WenmarOpen by Wenmar Pro

Service bulletin SSM 52050

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10245257
Published by NHTSA2023-11-15
Manufacturer's numberSSM 52050
Manufacturer's date2023-11-09
NHTSA componentENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE

NHTSA's summary

Some 2021-2023 F-150 hybrid vehicles equipped with a 3.5L PowerBoost engine built on or before 01-Mar-2023 may exhibit an illuminated malfunction indicator lamp (MIL) with DTCs P237C, P2C22 and/or P2C23 in the powertrain control module (PCM). This may be due to the exhaust heat exchanger bypass control valve. To correct this condition replace the muffler inlet pipe. Refer to Workshop Manual (WSM), Section 309-00D Exhaust System - 3.5L V6 PowerBoost (CN), Removal and Installation. For claiming, use causal part 5A212 and applicable labor times in Section 05 of the Service Labor Time Standards (SLTS) Manual.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Engine, Exhaust and emissions, Exhaust manifold, pipes and muffler

Trouble codes named

P237C, P2C22, P2C23

Vehicles listed
FORD F-1502021, 2022, 2023

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
TSB 23-23412023-11-21. Service bulletin. This article supercedes TSB 22-2388 to update the Service Procedure and vehicle model years affected. Some 2021-2023 F-150 Raptor vehicles may experience a rattle noise from the exhaust at the exhaust tailpipe actuators. This may be due to the exhaust tailpipe actuator valves rattling inside the muffler assembly. To correct the condition, follow the Service Procedure to reprogram the powertrain control module (PCM) and install new exhaust tailpipe actuator and/or valve springs on the exhaust tailpipe actuator valves.