WenmarOpen by Wenmar Pro

Service bulletin 3628520

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10225947
Published by NHTSA2022-11-07
Manufacturer's number3628520
Manufacturer's date2022-09-12
NHTSA componentELECTRICAL SYSTEM

NHTSA's summary

Long range PHEV BECM DTC P065800 leads to BDU replacement.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Electrical system

Trouble codes named

P0658

Vehicles listed
VOLVO S602023
VOLVO S902023
VOLVO V602023
VOLVO V60CC2023
VOLVO V902023
VOLVO V90CC2023
VOLVO VOLVO
VOLVO XC402023
VOLVO XC602023
VOLVO XC902023

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
23V1880002023-03-22. ELECTRICAL SYSTEM

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
37373.8.02026-08-18. Service bulletin. This is a Technical Journal: DIM Message and DTC BECM P0C7800. If the DIM displays a message stating "Drive System Service Required" and the DTC listed below is set, follow the advice under "Service". •Do not replace any parts. This is not hardware-related. •A new BECM software is released in version 3.6.4. or later. Perform a total upgrade according to TJ 31543 and release the car back to customer.
37373.7.02026-06-08. Service bulletin. This is a Technical Journal: DIM Message and DTC BECM P0C7800.
 If the DIM displays a message stating "Drive System Service Required" and the DTC listed below is set, follow the advice under "Service".
 •Do not replace any parts. This is not hardware-related.
 •A new Battery Energy Control Module software is released in software version 5.1.9. Perform a Total Upgrade according to TJ 31543 and release the car back to the customer.
37376.3.02026-04-07. Service bulletin. This is a Technical Journal: Propulsion Message with DTC BECM P0A9500 and/or P0E2F00. Check the following parameters below. Utilize the High-voltage system overview to make sure that the contactors are closed while performing this check.
367572026-02-05. Service bulletin. This is a Technical Journal: Text plus TJI 528994 - Charge Lid Hard to open/close. begin with replacing the actuator in the lock mechanism
TJ37373.6.0-2025-11-052025-12-22. Service bulletin. This is a Technical Journal: DIM Message and DTC BECM P0C7800. Structure Week 2023w47 and newer: New BECM software is released in version 3.6.4. Perform a Total Upgrade according to TJ 31543. • If the DTC sets after SW version 3.6.4 or newer has been installed, please follow VIDA fault tracing and then create a TIE Support Needed Vehicle Report. *Structure Week 2023w46 and older: New BECM software is planned for 2026, Q1. • Please follow VIDA fault tracing and then create a TIE Support Needed Vehicle Report
373762025-11-17. Service bulletin. This is a Technical Journal: Propulsion Message with DTC BECM P0A9500 and/or P0E2F00. Perform a "High-voltage system overview" read out. If the BECM "voltage after fuse" values (front and rear) are greater than the high voltage battery, the BECM needs to be replaced.
373732025-08-18. Service bulletin. This is a Technical Journal: DIM Message and DTC BECM P0C7800.
 Structure Week 2023w47 and newer: New BECM software is released in version 3.6.4. Perform a Total Upgrade according to TJ 31543.
 •If the DTC sets after SW version 3.6.4 or newer has been installed, please follow VIDA fault tracing and then create a TIE Support Needed Vehicle Report.
 *Structure Week 2023w46 and older: New BECM software is planned for 2026, Q1.
 •Please follow VIDA fault tracing and then create a TIE Support Needed Vehicle Report
369162025-08-18. Service bulletin. This is a Technical Journal: VCM Backup Battery Replacement with VCM-U105000. Replace the VCM Backup Battery and download the relevant Software.
373732025-07-09. Service bulletin. This is a Technical Journal: DIM Message and DTC BECM P0C7800.
 Structure Week 2023w47 and newer: New BECM software is released in version 3.6.4. Perform a Total Upgrade according to TJ 31543.
 •If the DTC sets after SW version 3.6.4 or newer has been installed, please follow VIDA fault tracing and then create a TIE Support Needed Vehicle Report.
 *Structure Week 2023w46 and older: New BECM software is planned for 2026, Q1.
 •Please follow VIDA fault tracing and then create a TIE Support Needed Vehicle Report
373862025-07-09. Service bulletin. This is a Technical Journal: Ghost DTC CEM-B18711B.
 The DTC is set due to wrong resistance calculation with a low 12V battery SOC.