This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-063/24 09/06/24 DESCRIPTION The Blind Spot Monitoring (BSM) system can malfunction with the following symptoms if the rear side radar sensors are installed facing the wrong direction. |
|---|---|
| SA-025-25 | 2025-06-05. Service bulletin. Some vehicles may exhibit wiper blade contact with the A-pillar trim, with or without a chattering noise. This condition may be caused by worn or contaminated wiper blades. It can also be caused by bent wiper arms, or loose wiper arm retaining nuts due to improper handling. Improper handling occurs when pulling on or forcing the wiper arms. Technicians should be aware that while replacement of the wiper blade may resolve some cases, correction of bent components or repositioning of the wiper arms, particularly when the retaining nut is loose, requires additional steps to ensure proper alignment and function. |
| SA-079-23 | 2024-01-05. Service bulletin. Some customers may complain about color discrepancies (brightness differences) of the image displayed on the screen when using the 360°view monitor. As this phenomenon is not a system failure, do not make any repairs or replace any parts. |
| SA-059-23 | 2023-11-01. Service bulletin. When the power windows are operated many times without being fully closed, small errors of the window position sensor may accumulate and cause improper operation of the jam-safe function. To reduce the risk of this occurrence, the AUTO function is disabled if the power window is operated 10 consecutive times without being fully closed (turning the ignition OFF and then ON does not reset the counting). If the power window is fully closed before the 10th time, the counting restarts and the AUTO function is not deactivated. |
| SA-039-23a | 2023-10-05. Service bulletin. Some vehicles may experience exterior trim heat damage when parked near a glass building or Low-E windows. This may be caused by the sun's reflection. |