Service bulletin WB08-X-001J
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10243651 |
| Published by NHTSA | 2023-10-06 |
| Manufacturer's number | WB08-X-001J |
| Manufacturer's date | 2023-09-27 |
| NHTSA component | UNKNOWN OR OTHER; EQUIPMENT |
NHTSA's summary
Policies and procedures update for all commercial vehicles. This bulletin provides instructions with regard to the Isuzu Commercial Vehicle (CV) Warranty Parts Center on the topics of parts retention, parts preparation for shipping, and administration.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Equipment and accessories
| ISUZU ASCENDER | 2009 |
|---|---|
| ISUZU F-SERIES | 2009 to 2010 |
| ISUZU FTR | 2009 |
| ISUZU FVR | 2009 |
| ISUZU FXR | 2009 |
| ISUZU HTR | 2009 |
| ISUZU HVR | 2009 |
| ISUZU HXR | 2009 |
| ISUZU I-290 | 2009 to 2010 |
| ISUZU N-SERIES | 2009 to 2010 |
| ISUZU NPR | 2009, 2010 |
| ISUZU NPR HD | 2009, 2010 (the catalog's model; the bulletin names a series or trim of it) |
| ISUZU NQR | 2009 to 2010 |
| ISUZU NRR | 2009 to 2010 |
| ISUZU W-SERIES | 2009 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| WB13-X-001B | 2022-08-30. Service bulletin. Isuzu Commercial Truck of America, Inc. (ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback. This bulletin was revised to add a Parts Warranty Form |
|---|---|
| WB13-X-001A | 2022-08-30. Service bulletin. Isuzu Commercial Truck of America, Inc. (ICTA) is providing the following procedural recommendations to improve dealer efficiency when submitting Parts Warranty claims. We strongly recommend dealers follow these procedures in order to avoid delays in Parts Warranty claim payments and/or claim chargeback. |
| IB09-X-004C | 2022-08-02. Service bulletin. The Isuzu Commercial Truck of America (ICTA) Service Technical Assistance Center (TAC) provides diagnostic support to Isuzu dealer technicians repairing Isuzu vehicles in and out of vehicle warranty. A TAC case number will be issued solely for information tracking purposes and future contact reference. |
| IB09-X-002B | 2022-08-02. Service bulletin. The following is a list of the Isuzu-recommended Threebond product part numbers identified in the various Isuzu Workshop Manuals and bulletins. If a Threebond product is unavailable, we recommend that you utilize the chart below to find equivalent of similar products (when available) from Loctite and Permatex. |
| IB17J001 | 2021-03-08. Service bulletin. Understanding drive belt noise. |
| IB08-X-002 | 2020-08-24. Service bulletin. ISUZU DIESEL ENGINES AVAILABLE IN THE ABOVE AFFECTED VEHICLES MEET THE CALIFORNIA AIR RESOURCE BOARD'S (CARB) OPTIONAL IDLING EMISSIONS STANDARD OF 30 GRAMS PER HOUR OF OXIDES OF NITROGEN (NOX) WITH NO INCREASE IN THE EMISSION OF OTHER REGULATED POLLUTANTS. AS A RESULT THESE VEHICLES HAVE BEEN APPROVED AS "CERTIFIED CLEAN IDLE" AND ARE "EXEMPT" FROM THE ENGINE SHUTDOWN SYSTEM (ESS) REQUIREMNET PURSUANT OT SECTION 1956.8 OF TITLE 13, CALIFORNIA CODE OF REGULATIONS. AS REQUIRED BY THE ESS REGULATION, FOR "CERTIFICED CLEAN IDLE" VEHICLES, ISUZU HAS INTRODUCED A TAMPER RESISTANCE "CERTIFIED CLEAN IDLE" LABEL LOCATED ON THE DRIVER'S SIDE DOOR PANEL. IT IS IMPORTANT THAT THIS LABEL REMAIN, PERMANENTLY, ON THE VEHICLE TO IDENTIFY IT AS "CERTIFIED CLEAN IDLE." CARB REQUIRES THIS LABEL AS EVIDENCE THAT, AT HTE TIME OF MANUFACTURE, THE ENGINE INSTALLED MET THE APPLICABLE EMISSION STANDARDS. SHOULD THE LABEL BE FOUND MISSING OR DAMGED DURING AN INSPECTION, A CITATION AND PENALTIES MAY BE ISSUED. IF THE VEHICLE IS OPERATED IN CALIFORNIA WITH A DAMAGED OR MISSING CLEAN IDLE LABEL, ISUZU RECOMMENDS VEHICLE OPERATORS FOLLOW THE 5 MINUTE ESS REQUIREMENT BY MANUALLY TURNING OFF THE ENGINE. FOLLOWING THIS ESS REQUIREMNET WILL KEEP THE VEHICLE OPERATION COMPLIANT UNTIL A REPLACEMENT LABEL CAN BE INSTALLED. "CLEAN AIR IDLE" LABELS ARE PRINTED WITH A SERIAL NUMBER AND REGISTERED TO AN INDIVIDUAL VIN. AS A RESULT, A REPLACEMNET LABEL WILL ALSO INCLUDE A NEW SERIAL NUMBER WHICH MUST BE REGISTERED TO THE VEHICLE'S VIN BY THE MANUFACTURER. THE BELOW INFORMATION IS PROVIDED TO ASSIT IN ACQUIRING, REPLACING AND REGISTERING A REPLACEMENT LABEL. |
| SB-12-K-002 | 2013-01-24. Service bulletin. ISUZU: DUE TO INSECT NESTING AND/OR DEBRIS LEFT BY FLOODING, FLUID IS LEAKING AT TOP OF AUTOMATIC TRANSMISSION DIPSTICK TUBE, AND A NEW BREATHER HOSE VENT WAS DESIGNED TO REDUCE THIS CONDITION. MODELS 2007-2012 N SERIES, 2007-2010 W SERIES. *PE |
| SB-09-J-006 | 2010-08-06. Service bulletin. ISUZU/GMC/CHEVROLET: OIL RELATED MISDIAGNOSIS-ENGINE OIL DIPSTICK CALIBRATION INCORRECT. MODELS EQUIPPED WITH DIESEL PARTICULATE FILLER (DPF) AND WHOLESALED BEFORE 12/03/09, WERE BUILT WITH AN INCORRECT ENGINE OIL DIPSTICK CALIBRATION. THE INCORRECT CALIBRATION CAUSES AN OVERFILLED CONDITION OF APPROXIMATELY 1.5QTS WHEN AT THE FULL MARK. *PE |
| CB-09-B-001 | 2009-06-01. Service bulletin. CHEVROLET GMC ISUZU SERVICE CAMPAIGN: SEE DOCUMENT SEARCH BUTTON FOR OWNER LETTER. VEHICLES MAY HAVE A LOOSE OR UNSECURED CAB STAY JOINT PIN. CSC LETTER WAS RECEIVED. *PE |