WenmarOpen by Wenmar Pro

Service bulletin SA-068-22

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10225767
Published by NHTSA2022-11-04
Manufacturer's numberSA-068-22
Manufacturer's date2022-10-17
NHTSA componentPOWER TRAIN

NHTSA's summary

The new SKYACTIV-DRIVE FW6A-EL AT uses "Automatic Transmission Fluid (ATF) Type: FZ". Only use "ATF-FZ" to fill or top off the fluid level. ATF-FZ is specially designed for use in the SKYACTIV-DRIVE series AT. It is a low viscosity formula with less friction for better fuel economy. NOTE: ATF-FZ is colored blue for easy identification.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Transmission and driveline

Vehicles listed
MAZDA CX-32016, 2017, 2018, 2019, 2020, 2021
MAZDA CX-302020, 2021, 2022, 2023
MAZDA CX-52013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
MAZDA CX-502023
MAZDA CX-92016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
MAZDA MAZDA22016, 2017, 2018, 2019, 2020, 2021
MAZDA MAZDA32012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
MAZDA MAZDA62014, 2015, 2016, 2017, 2018, 2019, 2020, 2021

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
19V4970002019-06-27. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ENGINE

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
SA-029-262026-05-05. Service bulletin. This Service Alert supersedes the previously issued SA listed below: The changes are noted in Red. SA-011/24 02/12/24, 06/06/24, 07/29/24 DESCRIPTION Mazda has developed factory recommended scheduled maintenance services that support all major vehicle systems. Mazda recommends dealers follow the scheduled maintenance tables as cited in the vehicle-specific workshop manual or owner's manual. Services performed outside of Mazda's factory scheduled maintenance are not recommended. These services are unnecessary and create unneeded expenses for your customers. SCHEDULED MAINTENANCE Refer to the applicable Workshop Manual or Owner's Manual for vehicle -specific manufacturer scheduled maintenance. Workshop Manual - Refer to section 00-00 SCHEDULED MAINTENANCE. Owner's Manual - Refer to section 8 Maintenance and Care. b. Note: Please refer to the information below outlining the services not included in Mazda's Factory Scheduled Maintenance: IMPORTANT: Recommending fluid flushes when not necessary can lead to customer confusion and dissatisfaction. Fluid flushing for preventive maintenance purposes is strongly discouraged, unless otherwise specified in a published procedure (Owner’s Manual, Workshop Manual, Technical Service Bulletin, etc.).
01-008-262026-05-03. Service bulletin. This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted in Red. 01-008/23 06/05/23 Some vehicles may exhibit rattling noises from the engine compartment and oil leakage from the drive belt auto tensioner. This may be caused by insufficient sealing at the drive belt auto tensioner damper when the auto tensioner fully operates under both high ambient temperature and high load conditions. To eliminate this concern, the shape of the drive belt auto tensioner damper has been changed. REPAIR PROCEDURE If the tensioner is found to be "No Good" after completing the Drive Belt Auto Tensioner Inspection, replace it with a modified part according to the instructions on MGSS online:
01-007-262026-05-03. Service bulletin. Some vehicles may exhibit the check engine light ON with DTC P2112 (Throttle valve actuator control motor current system: Characteristic malfunction). The DTC is stored when the engine is started at sub-zero ambient temperatures. To eliminate this concern, the PCM logic has been modified. REPAIR PROCEDURE Reprogram the PCM with the Mazda Modular Diagnostic System (M-MDS), using Mazda Diagnostic and Repair Software (MDARS). Refer to MDARS ECU Reprogramming Procedure.
01-003-26a2026-05-03. Service bulletin. This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted in Red text. 01-003/26 01/30/26 Some vehicles may exhibit a check engine light ON with DTC P20F8:00 stored. P20F8:00 - Swirl control circuit range/performance problem. In these cases, increasing temperature levels of the Swirl Control Valve (SCV) motor due to excessive actuation leads to duty limitation, causing poor opening􀀀angle response and resulting in a stuck judgment. To eliminate this concern, the PCM logic has been modified. REPAIR PROCEDURE Reprogram the PCM with the Mazda Modular Diagnostic System (M-MDS), using Mazda Diagnostic and Repair Software (MDARS). Refer to MDARS ECU Reprogramming Procedure.
SA-011-262026-03-05. Service bulletin. Some vehicles may display some (or all) of the following symptoms: • Check engine light on with DTC P061B • Light increase in engine rpms during acceleration • Transmission will not shift past 4th gear • Various U codes (U0401 ABS, U0401, U0415 FSC, U0301, U0316 SBS/MRCC, U0442 TCM) may be set
SA-056-252025-12-05. Service bulletin. When inspected, the differential or PTO oil is dark or black. This is considered normal and NO repair should be performed. During production, differential ring and pinion gears receive a manganese phosphate coating (commonly referred to as black oxide). This coating forms a porous, oil-retentive surface that improves boundary lubrication and reduces adhesive wear during initial contact cycles. Designed as a sacrificial layer, it is gradually removed under load throughout the break-in process. As a result, after the first few hundred miles, or at the initial gear oil service interval, the lubricant may appear darkened by the worn-off coating. It will contain trace ferrous particles from the normal run-in of the gear teeth and bearing surfaces. This condition is expected and does not, by itself, indicate an issue with the differential or PTO gears.
SA-052-252025-12-05. Service bulletin. Some customer's might state that they notice fluid or oil leaking/dripping on the ground when the vehicle is parked. For this concern, inspect the vehicle for any trace of a fluid or oil leak and use the following examples as a guide to determine if it is severe enough to require a repair, or just to clean the area and monitor it at the next service. Examples of residue or seepage that may not be considered a leak and that may not require repair based on splash shield inspection.
SA-051-252025-12-05. Service bulletin. Noise, Vibration, and Harshness (NVH) Diagnostic Guidelines Diagnostic Guidelines When diagnosing NVH concerns, it is essential to first classify the issue into one of three primary categories: Noise, Vibration, or Harshness. Many customer complaints may involve overlapping symptoms, such as both noise and vibration, so identifying the dominant characteristic is critical. Once the primary symptom is determined, follow the appropriate diagnostic path. For example, if a concern includes both noise and vibration but is related to vehicle speed, the vibration diagnostic path should be followed. When considering component replacement during the diagnostic process, it is best practice to start with the lowest cost or most accessible part unless diagnostic evidence clearly identifies a more expensive or complex component as the root cause. This approach helps minimize repair costs and avoids unnecessary part replacements. For example, a growling or bearing whine noise may be mistakenly attributed to internal components in the differential, transfer unit, or transmission, when the actual source is a wheel bearing. Misdiagnosis like this can lead to unnecessary repairs, added time and cost. To help prevent this, always follow the guidelines in the repair procedure.
SA-040-25a2025-12-05. Service bulletin. A New Automatic Transmission Fluid (ATF-A7) is being used for some 2023-2026 models. ATF-A7 is an extremely low viscosity formulation with low friction to achieve best-in-class fuel economy and driving performance. For easy identification, ATF-A7 is colored Red and ATF-FZ is colored Blue. ATF-A7 includes UV-reactive dye (see "Fluorescence Example" below). There is NO interchangeability between ATF-A7 and ATF-FZ. For CX-30, Mazda3, and CX-5, some 2.5L and all 2.5T engines still use ATF-FZ. Verify the type of ATF according to what is in MGSS (TRANSMISSION/TRANSAXLE TECHNICAL DATA) or what is marked on the dipstick (see "ATF-A7 Identification" below).
05-001-25a2025-12-04. Service bulletin. Some customers may see the A/T warning light on during (or immediately after) engine start-up with DTCs P073D:00-TCM / P1738:00-TCM stored. P073D:00-TCM: Turbine/input shaft speed sensor: Sensor output range malfunction P1738:00-TCM: Automatic transaxle internal malfunction This concern is caused by improper TCM logic. To eliminate this concern, the TCM control software has been modified to change the DTC detection logic, preventing DTC judgment during start-up.